Installing the Half Cylinder Diffuser with Prongs on your LED Sconce Wall Bracket involves a few key steps. Here's a general guide, referencing the LITHONIA LIGHTING U212198 installation instructions, to help you:
-
Safety First: Begin by turning off the power at your circuit breaker to eliminate any electrical risks.
-
Positioning: Depending on your specific diffuser model (such as DLSD3, DLSD4, DLSD1, or DLSD2), position the sconce housing so the LED lights are at the top and the driver is at the bottom.
-
Mounting Bracket Setup: Secure the mounting bracket to the housing by inserting screws through the bracket holes. For some models, like DLSD7, DLSD8, DLSD9, and DLSD17, align the holes in the Prong Assembly with the mounting brackets and use screws to fasten them.
-
Attaching the Diffuser: Align the holes in the diffuser with those in the mounting bracket or prong assembly. Use the provided screws to secure the diffuser. If you have models like DLSD13, DLSD14, or DLSD15, use thumb nuts for this step.
-
Final Review: Once everything is in place, double-check all connections. Make sure the diffuser is correctly aligned and securely attached.
Following these steps, as outlined in the LITHONIA LIGHTING manual, should allow you to successfully install the Half Cylinder Diffuser with Prongs on your LED Sconce Wall Bracket. If you require further assistance or encounter any problems, reach out to Technical Support at (800) 748-5070.
