
Installing the ELMEKO MSE 20 Dehumidifier in your control cabinet is straightforward. Here's a step-by-step guide: First, consider the mounting options. You can install it on a TS 35 × 15 mm mounting rail or use M4 screws through the provided holes. Make sure the unit is horizontally positioned with the hose connection facing downwards. Next, connect the condensate hose. Push the hose onto the connection on the underside and direct it to a container or through the enclosure wall. An OUT-FIT element is available as an accessory to aid in drainage. Ensure proper air circulation by maintaining at least an 80 mm clearance from the top and front of any adjacent devices. If using screws, use four M4 × 12 mm screws with washers and tighten them to a maximum torque of 2 Nm. For the electrical installation, always disconnect the control cabinet's power supply beforehand. Use either a 24 V DC power supply for part number 40 ME2 52L or a 12 V DC power supply for part number 40 ME2 82L. Connect the supply voltage using the enclosed plug-in terminal, paying close attention to the correct polarity. Refer to the wiring diagram specific to your device variant (24 V DC or 12 V DC) for accurate power supply connections. Once installed and connected, the dehumidifier operates automatically, responding to the humidity levels within the cabinet. It features humidity control, frost protection, and automatic defrosting. Following these instructions will help you successfully set up your ELMEKO MSE 20 Dehumidifier, safeguarding your control cabinet from moisture-related problems.


