Installing your Opticlimate REVOMAX II Classic PRO Series Style Housing correctly is crucial for optimal performance. Here's a step-by-step guide to help you: First, consider the installation spacing. Allow at least 15cm of space between the wall and the unit's backside for proper air suction, and maintain a 15cm gap between the unit's top and the ceiling. More space is always preferable to minimize noise. Next, choose your mounting method. You can hang the unit from the ceiling using M8 or M10 metal threaded rods, along with nuts, washers, and rubber dampers. Alternatively, mount it on a stand or frame using an M8 bolt and washer to secure the rubber or damper. When it comes to cables, begin by removing the panel near the manometer to access the electrical connections. Route the necessary cables for the magnetic valve, water leakage sensor, automatic moisture meter, remote control, and room temperature sensor through the designated openings. Now, connect the electrical components: the solenoid valve, water leakage sensor, automatic moisture meter, room temperature sensor, and remote control, making sure to follow the specific instructions provided. Pay close attention to the power supply. Adhere strictly to the power supply specifications to ensure a safe and correct connection. Use the recommended circuit breakers and cable thickness, and connect the power supply cables to the green terminal on the circuit board. Don't forget the temperature safeguards. Utilize the high-temperature safeguard to shut off heat sources if the room temperature gets too high, connecting it to a timer as instructed. For water connections, link the water inlet to a cold water supply and the outlet to a drain. Place a solenoid valve at the start of the piping and confirm the water connections are secure. Finally, address condensation water by using a P-trap on the condensation outlet. If the unit is positioned at the same level or lower than the drain, consider installing a drain pump. For the Smart Remote Controller, connect the power supply and USB connector from the remote cable. Follow the instructions for powering up the unit and initializing the Smart Remote controller. By carefully following these steps and the Opticlimate REVOMAX II Classic PRO Series Style Housing manual, you'll be well on your way to a successful installation.
