Installing LED fog lights on your 2020+ Ford F-250 using Factory Aftermarket LED Fog Light Kits involves several steps. First, ensure your vehicle is parked on a level surface, with the transmission in PARK, tires chocked, and the emergency brake engaged. Safety glasses are recommended throughout the process. Begin by removing the plastic trim covers around the front tow hooks to access the bumper bolts; these covers are typically held in place by three plastic clips. Next, identify and trim the metal tabs located on both the driver and passenger sides of the bumper, following the diagram provided with your kit. Then, remove the lower front bumper bolts using an 18mm socket. To align the lights correctly, use tape to mark the center lines of the bumper bolts vertically and horizontally. Reinstall the bumper valances and transfer these guidelines onto them. Drill pilot holes where the tape lines intersect, preparing for light bar installation. With assistance, carefully lift the light bar into position, aligning it with the outer/lower factory bumper bolt holes. Hand-thread the 18mm bumper bolts back into place. Before fully tightening the bolts, connect any plugs and wiring located behind the lights. Finally, tighten the bumper bolts completely. For added security, consider using locking hardware for both the off-road lights and the light bar itself. Following these steps, adapted from the Factory Aftermarket LED Fog Light Kits instructions, will help ensure a secure and correct installation.
