How do I install ARMORLITE Jeep Wrangler JK 4-Door Wheelhouse Covers?

[VanPaislee]

Installing ARMORLITE Jeep Wrangler JK 4-Door Wheelhouse Covers is straightforward. Here's a step-by-step guide to ensure a perfect fit:

1. Pre-Installation Preparation:

   • Make sure your Jeep is in "Park" and the emergency brake is engaged.
   • Wear gloves to protect your hands.
   • Remove any existing factory carpet wheelhouse covers.
   • Clean the sheet metal surfaces thoroughly using water and mild dish soap to remove any dirt or debris.

2. Installation Steps:

   • Start by installing the tail section, tucking the top edge under the sheet metal trim and the bottom edge under the plastic trim.
   • Position yourself in the rear cargo area to help with alignment.
   • Install the main section over the wheelhouse, ensuring the bottom section sits correctly under the seat.
   • Align the hole between the main and tail pieces and secure them using the provided snap-fit connector plug.
   • Tuck the top and bottom edges of the main section under the sheet metal and plastic trim.
   • Ensure the side of the ridge touches the plastic trim to prevent any popping. Push the cover firmly into place.
   • Repeat these steps on the opposite side to install the other wheelhouse cover.

3. Alignment Tips:

   • If you have an ARMORLITE cargo mat, make sure the wheelhouse covers tuck neatly underneath it for optimal water management.
   • If you don't have the cargo mat, ensure the finished edge of the wheelhouse covers follows the contour of your vehicle's wheelhouse and lies flat against the cargo floor.

For visual guidance, check out the detailed installation video on the Armorlite website at www.GoArmorlite.com/installation.