How do I install and configure the Z-Axis Extension Module for my Snapmaker Original 3D printer?

[AndresFitz]

Installing the Z-Axis Extension Module on your Snapmaker Original enhances its capabilities. Here's a step-by-step guide:

Installation Process:

1. Power off your Snapmaker Original and unplug all cables.
2. Allow the machine to cool down completely, especially if it was recently used.
3. Detach the Filament Holder, the X-Axis (with the 3D Printing Module attached), and the Controller.
4. Remove the existing Z-Axis. Then, attach the Z-Axis Extension Module.
5. Reattach the Filament Holder to the Z-Axis, followed by the X-Axis and Controller.
6. Reconnect all the cables that you unplugged in the first step.

Configuration in Snapmaker Luban:

1. Update your Snapmaker Original's firmware to version 2.11 and install Snapmaker Luban on your computer.
2. Connect your computer to your Snapmaker Original using the USB cable provided, and then power on the machine.
3. Open Snapmaker Luban. In the left sidebar, go to the 'Workspace' section.
4. Click on 'Connection', refresh the serial ports list, select the serial port corresponding to your Snapmaker Original, and then click 'Connect'.
5. Choose 'Custom' and select the connected toolhead when prompted.
6. Go to 'Machine Settings' under 'Settings'. Enter the following values under X, Y, and Z: 125, 125, and 221, respectively.
7. Under 'Z-axis Extension Module', select 'On' from the drop-down menu, and click 'Save Changes'.
8. Use the touchscreen controls on your Snapmaker Original to home the axes and level the Heated Bed. Refer to the Quick Start Guide for detailed instructions.

Important Note: If you're using the 3D Printing Module, confirm the configuration by checking 'Settings > About > Build Volume' on the touchscreen of your Snapmaker Original. For comprehensive instructions and safety guidelines, always consult the official Snapmaker Original Z-Axis Extension Module Installation Guide.