
Setting up your Aube TH146-P-2H1C Programmable Thermostat involves a few key steps to ensure optimal performance with your HVAC system. First, for installation, mount the control module (CT280-2H1C) near your heating or cooling system, keeping it away from heat sources. Position the user console (TH146-P) in a central, accessible location on an interior wall, approximately 1.5 meters (5 feet) from the floor. Connect the console to the control module using any two wires previously connected to your old thermostat. Refer to the specific wiring table in the Aube TH146-P-2H1C installation guide for your system type (HVAC or Heat Pump) to connect the plenum sensor, outdoor sensor, and humidifier, if applicable. Second, to configure the thermostat, access the configuration switches on the back of the console by loosening the captive screws. Set the Access Mode switch (SW1-1) to INST for Installer mode or USER for User mode. Use the Keypad Lock switch (SW1-2) to lock or unlock the keypad. Access the configuration menu by pressing the Mode button for 3 seconds, and then use the buttons to navigate and modify the parameters. Finally, understanding the operation modes is essential. The thermostat offers Automatic, Manual, and Auto modes for heating/cooling changeover. Balance Points can be set to control heat pump or auxiliary heating operation based on outdoor temperature. Additionally, adjust settings such as Interstage Delay, Low/High-Temperature Limits, and Fan for optimal performance. You can program the thermostat with a pre-set schedule or manually adjust temperature settings to suit your needs. If you encounter any issues, Aube Technologies offers support. The product includes a three-year warranty that covers defects in workmanship or materials. Consulting the detailed installation guide provided with your Aube TH146-P-2H1C thermostat will provide further specific guidance tailored to your system.


