How do I connect a new LiftMaster camera to my myQ account after a replacement?

[OQuinn]

If you've replaced the camera service kit on your LiftMaster garage door opener, you'll need to reconnect the new camera to your myQ account. Here’s how:

1. Safety First: Before you begin, always disconnect both the electrical and battery power to your garage door opener. This is crucial for your safety.
2. Remove the Old Camera: Use a Phillips screwdriver to remove the three screws securing the old camera to the opener housing. Carefully detach any wire harnesses connected to it.
3. Install the New Camera: Position the new camera in the opener, aligning it with the existing holes, and secure it with the three screws. Reattach the decorative badge.
4. Restore Power: Once the new camera is installed, restore power to the garage door opener, including the battery if it's used.
5. Connect to myQ: Find the notch on the camera’s opener and pull it down. Now, follow the instructions provided within the myQ app to add the new camera to your account. Remember to delete the garage door opener from your myQ account before adding it again, this time including the new camera. Following these steps ensures your LiftMaster camera is correctly connected to your myQ account, allowing you to monitor and control your garage door remotely.