How do I configure the baud rate and address for a Simplex 4100U Flex Amplifier?

[LeMaggie]

Configuring the baud rate and address for your Simplex 4100U Flex Amplifier involves using DIP switch SW1 on the amplifier. Here's a straightforward guide:

Setting the Baud Rate: To set the baud rate, use switch SW1-1. Set this switch to the ON position to configure the baud rate for internal communications.

Setting the Address: The card's address within the Fire Alarm Control Panel (FACP) is set using switches SW1-2 through SW1-8. It's crucial to consult Table 1 in the Simplex 4100U Flex Amplifier manual to determine the correct switch settings for your desired card address. Make sure these switches are set according to the value assigned to the card by the programmer. Remember, the SW1 settings are applicable to audio controller slaves, including audio input cards.

Using Table 1: Card Addresses: Table 1 in the manual is your key resource. It details the precise switch settings required for each possible card address. Review the table carefully to ensure accurate configuration. By following these steps and referencing Table 1, you'll be able to successfully set the baud rate and address for your Simplex 4100U Flex Amplifiers.