Calibrating the frequency of your Uniden 8010 Remote VFO with the Uniden 2020 transceiver is essential for accurate operation. Here's a step-by-step guide:
- Connectivity: First, ensure the Uniden 8010 VFO and Uniden 2020 transceiver are correctly connected using the supplied cable.
- Band Selection: Set the desired operating band on your Uniden 2020 transceiver.
- Segment Selection: On the Uniden 8010 VFO, select the appropriate segment using the segment switch.
- Mode Selection: Choose either VFO mode or SPOT (crystal control) mode, depending on your preference.
- Fine Tuning: Utilize the R.I.T. (Receiver Incremental Tuning) control if you need to fine-tune your frequency.
- Dial Calibration: Follow the dial calibration procedure detailed in section 4-3-1 of the Uniden 2020 transceiver manual to ensure the frequency display is accurate.
- EXT. Function: When the function switch on the Uniden 2020 is set to the EXT. position, select the 100 kHz order on the Uniden 8010 using the segment switch. Then, use the VFO dial to tune below 100 kHz.
- Frequency Display: The operating frequency will be displayed as a combination of readings. For example, if the transceiver displays 14 MHz and the VFO displays 230 kHz, the actual frequency is 14.230 MHz.
- Crystal Control: For crystal-controlled operation, insert the appropriate crystals into the Uniden 8010 VFO to match the desired frequencies within the 100 kHz coverage range. Consult the manuals for both the Uniden 8010 Remote VFO and the Uniden 2020 transceiver for detailed instructions and diagrams. By following these steps, you'll ensure seamless and accurate operation with your Uniden equipment.