Assembling the wheels on your Topmaq CT-B0136 36V Cordless Tiller is straightforward. Here's a step-by-step guide based on the manufacturer's instructions: Step 1: Wheel Assembly 1. Begin by placing a wheel (F) onto the axle (H). 2. Next, position a washer (O) over the axle, on top of the wheel. 3. Insert a split pin (J) through the hole in the axle and spread the ends to secure the wheel. 4. Attach a wheel cover (G) to the wheel (F), ensuring the tabs on the cover align with the slots on the wheel, and clip it into place. 5. Repeat these steps for the second wheel. Step 2: Wheel Attachment 1. Place a spacer (P) onto the bolt (O). Insert this bolt through the hole on the wheel axle bracket (H1), making sure the washer fits inside the hole. 2. On the right-hand side (opposite the wheel height adjuster pin), put a washer (S) onto the bolt (O) before inserting the bolt through the hole on the lower handlebar. 3. On the left-hand side (next to the wheel height adjuster pin), insert the bolt directly through the hole on the lower handlebar, without a washer. Step 3: Middle Bar Attachment Connect the middle bar (D) to the lower bars (B) using the wing nut (I) and bolt (M). Step 4: Upper Bar Attachment Connect the upper bar (N) to the middle bar (D) using the wing nut (I) and bolt (M). Step 5: Cable Clip Attachment Secure the cable to the right-hand handlebar (D) using the provided cable clips (L). This keeps the cable neat and secure. Step 6: Cable Holder Ensure the machine is disconnected from power. Create a small loop in the power cable (Y). Thread this loop through the hole in the handle and then onto the hook (U). Gently pull the loop to remove any slack. By following these instructions, you should successfully assemble the wheels on your Topmaq CT-B0136 36V Cordless Tiller.
