
Adjusting the hanging length of your Progress Lighting P500417 Lattimore Aged Brass Coastal Cylinder fixture involves several steps. First, attach the chain holder (EE) to the [specific component, identified as xxxx in original instructions] (FF) and loosely thread the hex nuts (AA). Next, thread this assembly onto the mounting plate (CC) and secure it to the outlet box with the provided mounting screws. Now, slide the canopy (KK) over the chain holder (EE) and adjust the chain holder's depth so at least 1/4 of the threaded portion is visible through the canopy hole. You can adjust this by altering the depth of the [specific component, identified as xxxx in original instructions] (FF) on the mounting plate (CC). Once correctly adjusted, remove the canopy (KK) and tighten the top hex nut (AA) against the mounting plate (CC) and the bottom hex nut (AA) against the chain holder (EE). Determine your desired hanging length by removing chain links (GG) and, if needed, trimming the electrical and ground wires to length. It's crucial to wait until you've finalized the overall length before cutting. Ensure you leave at least 6 inches of wire extending past the chain holder (EE) for easy connections. Open a chain link (GG) at one end, attach it to the loop (JJ), and close the link with pliers. Secure the other chain end to the chain holder (EE) using the quick link (HH), threading the wires through the chain loop (JJ). Then, weave the wires through every third chain link (GG), passing them through the [specific component, identified as xxxx in original instructions] collar (DD) and the canopy (KK). Strip 3/8 inch of insulation from the wire ends and connect the fixture wires to the supply wires using wire nuts (BB). Finally, tuck the wires into the junction box, place the canopy (KK) over the chain holder, and tighten it to the ceiling by threading the [specific component, identified as xxxx in original instructions] collar (DD) onto the chain holder. Complete the installation by screwing the appropriate wattage bulbs (not included) into the fixture sockets.


