Adding your Tyco PG4914 DSC PowerG Wireless Digital Pet-Immune PIR Motion Detector to your DSC alarm system involves a few key steps. First, consult the Installation Manual specific to your DSC alarm panel model to understand the device enrollment process unique to your system. Next, enter the device enrollment mode on your DSC alarm system, usually through the system's keypad or programming interface, and choose the option to add a new device. You can then enroll the PG4914 detector by either pressing and holding the enrollment button on the detector itself until the alarm system recognizes it, or by manually entering the device ID into the system. After enrollment, you'll need to assign the detector to a specific zone number within your alarm system's configuration. Configure any device-specific parameters that are necessary for the PG4914 detector's proper function, such as pet immunity settings if available. Once configured, physically install the detector according to the installation instructions, and then test its functionality. The Installation Manual will provide detailed testing procedures. Finally, conduct any additional tests outlined in the alarm system's manual to confirm the detector is working correctly. If the detector is already enrolled, you can configure its settings by programming the system according to the alarm system's manual instructions. Should you face any difficulties during the enrollment, review the troubleshooting section in your alarm system's manual for potential solutions.
