To verify your Mircom MIX-2351AP smoke sensor is working correctly, you can perform a few straightforward tests. These tests ensure the sensor accurately detects smoke and communicates with your fire alarm system.
-
Functional Magnet Test: This test uses a special test magnet (like Mircom's P/N M02-04-01 or M02-09-00) to simulate a smoke condition. Simply hold the magnet near the designated test area on the sensor. The sensor should trigger an alarm signal that your fire alarm control panel will recognize, and the sensor's LEDs will reflect its status as communicated by the panel.
-
Smoke Entry Test: This test uses approved canned aerosol smoke to simulate an actual fire. You can access sensitivity readings through your Fire Alarm Control Panel (FACP). Always follow the manufacturer's instructions when using canned smoke products. Popular and reliable choices for simulated smoke include products from HSI Fire and Safety, SDi, and No Climb. Expose the sensor to the simulated smoke according to the product's instructions. The smoke detector should immediately trigger an alarm.
-
Post-Test Actions: After either test, always return your fire alarm system to its normal operating state. If the sensor fails either test, consult the Mircom MIX-2351AP's manual for guidance, which may involve cleaning or further troubleshooting. Importantly, if you've notified authorities about the system, inform them when it is back in service. Following these steps helps ensure your Mircom MIX-2351AP continues to provide reliable fire detection.
