Installing ProBEAM Dynamic Strips LED Turn Signals can enhance your motorcycle's visibility. Here's how to install them, based on the manual: First, remove your current turn signal assembly by unscrewing the securing nuts. Then, unplug the wiring connector from the turn signal assembly. Next, remove the mounting studs using a wrench or socket. Repeat these steps for the other side. Now, remove the top T27 Torx bolts from the outer fairing and take off the windshield. Reinstall the center T27 Torx bolt to keep the fairing secure while removing the inner fairing bolts. Then, remove the T27 Torx bolts from the inner fairing's left and right sides. Disconnect the connector from the headlamp and place the fairing on a flat surface. After that, plug the male connector of the AW Converter harness into the female connector on the turn signal factory wiring. Plug the male plug on the ProBEAM Dynamic Strips harness into the hole in the fork frame and connect it to the AW Converter's female connector. Install the ProBEAM Dynamic Strips onto the fork frame with the provided bolts and washers. Use wire ties to secure the wiring harnesses and converters to avoid damage. Reinstall the fairing and windshield, ensuring all bolts are correctly placed. Finally, with the ignition off, run the hazard flashers for 3 minutes to sync the BCM with the ProBEAM Dynamic Strips, then verify all lighting modes function correctly. For any installation issues, contact Custom Dynamics at 1 (800) 382-1388 for support.
