Why Can't I Align Properly in Subject Two?
3 Answers
Align the rivet position of the left wiper with the right edge line on the ground. At this point, the right side of the car should be about 30 centimeters away from the road edge line. Alternatively, align the right 1/3 of the car hood with the road edge line. The car body should also be approximately 30 centimeters away from the edge line. As you approach the stop line, observe when the lower edge of the left rearview mirror aligns with the second thick yellow solid line. Simultaneously press the clutch and brake to bring the vehicle to a stop.
I also struggled with aligning the lines during my Subject 2 practice, it was such a headache. The key is to remember adjusting the seat to your most comfortable position first after getting in the car, and fixing the backrest angle - this directly affects your viewing angle for reference points. Don't skip adjusting mirrors either, always set them to clearly see the rear wheels. Keep the speed slow and clutch control steady, so you can clearly observe the corner of the garage and boundary lines. Be decisive with steering wheel movements - act immediately when you see the reference point, hesitation for even one second is too late. Through practice I found that even slightly leaning forward causes angle deviations, so maintaining a fixed sitting posture is crucial. And most importantly, don't get nervous on exam day, or your stiff hands and feet will make alignment even harder.
When teaching driving, I found that students often misalign due to three main reasons: seats and rearview mirrors are not adjusted properly. Different heights require different adjustments; if not done correctly, it's like wearing glasses with the wrong prescription. Incorrect reference point selection. Some focus on the wrong corner of the garage, while others misjudge the tire position. Poor coordination between hands and feet. The clutch isn't pressed steadily, causing the speed to fluctuate, and the steering wheel isn't turned in time. Here's a tip—first, adjust to a standard sitting position while parked, and memorize key reference points like the hood and wipers. When practicing garage reversing, break the movement into three steps: first turn the wheel to enter the garage, then straighten it, and finally fine-tune the car's position. Recording a short video after each practice session for review is very helpful.