Which turn signal to use for parallel parking?

1 Answers
Lopez
07/29/25 2:20pm
When performing parallel parking, you should use the right turn signal. Below are detailed instructions on turn signal usage: 1. Left turn signal: You should activate the left turn signal in advance when making a left turn, changing lanes to the left, preparing to overtake, leaving a parking spot, or making a U-turn. 2. Right turn signal: You should activate the right turn signal in advance when making a right turn, changing lanes to the right, returning to the original lane after overtaking, or parking by the roadside. 3. Accident liability: If an accident occurs due to the driver's failure to use turn signals, there is a high probability that the driver will bear primary or full responsibility for the accident.
Was this review help?
14
0
Share
More Forum Discussions

Can Hebei Still License China V Vehicles?

Hebei cannot license China V vehicles. Below is relevant information about China V: 1. Definition: China's Fifth Stage Motor Vehicle Pollutant Emission Standard, abbreviated as "China V Standard," has an emission control level equivalent to Europe's currently implemented Euro 5 emission standard. 2. Differences from China IV: Compared to the China IV standard, the new standard reduces nitrogen oxide emissions by 25% for light-duty vehicles and 43% for heavy-duty vehicles. Based on Shanghai's annual vehicle registration volume of approximately 350,000 units, it is estimated that annual new vehicles could reduce nitrogen oxide emissions by about 1,000 tons. Additionally, the domestic China V standard's emission control level is equivalent to Europe's currently implemented Euro 5 emission standard.
1
0
Share

Can You Shift to P Gear at a Red Light?

It is possible to shift to P gear at a red light, but it is not recommended for drivers to do so. If the car is shifted into P gear and is rear-ended by another vehicle, the transmission of the driver's car may be damaged. Therefore, it is advisable to stay in D gear with the handbrake engaged or shift directly into N gear when waiting at a red light. Automatic transmissions have both N gear and P gear, both of which can be used when parking. When shifted into N gear, there is no locking mechanism to secure the transmission gears, so the car can still move if the handbrake is not engaged. However, P gear is different—it has an internal locking mechanism that secures the transmission gears once engaged. In this case, the car cannot move even without the handbrake being applied.
13
0
Share

Do I Need to Drive to Handle Traffic Violations?

Handling traffic violations does not require driving. Methods for handling traffic violations: Traffic violations can be handled by the vehicle owner in person, delegated to someone else to process at the traffic police station, or resolved independently online by checking the points and accepting the penalty. Precautions for handling violations: Violations can be processed either all at once or selectively, and you may raise objections to the violations and apply for administrative reconsideration. If there are no objections to the violations, after completing the deduction of driver's license points, you will receive a violation processing notice and a fine ticket. You can then take the violation ticket to the designated payment bank to pay the fine.
16
3
Share

What is the minimum turning radius of a car?

The minimum turning radius of a car is 6 meters. Pre-departure vehicle inspection: Before setting off each day, conduct a comprehensive check of the vehicle, including checking for oil or water leaks, measuring tire pressure to ensure it's appropriate, inspecting the engine oil condition to verify its color is normal and the oil level is correct. Safe driving: Use seat belts properly. In the event of a severe collision, seat belts provide protection no less effective than airbags. Avoid fatigued driving and take breaks every 2 hours. Obey traffic rules: Especially on highways, do not speed. Speeding may not only result in penalties from traffic police but, more importantly, is unsafe.
18
5
Share

Where is the date on Varta batteries?

Varta battery dates are located on the stamped code between the positive and negative terminals of the battery. The code indicates the production date. The first digit represents the year in Arabic numerals; the second digit represents the month using English letters, with 'A' standing for January, 'B' for February, and so on; the third digit indicates the place of production, with 'C' representing Chongqing and 'Z' representing Zhejiang; the fourth and fifth digits indicate the specific production date; the sixth and seventh digits represent the production team. Car batteries are an essential part of automobiles and can be divided into traditional lead-acid batteries and maintenance-free batteries. The structure of lead-acid batteries mainly consists of positive (negative) plates, separators, electrolyte, case, connecting straps, and terminal posts.
2
4
Share

What is the normal tire pressure for the Nissan X-Trail while driving?

The normal tire pressure for the Nissan X-Trail while driving is between 2.3 and 2.5. Tire pressure refers to the air pressure inside the tire. The hazards of excessive tire pressure are: 1. Reduced tire friction and adhesion, affecting braking performance; 2. Accelerated wear on the central tread pattern, shortening the tire's lifespan. The hazards of insufficient tire pressure are: 1. Heavy steering wheel and tendency to drift; 2. Increased friction coefficient with the road surface, leading to higher fuel consumption. The Nissan X-Trail measures 4675mm in length, 1820mm in width, 1722mm in height, with a wheelbase of 2706mm, and is equipped with a CVT transmission.
16
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.