Where is the tire pressure monitoring located?

1 Answers
DelZane
07/29/25 10:18am
The tire pressure monitoring is located on the left side of the center console. The functions of the tire pressure monitoring are: 1. It will promptly alert when there is rapid or slow air leakage due to tire puncture; 2. It will issue an alarm when tire loosening causes unbalanced friction, leading to tire temperature reaching 70 degrees Celsius to prevent blowouts; 3. It will alert when the tire pressure is below the vehicle's set limit due to prolonged lack of inflation, preventing low pressure from causing tire temperature rise and blowouts. The method to reset the tire pressure monitoring is: 1. Ensure the vehicle's tire pressure is within the normal range; 2. Park the vehicle on a flat surface and turn off the engine; 3. Power on the vehicle and hold down the tire pressure monitoring button; 4. After 5 seconds, upon hearing an alarm sound, release the button to successfully reset.
Was this review help?
5
2
Share
More Forum Discussions

How to Maintain a Motorcycle at 10,000 Kilometers?

Body bolts, including the front and rear axle nuts, must be tightened in a timely manner. Tire pressure should be checked every three months. The rear brake of the new Neptune still uses a relatively conventional drum brake. As the mileage increases, the brake clearance should be adjusted appropriately.
3
2
Share

How to Remove a Motorcycle Lock?

The protective cover of the ignition lock core is magnetic, and you need to use the hexagonal magnetic protrusion on the other end of the special key to unlock it. Lift the main stand and sit on the seat. If the handlebar is locked to the left, gently pull the right handle with your right hand and kick the left handle hard with your left foot.
15
1
Share

How to Ship a Motorcycle via Logistics?

Safety is guaranteed, and the railway does not require dismantling the motorcycle; the whole vehicle can be delivered to your home, with relatively low logistics costs. Empty the gasoline and load it directly onto the bus, then hand it over to the driver. You can do the packaging yourself, which is labor-intensive but saves money, or you can have the logistics company handle the packaging, which offers better results but costs more. Having the original factory packaging makes it even more convenient.
17
4
Share

How to Do a Wheelie for Beginners on a Motorcycle?

First, place both feet on the ground, shift into first gear, and while using your right hand to throttle up and your left hand to pop the clutch, pull the handlebars upward with both hands. This will make the front wheel easily lift off the ground. While moving slowly, hold the clutch, increase the throttle, and quickly release it to utilize the strong torque of first or second gear to lift the front wheel.
20
1
Share

How to Replace a Lost Motorcycle Driver's License?

Apply for a replacement driver's license at the local vehicle management office where the original motorcycle driver's license was issued. Submit the identity proof of the motor vehicle driver, which includes the front and back copies of the ID card and a written statement declaring the loss of the motor vehicle driver's license.
16
4
Share

How to Install Motorcycle Spotlights?

Spotlight negative connects to ground, spotlight positive connects to terminal 87 of the relay, relay terminal 30 connects to the positive terminal of the battery, and the other end of the switch connects to the positive terminal of the battery. If the spotlight power is not high, it is recommended to remove the relay. Spotlight negative connects to ground, spotlight positive connects to one end of the switch, and the other end of the switch connects to the positive terminal of the battery or the output wire of the ignition switch.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.