Where is the location to add windshield washer fluid for the Magotan?

3 Answers
LeEmilia
07/24/25 5:30am
The windshield washer fluid for the Volkswagen Magotan is added into the reservoir located in the engine compartment. To add windshield washer fluid, follow these steps: 1. Turn on the windshield wiper switch, and the washer fluid will spray out from below the front windshield. 2. After completely draining the old washer fluid, add a small amount of new washer fluid into the washer fluid filler port. 3. Turn on the windshield washer switch again to clean out any remaining old washer fluid. 4. When no more washer fluid sprays out during the second activation, pour in 4 liters of washer fluid. The filling process is now complete. Finally, securely close the washer fluid cap.
Was this review help?
9
5
Share
MicahLee
08/10/25 11:31pm
As a veteran Passat driver with over a decade of experience, let me tell you the windshield washer fluid reservoir is located on the left side of the engine compartment. To be specific, after opening the hood and standing at the front of the car, look towards your right hand side - you'll see a distinctive blue plastic cap with a windshield washer icon. This semi-transparent blue cap is deliberately designed by manufacturers for easy identification. Personally, I always switch to antifreeze washer fluid before temperature drops. Be extra careful not to mistake it for the red coolant cap nearby - they're quite close to each other. The reservoir can hold 2-3 liters, so I always keep two bottles of concentrate in the trunk for top-ups. Pro tip: It's safer to refill when the engine is cool to avoid steam burns.
Was this review help?
4
2
Share
Expand All
Tyra
09/24/25 6:46am
When I first bought my Magotan, I couldn't figure out where the windshield washer fluid was either, but now I'm quite familiar with it. Pop open the hood and look to the right side, near the headlight on the passenger side - the blue cap with the windshield washer symbol is what you're looking for. If you can't find it, you can check page 63 of the user manual; there's a diagram there. Now that it's winter, I always switch to -25°C washer fluid in advance, otherwise freezing could crack the pipes. It's best to use a funnel when filling up the washer fluid - last time I didn't and spilled some on the battery, which was scary even though nothing bad happened. Remember not to overfill it; the ideal level is about two fingers' width below the filler neck, otherwise it might spill when driving over bumps.
Was this review help?
10
1
Share
Expand All
More Forum Discussions

How to Apply Gold Plating to a Car?

It can form a sturdy protective layer on the car paint, making it less prone to scratches. It easily integrates with the car paint, allowing for effortless cleaning of all hard-to-clean areas on the paint, leaving the car paint glossy and looking like new. Its coating layer is extremely durable and difficult to wash off, thus providing long-lasting protection for the car paint.
11
3
Share

Is it possible to reverse in a waterlogged section?

Yes, and the possibility of stalling while reversing through water is significantly reduced. Here are the relevant details: 1. Principle: Due to the presence of gas in the exhaust pipe, under normal pressure (water depth of about half a meter), water will not flow backward. Therefore, the key to deep water fording is controlling the speed to avoid splashing water waves from entering the engine compartment. Additionally, the radiator fan should be temporarily turned off before fording to prevent splashed dirty water from damaging the electrical system. 2. Specific situation: After exiting the waterlogged area, the brake pedal should be lightly pressed continuously to remove residual water from the brake system and restore braking performance. If you are really unsure, you can engage the R gear to reverse through the water, which is highly unlikely to cause the engine to stall. Even if you rev the engine hard and then release the throttle, the engine remains stable with no signs of water flowing backward.
3
1
Share

How to turn off the hazard lights flashing on both sides?

When turning the steering wheel back to center during driving, the turn signal will automatically turn off. However, with the development of automotive technology, many modern cars now feature a 'one-touch three-flash' quick turn signal function on the hazard light switch. By lightly 'tapping' the turn signal lever, the turn signal will flash three times and then automatically turn off.
8
0
Share

What is the method for resetting the tire pressure on the Baojun e200?

Before resetting the tire pressure, first check the tire pressure condition of the car to determine whether the tire pressure is normal. The automatic tire pressure adjustment function can automatically correct and reset the tire pressure. After confirming the car's tire pressure condition, you can go to a car service shop to check the tire pressure sensors and clear the corresponding fault codes.
11
5
Share

How many one-inch photos are required for a driver's license renewal?

Renewing a C1 driver's license requires eight 1-inch photos. According to the "Road Traffic Safety Law of the People's Republic of China," the photo size requirement for applying for a motor vehicle driver's license is a 1-inch bareheaded photo of the applicant. In addition to the photos, the following materials are also required for the driver's license application: 1. "Motor Vehicle Driver's License Application Form." 2. "Motor Vehicle Driver's Physical Condition Certificate" issued by a medical institution at or above the county level or the regimental level of the military. 3. The original and a copy of the applicant's valid identity document. Additional information: Below are the photo requirements for applying for a driver's license: 1. Time: The photo must be taken within six months before the applicant applies for the driver's license. 2. Attire: The photo must be a straight-edged, front-facing, bareheaded, color, single-person half-length ID photo without a hat, scarf, uniform, or colored glasses; long-haired individuals should expose both ears, and the head and face should not have any tilting, turning, heavy makeup, or accessories that affect facial feature recognition. 3. Background: The background color should be white, with a clear, well-defined, and natural-looking portrait without obvious distortion. 4. Size: The photo size should be 32mm × 22mm, with a head width of 14mm to 16mm and a head length of 19mm to 22mm.
4
3
Share

How to Use the Blue Bike?

Software to find a bike, book a nearby e-bike in advance. Navigation guides you to the bike, and the bike rings to help locate it when you are close. Scan the QR code on the bike to unlock and start using it. Check your current location, usage duration, and cost. Park the bike in the designated public e-bike area, and it will be automatically returned when locked.
15
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.