Where is the headlight switch located on the Audi Q3?

How to Determine the Distance to the Following Vehicle

To determine the distance to the following vehicle, you can use the rearview mirror or the in-car reversing camera. If the image of the following vehicle occupies the entire area of the rearview mirror, the distance is approximately three meters. When the image occupies two-thirds of the mirror, the distance is about five meters. If it covers half of the mirror, the distance is roughly nine meters. And when the image takes up one-third of the mirror, the distance is around twelve meters. The rearview mirror is a tool that allows the driver, seated in the driver's seat, to directly obtain external information about the rear, sides, and lower parts of the car. For the convenience of the driver, to prevent traffic safety accidents, and to ensure personal safety, all countries mandate that vehicles must be equipped with rearview mirrors, and all mirrors must be adjustable in direction.

16

4

Share

Is the Hongqi H5 front-engine?

The Hongqi H5 is a front-engine vehicle. This is a mid-size sedan with dimensions of 4945mm in length, 1845mm in width, and 1470mm in height, and a wheelbase of 2875mm. The body style is a 4-door, 5-seater sedan. It features a 7-speed dual-clutch transmission and is powered by a 1.5T L4 turbocharged engine, delivering a maximum horsepower of 169ps and a peak torque of 258Nm. The front suspension is a MacPherson strut independent suspension, while the rear suspension is a multi-link independent suspension. It comes with electric power steering, a unibody structure, and an electronic parking brake.

17

0

Share

What does it mean when the SVS warning light is on in the JMC Transit?

JMC Transit SVS warning light is the engine fault light. When the SVS indicator is illuminated, it indicates that the engine control unit has detected an erroneous signal from a sensor or that the sensor has exceeded its usage standard. When the driver turns on the ignition, the SVS warning light will illuminate for an automatic check and then turn off after a few seconds. The dimensions of the JMC Transit are 5696mm in length, 1972mm in width, and 2240mm in height, with a wheelbase of 3570mm. The body type is a 5-door, 9-seat passenger van, equipped with a 5-speed manual transmission. The front suspension is MacPherson strut independent suspension, and the rear suspension is leaf spring non-independent suspension.

20

0

Share

Can a car be started while charging?

Starting a car while charging is not recommended as it may damage the battery. A car battery, also known as a storage battery, works by converting chemical energy into electrical energy. Typically, the term 'battery' refers to lead-acid batteries, which mainly use lead and its oxides as electrodes and sulfuric acid solution as the electrolyte. The plates of ordinary batteries are made of lead and lead oxides, with the electrolyte being an aqueous solution of sulfuric acid. Dry-charged batteries, fully named dry-charged lead-acid batteries, are characterized by their negative plates having a high capacity for storing electricity, allowing them to retain their charge for up to two years in a completely dry state. Maintenance-free batteries, due to their structural advantages, consume very little electrolyte and generally do not require the addition of distilled water during their service life.

6

1

Share

What are the scoring rules for the reverse parking in Subject 2?

Additional information: Candidates should note that each test begins when the vehicle passes the starting dotted line and the computer announces the start of the test; it ends when the vehicle passes the ending dotted line and the test results are announced (any disqualifying mistakes during the test will immediately end it). Mistakes such as stopping midway or crossing the line on the section between the ending dotted line of the previous test and the starting dotted line of the next test will not be counted in the score.

6

1

Share

How to Adjust the Time on the Dashboard?

There is a button on the lower left and lower right corners of the dashboard. You only need to use these two buttons to quickly adjust the time. Here are the steps to adjust the time on the dashboard: 1. First, familiarize yourself with the two buttons for adjusting the time. Press the left button once. The left button is the selection button, and pressing it once adjusts the hour. Then press the right button once. The right button is the adjustment button, and pressing it once increases the value by one. After adjusting the hour, proceed to adjust the minutes. 2. Press the left button twice in quick succession to adjust the minutes. Then, similarly, use the right button to increase or decrease the minutes until the desired time is set. Note that you should operate quickly when adjusting the time. If the interval is too long, you may need to readjust. Additionally, you cannot adjust the time while the vehicle is in motion.

5

Share

Where is the headlight switch located on the Audi Q3?

How to Determine the Distance to the Following Vehicle

Is the Hongqi H5 front-engine?

What does it mean when the SVS warning light is on in the JMC Transit?

Can a car be started while charging?

What are the scoring rules for the reverse parking in Subject 2?

How to Adjust the Time on the Dashboard?

What is the purpose of a dash cam?

What is the chassis code for the BMW 4 Series?

What is the fuel consumption per 100 kilometers for the Nissan Sylphy Classic?

How to Deal with Understeer in a Car?