···
Log in / Register

Where is the fuel tank switch of the LANGDONG car?

3 Answers
LaBenjamin
07/29/25 4:22am
The fuel tank switch of the LANGDONG car is located below the driver's seat near the door side, and below it is the trunk switch. The LANGDONG is a compact 4-door 5-seater sedan. Taking the 2016 LANGDONG model as an example, its body dimensions are: length 4570mm, width 1775mm, height 1445mm, wheelbase 2700mm, fuel tank capacity 50 liters, and trunk capacity 473 liters. The 2016 LANGDONG model is equipped with a 1.6L 4-cylinder naturally aspirated engine, with a maximum horsepower of 128 and a maximum power of 93.8 kW. It is paired with a 6-speed manual transmission, adopts front-wheel drive, uses MacPherson independent suspension at the front and torsion beam non-independent suspension at the rear.
Was this review help?
8
1
Share
Alyssa
08/12/25 4:33pm
As a veteran Elantra owner for eight years, I know the fuel tank release location often confuses new drivers. It's a small lever hidden in the carpet near your left knee, right beside the clutch pedal, marked with a fuel pump icon. After unlocking the car, bend down and give it a firm pull to hear the fuel cap pop open with a click. Important winter tip: if the cable is frozen, don't yank forcefully. First tap the fuel cap to loosen the ice, or you might snap the cable - a $300+ replacement. Always refuel with the car unlocked, and remember to push the fuel cap shut firmly after refueling, otherwise the dashboard warning light will stay on.
Was this review help?
5
3
Share
Expand All
MacCarlos
10/03/25 2:46am
Recently helped my cousin pick up a used Elantra, and while teaching her how to use the car, I noticed the fuel tank switch has a rather unique design. Instead of searching around for a button, there's a small orange-labeled lever on the floor by the driver's left side—just look down and you'll see it. It's actually more convenient than the center console button type; once you get used to the position, you can operate it blindly without looking. But remember to ensure the car is turned off every time you refuel. Last time, a guy almost got scolded by the gas station attendant for pulling the switch while the engine was idling. Also, the Elantra's fuel cap is a spring-loaded one-way opening type; if you press it the wrong way, it won't open. Newbies should remember to turn it clockwise.
Was this review help?
14
0
Share
Expand All
More Forum Discussions

Is Audi Original Glass Better or Coated Glass Better?

Choosing coated glass is better. Coated glass offers many color options for the coating, and since the glass coating is applied to the 2nd and 3rd surfaces of the insulated glass, it ensures excellent durability of the coating. Additionally, selecting low-e coated glass can effectively prevent UV damage and more. Introduction to Coated Glass: Coated glass (Coated glass) is also known as reflective glass. Coated glass involves applying one or more layers of metal, alloy, or metal compound films on the glass surface to alter its optical properties and meet specific requirements. Depending on the product's characteristics, coated glass can be categorized into the following types: heat-reflective glass, low-emissivity glass (Low-E), conductive film glass, etc. Production Methods of Coated Glass: There are many production methods for coated glass, mainly including vacuum magnetron sputtering, vacuum evaporation, chemical vapor deposition, and sol-gel methods. Magnetron sputtering coated glass utilizes magnetron sputtering technology to design and manufacture complex multi-layer film systems, allowing for a variety of colors on white glass substrates. The film layers exhibit good corrosion resistance and wear resistance, making it one of the most widely produced and used products currently.
19
0
Share

What is the fuel consumption of the new Bora?

According to the test by the Ministry of Industry and Information Technology, the comprehensive fuel consumption of the new Bora 1.6L is around 6.8 to 7.2, while the 1.4T model is around 6.6. Introduction to fuel consumption: Fuel consumption (Constant-Speed Fuel Economy): Constant-speed fuel consumption refers to the fuel economy indicator when a car is driving at a constant speed on a good road surface. Since constant-speed driving is a basic operating condition for cars on highways, and this type of fuel consumption is easy to measure, it is widely adopted. Comprehensive fuel consumption: Comprehensive fuel consumption is tested under different conditions such as urban roads, highways, and varying loads. It is only a reference, and the actual fuel consumption may be higher or lower than this number. For example, driving daily in busy city areas, frequently braking and accelerating, can lead to higher fuel consumption, even reaching 10 liters per 100 kilometers, which is quite normal.
1
1
Share

Which one is the low beam headlight on the Baojun 560?

The low beam headlight on the Baojun 560 is controlled by a lever on the left side of the steering wheel. Above the turn signal indicator, there is a symbol for the low beam headlight. Twist it twice to turn on the low beam. Introduction to low beam headlights: Low beam headlights are designed for close-range illumination. Their design requirements include a wide coverage angle (160 degrees) and a short illumination distance, with non-adjustable focus. Illumination range of low beam headlights: The low beam headlights illuminate approximately 30-40 meters ahead. According to experiments, when driving at 55 km/h at night, the braking distance after noticing an obstacle is exactly 30 meters. This means that if you spot an obstacle within the low beam's range and brake immediately, there will be no gap between the car and the obstacle. Of course, this is under ideal conditions with good vehicle and road conditions and a quick driver reaction. If the speed is higher, or if the vehicle or road conditions are poor, or the driver is fatigued with slower reactions, the outcome can be imagined. Therefore, it is essential to control your speed when driving at night. On flat, wide, and well-lit roads, you can use high beams and drive slightly faster. However, when encountering oncoming traffic, uneven roads, turns, bridges, narrow roads, or intersections, you should slow down, generally keeping the speed below 40 km/h.
10
0
Share

What is the chassis code of the new Fit?

2021 Fit is the fourth generation Fit, and the chassis code of this model is GR9. The chassis code is commonly known as the frame number, similar to a person's ID number. The frame number is the ID number of that car. Normal frame number locations: Except for trailers and motorcycles, on the door hinge pillar, door lock pillar, or one of the pillars connected to the door lock pillar, near the driver's seat; fixed on the left side of the dashboard; fixed on the inner side of the door, near the driver's seat. It should be in a place where it can be easily read without moving any parts of the vehicle except for the outer door. The VIN code of most domestic cars can be found on the left side of the dashboard or below the windshield. Importance of the frame number: The frame number is like a person's fingerprint. If the steel plate with the frame number is damaged, the owner must not cut the steel plate with the frame number by themselves. The damaged condition of the vehicle must be preserved, and the car should be driven directly to the vehicle management department for certification to prove that the steel plate with the frame number is indeed damaged. Then, the vehicle management department will handle the situation according to the actual circumstances.
16
2
Share

What is the fuel consumption per 100 kilometers for the Audi A7?

Audi A7 has an average fuel consumption of 14.45 liters per 100 kilometers. Introduction to fuel consumption: Constant-Speed Fuel Economy refers to the fuel efficiency indicator when a car is driving at a constant speed on a good road surface. Since constant-speed driving is a basic operating condition for cars on highways, and this type of fuel consumption is easy to measure, it is widely adopted. For example, France and Germany use the constant-speed fuel consumption at 90Km/h and 120Km/h as the main evaluation indicators for fuel economy. China also adopts this indicator. Fuel consumption testing: Special personnel select experimental roads, use a specially marked fuel tank to run a 100-kilometer round trip (acceleration fuel consumption can be calculated, but coasting is not allowed), and then divide by two to calculate the actual constant-speed fuel consumption per 100 kilometers.
5
0
Share

How often should the automatic transmission fluid be changed in a new Santana?

The automatic transmission fluid and filter in the new Santana should be replaced every 60,000 kilometers, or every two years or 50,000 kilometers, whichever comes first. Transmission fluid change interval calculation: The replacement cycle for transmission fluid is calculated the same way as the vehicle's maintenance cycle, based on either mileage or time in use. If the vehicle's manual clearly specifies both indicators, follow whichever comes first. If the manual doesn't provide such indicators or doesn't clearly mark the fluid change interval, replace it every 50,000 to 80,000 kilometers. Transmission fluid change methods: Circulating machine fluid change method: This method can completely clean out the old transmission fluid. However, it's relatively expensive and suitable for vehicles less than 5 years old.
7
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.