Where is the fuel filter located in the Fit?

How to Perform a High-Speed Run with an Automatic Transmission?

Methods for performing a high-speed run with an automatic transmission: You need to place the gear in D mode, fully depress the accelerator for acceleration, and the tachometer will temporarily reach the red zone. After that, shift gears and repeat the process. However, the high-speed run should not last too long. Maintaining the RPM in the red zone for an extended period can increase wear and even cause overheating issues, potentially damaging the transmission. A high-speed run essentially allows a new car to test its maximum performance capabilities, but the RPM should not exceed two-thirds of the design limit. Performing a high-speed run can help clear oil passages, burn off carbon deposits, and improve future performance. The purpose of driving at a certain high speed is to break in components such as wheel axles and the main reducer, but the speed should be controlled between 100 km/h and 120 km/h. Avoid pushing the speed too high.

3

2

Share

Will an Automatic Transmission Car Move Without Pressing the Accelerator?

Whether an automatic transmission car will move without pressing the accelerator depends on the gear position: 1. If the gear is in P (Park) or N (Neutral), the car will not move whether you press the accelerator or not; 2. If the gear is in any position other than P or N, the car will move even without pressing the accelerator. For an automatic car in D (Drive) gear without pressing the accelerator, it is equivalent to a manual transmission car in 1st gear without pressing the clutch—this is the starting gear, and the car moves very slowly. For manual transmission models, this function is achieved through the clutch. When starting the car, if the accelerator and clutch are properly coordinated, the car will slowly move forward, also known as "creeping." If the clutch is released too quickly, the car will not only fail to move but may also stall.

8

4

Share

How to Determine When Brake Discs Need Replacement?

There are two main methods to determine if your brake discs need replacement: 1. Check the brake pad thickness: Most brake discs have wear indicators, which are three small dimples distributed on the disc surface. Use a caliper to measure the depth of these dimples; when it reaches 1.5mm (meaning the total wear depth on both sides of the disc is 3mm), the brake discs should be replaced promptly. 2. Listen for sounds: If you hear a metallic scraping or squealing noise when lightly applying the brakes, the brake pads must be replaced immediately. This noise indicates that the wear indicators on both sides of the brake pads are directly grinding against the brake disc, meaning the pads have exceeded their limit. In such cases, while replacing the brake pads, you should also inspect the brake discs. Often, the discs are already damaged when this noise occurs, and simply replacing the pads won’t stop the noise. In severe cases, the brake discs may also need replacement.

8

5

Share

What to Do If You Forget to Turn Off the Car Engine Overnight?

Forgetting to turn off the car engine overnight will not cause significant issues. In this idling state, the fuel consumption varies depending on the engine displacement, typically ranging from 0.5L to over 1L per hour. Therefore, even if the car idles all night, the total fuel consumption would be roughly equivalent to driving 100 kilometers. Simply refuel the next day. Below is some additional information: 1. Introduction: Idling is an operational state of a car where the engine runs in neutral gear. The engine speed during idling is called the idle speed, which can be adjusted by modifying the throttle opening. 2. Precautions: When the engine is running, releasing the accelerator pedal completely puts the engine in an idling state. Adjusting the idle speed should avoid sudden increases or decreases, as this can cause premature engine wear. It is best to have the idle speed adjusted at an auto repair shop.

6

5

Share

What Causes Frequent Coolant Loss in the Engine Radiator?

Reasons for frequent coolant loss in the engine radiator: leaks; high water temperature due to constant heavy workload; if the coolant was recently replaced, it could be due to air not being fully purged. Below are some explanations regarding high engine radiator temperatures: 1. Insufficient coolant: A lack of antifreeze in the engine cooling system may indicate leakage points, such as a water pump leak, damaged pipes, or a cracked radiator. 2. Thermostat failure: A faulty thermostat in the engine cooling system can cause excessively high water temperatures. If the thermostat fails to open, it restricts the flow of coolant within the engine, leading to overheating. 3. Cooling fan malfunction: If the cooling fan in the engine cooling system is not functioning properly, it reduces the efficiency of coolant heat dissipation. This can trigger the water temperature warning light and cause the coolant temperature to rise excessively.

11

4

Share

Where is the engine number located on the Besturn X80?

The engine number of the Besturn X80 is located in: 1. On the left side of the engine exhaust pipe, on the engine block, where it is displayed; 2. On the vehicle's driving license; 3. On the vehicle's nameplate, all of which will be marked. To check it, the driving license is the most convenient option. Taking the Besturn X80 2018 Live Edition 1.8T Automatic Luxury model as an example, its body dimensions are 4620mm in length, 1820mm in width, and 1695mm in height, with a wheelbase of 2675mm. It is equipped with a 1.8T turbocharged engine, matched with a 6-speed automatic manual transmission. The front suspension type is a double-wishbone independent suspension with a stabilizer bar, and the rear suspension type is a multi-link suspension with a stabilizer bar.

1

3

Share

Where is the fuel filter located in the Fit?

How to Perform a High-Speed Run with an Automatic Transmission?

Will an Automatic Transmission Car Move Without Pressing the Accelerator?

How to Determine When Brake Discs Need Replacement?

What to Do If You Forget to Turn Off the Car Engine Overnight?

What Causes Frequent Coolant Loss in the Engine Radiator?

Where is the engine number located on the Besturn X80?

Can You Turn on Hazard Lights While Driving in Heavy Rain?

What Causes an Automatic Transmission to Shake and Stall at Idle?

What type of engine oil should be used for the three-cylinder Excelle?

What is the W gear in an automatic transmission?