Where is the door drain hole of the Leopaard CS10 located?

2 Answers
DiAthena
07/28/25 3:58pm
The door drain holes of the Leopaard CS10 are located at the bottom of the door panel. Generally, each door has at least two drain holes. However, due to their low position, these holes can easily become clogged when driving on muddy roads for extended periods. If water accumulates inside the door, it can erode the door panel and damage components such as the window regulator and audio system. Hazards of door water leakage: 1. Door water leakage is usually caused by aging window seals or blocked door drain holes. 2. Door water leakage can lead to water seeping out from the door trim panel, and in severe cases, it may cause water accumulation under the cabin carpet. It is essential to clear these drain holes promptly during the rainy season. 3. In most cases, sunroof leakage is caused by blocked sunroof drain holes. Sunroof leakage can wet the roof trim panel and even result in water pouring into the cabin from the sunroof.
Was this review help?
8
1
Share
LeJuliette
08/11/25 11:08pm
As an enthusiast who frequently works on car repairs, I've noticed the door drainage hole designs in different vehicle models. The Leopaard CS10's door drainage holes are typically located at the very bottom edge of each door or on the inner side near the weatherstripping. Specifically, you can find several small holes in the plastic or metal area beneath the door frame. These holes are designed to allow rainwater or car wash water to drain smoothly, preventing water accumulation that could lead to corrosion or electrical failures. When driving regularly, I make it a habit to periodically check if these holes are clogged, as leaves, dust, or small insects can easily get stuck—blockages can be troublesome, causing water to back up into the door and damage components like the power window motor or speakers. Cleaning them is straightforward: use a thin wire or an air gun to gently clear the holes at least once a month. Pay extra attention during the rainy season or after car washes—this simple maintenance can save you from costly repairs and extend your door's lifespan. If the exact location is unclear, you can remove the door trim panel to confirm the hole positions, but be careful not to damage the seals. Additionally, the Leopaard CS10's door panels all feature similar designs to ensure water drains through the gaps, so regular cleaning is sufficient.
Was this review help?
2
1
Share
Expand All
More Forum Discussions

What is the fuel tank capacity of the Cadillac CT6 in liters?

Cadillac CT6 has a fuel tank capacity of 70L. The fuel consumption published by the Ministry of Industry and Information Technology is 7.9 liters per 100 kilometers. Methods to improve fuel economy: avoid prolonged idling or low-speed driving, prevent excessive vehicle load or overfilling the fuel tank, do not use high-viscosity oil, decelerate by easing off the accelerator instead of braking, minimize opening windows at high speeds, maintain the vehicle promptly, and set reasonable tire pressure when using the air conditioning. Sometimes it is necessary to stop by the roadside or in the vehicle for a while. If the vehicle idles in place, the engine continues to run, significantly increasing fuel consumption per 100 kilometers under these conditions. Additionally, during such stops or low-speed operations, the engine speed is relatively low, leading to incomplete combustion in the engine cylinders, which can easily cause carbon buildup, further increasing fuel consumption. Therefore, to reduce fuel consumption, it is essential to avoid prolonged idling and low-speed driving of the vehicle.
16
1
Share

Where to Check for China V or China VI?

How to determine between China V and China VI can be checked through the parameter configuration in the manual or by searching online. The differences between China VI and China V are as follows: 1. Emission content: The emissions under the China VI standard are far lower than those under the China V standard. The carbon monoxide emission limit for China V standard gasoline vehicles is 1000 mg/km, while under the China VI standard, it is reduced to 700 mg/km. China VI gasoline undergoes stricter treatment in olefin components, reducing the content of this component in the fuel. Additionally, the reduction in aromatic content leads to a decrease in particulate matter emissions from gasoline. 2. China VI standard: It is divided into two phases, 'China VI a' and 'China VI b', with nationwide implementation planned for July 1, 2020, and July 1, 2023, respectively. However, the China VI standard is extremely stringent, far surpassing the European Euro 6 emission standards and the U.S. Tier 3 standards, making it one of the strictest emission standards globally. The implementation period for the China VI standard will also be longer.
5
1
Share

Is it permissible to drive with 4cm high heels?

No. According to the Road Traffic Safety Law, driving while wearing slippers, high heels exceeding 4cm, barefoot, or holding a phone for calls—actions that impede safe driving—is prohibited. Violators will be penalized with a 2-point deduction and a fine. Driving with 3cm heels is allowed. Below are the impacts of driving in high heels: 1. Prone to getting stuck in gaps: Due to the excessive height of the heels (above 4cm), when the driver attempts to press the brake or accelerator, the heel can easily get caught in the gap between the pedal (brake or accelerator) and the car floor, preventing full depression of the pedal and severely affecting normal driving. 2. Heels are prone to getting stuck: When switching between the accelerator and brake pedals, the heel can easily get stuck during the transition. 3. Reduced pedal sensitivity: Wearing shoes with overly thick soles, such as platform shoes or height-increasing shoes, diminishes the foot's sensitivity to pedal depth, leading to excessive acceleration or deceleration.
6
0
Share

What is the normal speed for driving on highways?

Generally, the maximum speed limit on highways is 120 kilometers per hour. Below is relevant information about highway speed limits: 1. Speed limit regulations: When driving normally on highways, the minimum speed for motor vehicles should not be less than 60 kilometers per hour. The maximum speed for small passenger vehicles should not exceed 120 kilometers per hour; for large passenger vehicles, freight trucks, and motorcycles, it should not exceed 90 kilometers per hour. However, if the speed indicated by speed limit traffic signs or road markings differs from the above regulations, the signs or markings should be followed. 2. Different lane regulations: For highways with two lanes in the same direction, the minimum speed for the left lane is 100 kilometers per hour; for highways with three or more lanes in the same direction, the minimum speed for the leftmost lane is 110 kilometers per hour, and the minimum speed for the middle lane is 90 kilometers per hour. If the speed indicated by road speed limit signs differs from the above lane speed regulations, the speed indicated by the road speed limit signs should be followed.
20
2
Share

What are the symptoms of a faulty odometer sensor?

Car odometer and tachometer will stop moving, and the mileage will no longer increase. The following is relevant information about the car odometer sensor: 1. Principle: The roller counter was a purely mechanical instrument commonly used in the past, connected to the transmission output shaft via a flexible shaft on one end and to the odometer on the other. The more commonly used electronic instrument generally installs a speed sensor on the transmission output shaft or wheel, using the detected speed to convert into vehicle speed and mileage through a built-in calculation formula in the control module. 2. Advantages: The car odometer sensor is a widely adopted technology in today's automotive industry, primarily using Hall effect and photoelectric methods to detect signals. Its purpose is to effectively analyze and determine the vehicle's speed and mileage through odometer counting. This invention involves redesigning the originally vertically installed odometer sensor on the transmission into a chamfered odometer sensor, significantly reducing the torque during operation while maintaining the lubrication gap, enhancing service life, reducing failures, and overcoming all the drawbacks of the popular odometer sensors in the market, elevating this component to a new level.
5
3
Share

What are the precautions for the first maintenance of a new car?

Here are the precautions to note for the first maintenance of a new car: 1. Pay attention to the maintenance time: When consumers pick up the car, the staff at the 4S store will inform them of the first maintenance time and mileage. If the first maintenance time is approaching, the 4S store staff will also notify in advance. At the time of vehicle delivery, there is also a maintenance manual, which includes the first maintenance time and mileage for the vehicle. You can follow the indicated information for the first maintenance. 2. Required first maintenance items: The first maintenance of the car requires changing the engine oil and oil filter, and conducting a comprehensive inspection of the car. 3. Pay attention to the engine oil used in the first maintenance: Since the vehicle is in the break-in period, various components have not been fully broken in, and impurities may appear during use, affecting the performance of the engine oil. It is necessary to replace the engine oil in time during the first maintenance to avoid a decline in the performance of the engine oil.
3
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.