···
Log in / Register

Where is the cigarette lighter fuse located in a 2017 Envision?

6Answers
DelCarmen
07/28/2025, 02:30:30 AM

17-year-old Envision cigarette lighter fuse is located in the glove box on the passenger side. The following is an introduction about the Envision: 1. Power: The Envision is a mid-size SUV launched by SAIC-GM Buick. It is equipped with a 2.0-liter turbocharged four-cylinder engine. The LSY engine used in the LaCrosse has 237 horsepower and a maximum torque of 350 Nm. The maximum power speed of this engine is 5000 rpm, and the maximum torque speed is 1500 to 4000 rpm. 2. Body size: The length, width and height are 4694mm, 1839mm, 1686mm respectively, and the wheelbase is 2750mm.

Was this review help?
113
Share
McCatherine
08/11/2025, 10:31:10 AM

When I drove my 2017 Envision, I also frequently encountered cigarette lighter failures, mostly due to blown fuses. The cigarette lighter fuse is located in the vehicle's interior fuse box, specifically under the cover below the dashboard on the driver's side. Open that small door to find a diagram listing the purpose of each fuse; the cigarette lighter is usually labeled CIG and is typically the 15 or 20 amp one. Remember to turn off the car and remove the key first for safety. Replacing it yourself is simple—use tweezers to pull out the old fuse and insert a new one of the matching specification. Additionally, overloading the cigarette lighter or plugging in too many devices can easily blow the fuse, so avoid using high-power chargers regularly to prevent recurring issues.

Was this review help?
19
Share
Expand All
DelBrody
09/27/2025, 04:17:23 AM

From driving experience, the cigarette lighter fuse in the 2017 Envision is most likely located in a specific position within the fuse box. The box is situated in the driver's footwell area, with a small cover panel visible when you bend down. After opening it, there's a diagram—look for the label marked "CIG," as the cigarette lighter fuse is located there. It's rated at 15A or 20A, and the fuse box location is detailed in the owner's manual with an illustrated diagram. When replacing it yourself, ensure the vehicle's power is completely off, and use specialized tools to avoid short circuits. A reminder: avoid touching other components in the fuse box, such as the lighting or audio fuses, to prevent accidental damage to the electrical system.

Was this review help?
6
Share
Expand All
VanAdaline
11/10/2025, 10:28:55 PM

To locate the cigarette lighter fuse, open the small cover on the left side of the dashboard in a 2017 Envision. Inside is the fuse array, with the cigarette lighter labeled as CIG. Steps: First, turn off the engine and engage the handbrake; open the cover; locate the fuse using the diagram; remove the old fuse; replace it with a new one of the same specification. The entire process can be completed within 10 minutes without professional assistance.

Was this review help?
16
Share
Expand All
Kathleen
01/01/2026, 12:13:47 AM

Before repairing the cigarette lighter, ensure safety: park and turn off the engine, remove the key, and engage the handbrake. The 2017 Envision's cigarette lighter fuse is located in the box under the driver's area. Open the cover and refer to the chart to locate the CIG fuse. The position is clear, but don't overlook potential causes such as improper use of the cigarette lighter or aging wiring, which could lead to repeated fuse blowouts. Replacing a blown fuse immediately can prevent larger circuit failures that might affect other devices.

Was this review help?
5
Share
Expand All
OCharlie
03/29/2026, 01:37:25 AM

After driving this car for a few years, I've seen many cigarette lighter fuse issues. The location is in the fuse box under the driver's seat—just lift the cover to see the icons. The CIG (cigarette lighter) fuse is usually in the first row. The fuse is rated at 15 or 20 amps, so make sure not to mismatch the specification. Replacing it yourself is quick, but be careful with tools to avoid conductivity. Also, checking if the cigarette lighter socket is loose can prevent similar issues, ensuring stable and safe electrical usage in the car.

Was this review help?
18
Share
Expand All
More Q&A

Should the Buick GL8 use 92 or 95 gasoline?

According to the official vehicle manual recommendation, the Buick GL8 should use 95 gasoline. In addition to checking the appropriate gasoline grade in the vehicle manual, the Buick GL8 can also refer to the label on the fuel tank cap. Typically, the gasoline grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 gasoline, while those with a compression ratio between 10.0-11.5 should use 95 gasoline. However, with the application of new technologies, the gasoline grade cannot be solely determined by the compression ratio. A high compression ratio can still be adjusted to use lower-grade gasoline, as other factors such as ignition timing, turbocharging technology, and Atkinson cycle technology also play a role. Generally, the higher the gasoline grade, the higher the octane number and the better the anti-knock performance. 92 gasoline contains 92% isooctane and 8% n-heptane, while 95 gasoline contains 95% isooctane and 5% n-heptane. If the Buick GL8 occasionally uses the wrong gasoline grade, simply switch back to the correct grade after consumption. However, long-term use of the wrong gasoline grade can have the following effects: For vehicles recommended to use lower-grade gasoline, accidentally using higher-grade gasoline will not cause damage, but the increase in octane number will alter the fuel's ignition point, leading to delayed combustion in the engine. This reduces the engine's power output and thermal efficiency, resulting in poorer performance. For vehicles recommended to use higher-grade gasoline, using lower-grade gasoline can cause engine knocking. Due to the significantly lower octane number, the fuel's ignition point decreases, leading to premature ignition during the compression stroke. If combustion occurs before the spark plug ignites, resistance will arise during the upward stroke. This resistance makes the engine run very unstably. Mild knocking may only increase noise without significant engine damage, but noticeable knocking indicates severe engine conditions, affecting driving stability and causing abnormal wear on pistons and cylinders, potentially leading to cylinder scoring in severe cases.
103
Share

What is the tire size of the Fit?

The Fit has two tire sizes: 185/55R16 and 185/60R15. In 185/55R16, the first number 185 represents the tire width of 185MM, 55 indicates the aspect ratio of the tire cross-section is 55%, meaning the section height is 55% of the width, and 16 represents the rim diameter of 16 inches. The middle letter "R" stands for radial tire. In 185/60R15, the first number 185 represents the tire width of 185MM, 60 indicates the aspect ratio of the tire cross-section is 60%, meaning the section height is 60% of the width, and 15 represents the rim diameter of 15 inches. The middle letter "R" stands for radial tire. The Fit is equipped with Dunlop's ENASAVE fuel-saving and eco-friendly series tires, which combine fuel efficiency, environmental friendliness, and wet braking performance, enhancing driving comfort and stability. If you want to replace the tires yourself, follow these steps: Take out the spare tire and jack, place the jack under the vehicle frame near the tire to be replaced, ensuring the jack contacts the metal part of the frame; Raise the jack until it supports the car, making sure the jack is positioned under the vehicle and at a right angle to the ground; Remove the hubcap, loosen the nuts counterclockwise, but do not fully remove them—just enough to eliminate resistance. Keeping the tire on the ground when first loosening the nuts ensures the nuts turn, not the tire; Turn the nuts counterclockwise until they come off, repeat this step for all lug nuts, and remove all nuts completely; Place the new tire on the hub, carefully aligning the tire rim with the wheel bolts, install the lug nuts, and hand-tighten them until all nuts are snug. The tire replacement is now complete. Besides the model, tires also display the following common data: Tire cord material: Indicated by Chinese pinyin, such as M for cotton cord, R for rayon cord, N for nylon cord, G for steel cord, and ZG for steel radial cord tires. Speed rating: Indicates the maximum speed at which the tire can carry a specified load under defined conditions. Letters A to Z represent certified speed ratings from 4.8km/h to 300km/h. Common speed ratings include: Q: 160km/h; H: 210km/h; V: 240km/h; W: 270km/h; Y: 300km/h; Rim specification: Indicates the rim size compatible with the tire for practical use, such as "Standard Rim 5.00F".
115
Share

How to open the trunk of Dongfeng Honda CR-V?

To open the trunk of the Dongfeng Honda CR-V, follow these steps: 1. Open the door and enter the driver's compartment; 2. Press the trunk button to open it. The Dongfeng Honda CR-V has the following dimensions: length 4621 mm, width 1855 mm, height 1679 mm, with a wheelbase of 2661 mm, and a body structure of 5 doors and 5 seats. The Dongfeng Honda CR-V is equipped with a 1.5L turbocharged engine, delivering a maximum power of 142 kW at 5600 rpm and a maximum torque of 243 Nm between 2000 to 5000 rpm.
116
Share

How to Install a Parking Air Conditioner in a Car?

To install a parking air conditioner in a car, follow these steps: 1. Drill holes at suitable positions; 2. Secure the outdoor unit with matching screws; 3. Place the indoor unit inside the cabin and connect both units using the provided expansion valve and pipes. To turn off the car air conditioner, simply adjust the fan speed switch to position 0. The car air conditioning system is designed to regulate and maintain optimal temperature, humidity, air cleanliness, and airflow within the vehicle cabin. It provides a comfortable environment for passengers, reduces travel fatigue, creates favorable working conditions for the driver, and ensures safe driving.
103
Share

What is the cause of engine noise in Renault Scenic?

The cause of engine noise in Renault Scenic is: the bolts connecting the flywheel and the torque converter are not fully tightened, resulting in movement between the flywheel and the torque converter, which impacts the bolts. Taking the 2012 Renault Scenic as an example, its body dimensions are: length 4344mm, width 1845mm, height 1678mm, wheelbase 2703mm, minimum ground clearance 140mm, and fuel tank capacity 60l. The 2012 Renault Scenic is equipped with a 2.0l engine with a maximum power of 101kw and a maximum torque of 190nm, matched with a CVT continuously variable transmission.
119
Share

What is the displacement of the Nissan Patrol?

Nissan Patrol has a displacement of 5.6L. Displacement is a specialized term in hydraulic transmission, referring to the volume of fluid inhaled or discharged per stroke or cycle. The body dimensions of the Nissan Patrol are: length 5164mm, width 1999mm, height 1955mm, with a wheelbase of 3074mm, minimum ground clearance of 287mm, and a fuel tank capacity of 100L. The Nissan Patrol is equipped with a 5.6L naturally aspirated engine, delivering a maximum power of 293 kilowatts and a maximum torque of 555 Newton-meters, paired with a 7-speed automatic manual transmission. It features double-wishbone independent suspension for both front and rear suspension types.
107
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.