Where is the cabin air filter located in the 2009 Focus?

1 Answers
StEmery
07/30/25 7:54am
The cabin air filter in the 2009 Focus is located behind the panel on the right side of the accelerator pedal. The replacement method is as follows: 1. Use a screwdriver to remove the screws from the panel on the right side of the accelerator pedal; 2. After removing the screws, take off the plastic panel; 3. Once the plastic panel is removed, you will see the Focus's cabin air filter; 4. Replace it with a new cabin air filter, then reinstall the panel by reversing the removal steps. The 2009 Focus features a five-door, five-seat hatchback body structure with dimensions of 4342mm in length, 1840mm in width, and 1500mm in height. It has a wheelbase of 2640mm, front track of 1535mm, rear track of 1531mm, a fuel tank capacity of 55 liters, and a curb weight of 1321kg.
Was this review help?
14
2
Share
More Forum Discussions

Why is the entire Roewe RX5 not receiving power?

Here are the reasons why the entire Roewe RX5 is not receiving power: 1. An oxide layer between the battery terminals and battery posts causing no power. 2. Poor grounding of the main power switch to the vehicle body, blown power fuse, loose battery terminal connections, or battery damage, resulting in a short circuit in the car's electrical system. 3. The voltage line from the generator is disconnected, or the battery is excessively drained. It is best to have it further inspected at a repair shop. Below are the reasons for a car battery losing power: 1. The car has been parked for a long time, causing the battery to discharge: Even when the car is idle, the battery naturally discharges due to its self-discharge characteristics. 2. The battery has reached the end of its lifespan: Most private cars use maintenance-free batteries. Clean the battery's inspection window and observe the color inside; if it's green, the battery is functioning normally. 3. Insufficient battery electrolyte or leakage: During normal use, the battery's electrolyte naturally evaporates and depletes. 4. A blown fuse causing the battery to lose power: If the car's generator fuse is blown, the battery cannot charge, leading to a drained battery. This fault can be identified by the generator fault indicator light turning on. 5. Corrosion of battery terminals: Poor contact due to corroded battery terminals can also lead to a drained battery.
1
5
Share

What is the tire size of the Audi Q3?

Audi Q3 high-end models are equipped with 235/50R18 tires, while low-end models come with 235/55R17 tires. Tire brand of Audi Q3: The Audi Q3 is fitted with Goodyear Excellence series tires. The unique tread design ensures excellent grip performance under various dry and wet conditions, while also providing stronger support and higher limit performance for the body during cornering, thereby enhancing driving pleasure. Function of tires: Car tires are one of the important components of a vehicle, directly in contact with the road surface. Together with the car suspension, they help to mitigate the impact experienced during driving, ensuring good ride comfort and smoothness. They also improve the vehicle's traction, braking, and off-road capability, while bearing the weight of the car.
5
0
Share

What is the normal tire pressure for the Changan Benben car?

The normal tire pressure range for the Benben is 2.4-2.5 bar. Due to seasonal factors, the tire pressure can be appropriately increased by 0.2 bar in winter and reduced by 0.1 bar in summer. This data is based on the international GBT2978-2008 standard. To check the tire pressure of the Benben, first prepare a tire pressure gauge, locate the position of the original tire pressure label, press the tire pressure gauge against the tire valve to measure and read the value. After measuring, remember to cover the valve cap. Generally, a tire pressure exceeding 2.8 bar is considered too high, while a tire pressure below 2.0 bar is considered too low. Hazards of excessive tire pressure: Reduced tire friction and adhesion, affecting braking performance; causes steering wheel vibration and deviation, reducing driving comfort; accelerates wear on the central tread pattern, shortening tire lifespan; increases vehicle vibration, indirectly affecting the lifespan of other components; overextends the tire cords, reducing elasticity and increasing the load on the vehicle during driving. Hazards of insufficient tire pressure: Increased friction coefficient with the road surface, leading to higher fuel consumption; causes heavy steering and deviation, compromising driving safety; increases movement of tire components, leading to excessive rolling and abnormal heat generation; weakens the function of cords and rubber, causing delamination or cord breakage, and excessive friction with the rim, damaging the bead area and causing abnormal wear; multiplies friction with the ground, sharply raising tire temperature, softening the tire, and drastically reducing strength. High-speed driving may lead to tire blowouts. If the tire pressure monitoring indicator lights up (a yellow symbol, an irregular circle with no seal on top and four small spikes below, and an exclamation mark inside), there are generally three possible reasons: Abnormal tire pressure: Typically, it will alert if the pressure is below 1.8 bar or above 3.0 bar. In this case, tire inspection and pressure adjustment are required. Tire pressure monitoring not reset: After inflating the tires, if the tire pressure is not reset in time, the system will still record the previous data, causing the indicator to light up. Simply reset the tire pressure to resolve this. Damaged tire pressure sensor: The sensor, installed inside the tire and connected to the inflation valve, monitors tire pressure. If the sensor is damaged during driving, the tire pressure warning light will illuminate. For sensor damage, replacement with a new part is the only solution.
16
4
Share

Where is the rearview mirror heating switch for Audi Q5L?

The rearview mirror heating button for the Audi Q5 is located on the driver's door panel, on the knob used to adjust the left and right rearview mirrors. How to activate the rearview mirror heating: After pressing the button, the electric heating pad behind the rearview mirror glass will quickly heat up to a fixed temperature within a few minutes, usually between 35-60 degrees Celsius. Hot air will emerge from both left and right rearview mirrors, and the water droplets on the mirror surface will gradually evaporate and shrink due to the rising temperature, while the fog will slowly disappear. This achieves the effect of heating the mirror, removing fog and frost. The function of rearview mirror heating: The purpose of rearview mirror heating is to remove rainwater or fog from the mirror surface when driving in adverse weather conditions such as rain, snow, or fog.
2
2
Share

What is the reason for the sudden failure of the Audi Q5 sensor door lock?

Audi Q5 remote key lock and unlock failure may be caused by signal interference during remote operation or insufficient battery power in the remote key. Here are other reasons and solutions for the failure of the Audi Q5 remote key lock and unlock: Battery dead: If the car's sensor system fails due to a dead battery, charging the car can solve the problem. If the sensor key is out of power, you can use the spare mechanical key inside the sensor key to open the door, or simply replace the key battery. Signal interference: It may also be caused by long-term storage with digital devices such as mobile phones and iPads, leading to gradual electromagnetic failure. High temperature exposure, water damage, and other situations can also cause failure, requiring replacement at a repair shop.
13
3
Share

What is the recommended tire pressure for the Audi Q5 spare tire?

To save space, the spare tire of the Audi Q5 is stored with zero pressure. When in use, it is generally inflated to 2-2.5. Usage of the Audi Q5 spare tire: The spare tire of the Audi Q5 is an inflatable spare tire, which requires inflation before use. The vehicle is equipped with a built-in air pump for emergency use in case of a flat tire. When needed, simply install the air pump to inflate the spare tire. Without sufficient inflation, the spare tire will be useless and cannot function properly. Precautions for using the spare tire: When inflating the Audi Q5 spare tire, use a pressure gauge to adjust the tire pressure correctly. The spare tire pressure is different from that of the regular tire. If you don't have a pressure gauge, seek professional assistance to adjust the pressure before normal use. When replacing the spare tire, tighten the bolts diagonally to ensure even force distribution, preventing the tire from wobbling during driving. While using the spare tire, pay attention to the vehicle speed and avoid exceeding 90 kilometers per hour.
15
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.