Where is the Bluetooth switch in the Sylphy?

What is the fuel tank capacity of the Great Wall Tengyi C30?

The fuel tank capacity of the Great Wall C30-2016 1.5L Manual Luxury model is 40L. It is equipped with a 1.5L naturally aspirated engine and a 5-speed manual transmission (MT). The drivetrain is front-engine, front-wheel drive. The front suspension is a MacPherson independent suspension, and the rear suspension is a torsion beam composite suspension. In the same vehicle class, the Great Wall C30-2016 1.5L Manual Comfort model also has a 40L fuel tank capacity, while the Southeast A5 Wing Dance-2021 1.5L Manual Wing Edition has a 50L fuel tank capacity. During actual refueling, the amount of fuel may exceed the calibrated capacity. This is because the fuel tank capacity marked by the manufacturer is measured from the bottom of the tank to the safety level, with additional space from the safety level to the tank opening. This space ensures that the fuel can expand when temperatures rise without overflowing. If fuel is filled up to the tank opening, the actual refueling amount may exceed the calibrated capacity. To check the remaining fuel level, drivers can observe the fuel gauge on the right side of the dashboard, marked with E and F. When the needle is close to E, it indicates low fuel, and when it is near F, it means the fuel level is sufficient.

5

3

Share

What is the Principle of a Four-Wire Motorcycle Rectifier?

The principle of a four-wire motorcycle rectifier: The rectifier, also known as a voltage regulator, converts AC voltage into DC voltage. Voltage stabilization involves maintaining the unstable voltage output from the generator within a specified range. The device that achieves these two functions is called a rectifier-voltage regulator. The four-wire rectifier includes four wires: green, pink, yellow, and red. The green wire is the ground and is directly connected to the chassis; the pink wire is the AC input, connected to the generator's AC line; the yellow or white wire is the other AC input, connected to the other end of the generator's AC output; the red wire is the output positive terminal after rectification and voltage stabilization, used to connect to the positive terminal of the battery. The rectifier is a very important electrical component on a motorcycle. Its functions are twofold: first, to provide a stable working voltage for the motorcycle's electrical equipment, and second, to divert excess current to protect the electrical devices. It converts the AC electricity generated by the magneto into DC electricity, while reducing the higher voltage to a suitable level to charge the battery. Additionally, it dissipates excess electricity through resistors to achieve voltage stabilization. Once the generator fully charges the battery, it automatically shuts off and stops working. This means the engine does not need to waste fuel overcoming magnetic torque. Therefore, the four-wire chopper type is more fuel-efficient.

10

1

Share

What are the main causes of tire blowouts?

Tire blowouts can be caused by air leakage, excessive pressure, or severe wear. Below are the specific reasons: Causes of tire blowouts: Air leakage: When a tire is punctured by a nail or other sharp object but not immediately ruptured, air leakage occurs, which can lead to a blowout. Excessive tire pressure: As a car travels at high speeds, the tire temperature rises, increasing the pressure and causing deformation. The tire's elasticity decreases, and the dynamic load on the vehicle increases, which can result in internal cracks or blowouts upon impact. Insufficient tire pressure: When driving at high speeds, a tire that is not sturdy enough or already damaged is prone to blowouts. Severe wear: After prolonged use, tires may wear out significantly, with no tread left on the crown and thinning sidewalls, making them unable to withstand the high pressure and temperature of high-speed driving, leading to blowouts. Measures to handle a tire blowout: Do not brake suddenly; instead, slow down gradually. A sudden blowout at high speed can cause the vehicle to veer, and sudden braking can worsen this veering, potentially leading to a rollover. While slowing down gradually, firmly grip the steering wheel with both hands and turn it in the opposite direction of the blowout to maintain the vehicle's straight-line movement.

19

5

Share

Differences Between First, Second, Third, and Fourth Gears in Cars

There are several differences between the first, second, third, and fourth gears in cars: 1. Different gear speeds: First gear is used for starting, with speeds up to 20 km/h; second gear is used between 20-40 km/h, while third gear can be used between forty to sixty km/h. 2. Different purposes: First gear is for starting, second gear is for transition, third gear is for slow speed, and fourth gear is for medium speed. When starting in first gear, it should be done as slowly as possible. First gear is generally used only when starting or turning. Third gear at 2500-3500 RPM provides suitable engine torque for overtaking or climbing steep slopes, but at this point, fuel consumption increases and engine noise becomes louder. Second gear at 2000-2500 RPM is more fuel-efficient (varies slightly depending on the engine), with moderate engine torque and relatively lower noise, making it suitable for normal driving. 3. Different driving conditions: First gear is the starting gear, used when the car begins to move. Its gear ratio is similar to reverse gear, so it is not suitable for sustained high-speed operation. Generally, once the car has gained momentum, you can shift to second gear. Second gear is the passing gear, mainly used for navigating complex road surfaces and handling complicated situations. Third gear is the transition gear, primarily used for low-speed driving in urban areas. Depending on the situation, you can easily shift up to fourth gear for acceleration or down to second gear for deceleration.

8

5

Share

Will points be deducted if the car head sweeps the line in an S-curve?

Points will not be deducted if the car head sweeps the line in an S-curve. During curve driving, if the wheels run over the road edge line, it will be considered a failure. Additionally, stopping for more than 2 seconds or not shifting to second gear or above will result in a 5-point deduction. Therefore, as long as the wheels do not cross the line, no points will be deducted. Here are some precautions for the right-angle turn in Subject 2 of the driving test: Before entering the curve, be sure to slow down the speed. The key is to align the car body properly. When the car body is aligned, drive slowly close to the outer edge line of the road and control the lateral spacing. It is advisable to keep the outer wheels about 30cm away from the outer edge line and maintain parallel movement. When the car head approaches the turning point, do not delay in turning the steering wheel sharply. When the front bumper aligns with the turning point, quickly turn the steering wheel to the limit position (left or right). Avoid pressing the accelerator pedal too hard. First, check if the car can pass ahead, then move forward slowly. For right-angle turns that you are unsure about, you can stop and check beforehand. During the turn, always pay attention to the movement of the car body and the position changes of the wheels. If conditions allow, you can pass slowly under someone else's guidance. Keep track of the rear wheels in the rearview mirror and remember to turn the steering wheel back in time. When the car head approaches the turning point of the right-angle turn, promptly turn the steering wheel back. When the car head turns to the new direction, gradually straighten the wheels to make the car move forward quickly. At the same time, you can also observe the rearview mirror to check the movement of the rear wheels. When the rear wheels are about to pass the turning point, straighten the steering wheel.

7

2

Share

What Causes Smoke from the Front of a Car?

There are many reasons why a car emits smoke, and the issue can be identified based on the color of the smoke, such as engine overheating, decreased cylinder pressure, etc. Below are the specific details: Reasons for white smoke from the front of a car: Generally, if white smoke persists from the car engine even in a warmed-up state, it could be due to two scenarios: a small fuel injection advance angle causing incomplete combustion, or minor water leakage in the cylinder liner or water in the fuel. White smoke during a cold start, especially in low temperatures, which disappears as the engine warms up, is a normal phenomenon. Reasons for black smoke from the front of a car: An imbalanced air-fuel ratio; decreased cylinder pressure; early fuel injection timing (excessive fuel injection advance angle) can cause black smoke; failure of the smoke limiter on the fuel injection pump can also lead to black smoke during rapid acceleration; malfunctioning exhaust brake system. If severe black smoke is observed, other issues should also be considered. Reasons for blue smoke from the front of a car: Blue smoke from a car engine is often caused by "burning engine oil." In such cases, check for wear in the engine cylinder liner, "stuck piston rings," misaligned rings, aging or deformed valve seals, excessive valve guide clearance, etc., which may also be accompanied by crankcase blow-by. Severe oil discharge from the turbocharger can also cause some oil to enter the cylinder through the intake tract, resulting in "blue smoke." Therefore, during routine maintenance, the turbocharger's oil discharge should be checked, and any oil in the connecting line between the turbocharger and the intercooler should be promptly cleaned.

3

Share

Where is the Bluetooth switch in the Sylphy?

What is the fuel tank capacity of the Great Wall Tengyi C30?

What is the Principle of a Four-Wire Motorcycle Rectifier?

What are the main causes of tire blowouts?

Differences Between First, Second, Third, and Fourth Gears in Cars

Will points be deducted if the car head sweeps the line in an S-curve?

What Causes Smoke from the Front of a Car?

What are the general routine maintenance aspects of a car?

What Causes the Car Key to Turn but the Engine Not to Start?

What is the Principle of Hover Cars?

What is the spark plug model for the Baojun 630?