···
Log in / Register

Where is the battery located in the Haval H8?

6Answers
SabrinaMarie
07/28/2025, 07:02:30 PM

Haval H8 battery is located under the front passenger seat, which can be seen by lifting the seat. Car battery replacement cycle: Under normal usage, the battery generally needs to be replaced every two years or so. If the air conditioning is frequently used with the engine off or electrical equipment is operated without idling, the battery may need replacement in less than two years. Of course, good driving habits can extend the battery's lifespan, allowing replacement at two and a half or even three years. However, the exact timing for battery replacement should be determined based on the battery's wear and tear. Types of car batteries: Batteries are generally divided into two types: ordinary lead-acid batteries and maintenance-free batteries. Both types of batteries can have their lifespan affected by harsh usage or moderate usage.

Was this review help?
104
Share
MacLyla
08/11/2025, 10:23:26 PM

My 2016 Haval H8 has a sneaky battery location—it's not in the engine bay at all! You’ll find it under the trunk floor. Here’s how: First, clear out the trunk clutter, lift the bottom felt mat, and you’ll spot a small cover with a pull handle in the center. Pry open two plastic clips with your fingernail to remove the cover, and the battery lies horizontally in a foam slot. Even a roadside assistance guy got it wrong before, so remind anyone giving a jump-start about its location. Many urban SUVs use this design to save engine bay space and balance front-rear weight. When replacing it yourself, avoid reversing the terminals, and choose battery model H6-60-L-T2-A.

Was this review help?
17
Share
Expand All
JourneyLee
10/01/2025, 01:02:06 AM

Just helped my neighbor with this issue. The Haval H8's battery is indeed located in the lower compartment of the trunk, under the floor mat. Be careful when lifting the cover as the plastic clips are prone to breaking—I used a bank card to pry it open last time. It's advisable to keep a portable jump starter in the car. Last week, her car battery died, and she almost couldn't open the trunk. This design has its pros and cons: good for anti-theft but troublesome in emergencies. The battery capacity is usually 80Ah, but models with start-stop systems require a different type—remember to provide the VIN when purchasing to confirm. Also, be cautious during the rainy season as water leakage in the trunk can cause a battery short circuit.

Was this review help?
6
Share
Expand All
VanRicardo
11/14/2025, 01:49:30 AM

As a mechanic, it's common to encounter car owners who can't locate the battery. The Haval H8 features a design where the battery is hidden under the chassis in the trunk, requiring three steps: 1. Empty the trunk items; 2. Lift the felt layer of the trunk floor; 3. Locate the cover with a square notch and press the buckle with your thumb to open it. The design aims to optimize the weight distribution ratio. A reminder to all car owners: When replacing the battery, disconnect the negative terminal first, using a 10mm wrench to loosen the nut. If the battery voltage measures below 11.8V, it's time for a replacement.

Was this review help?
11
Share
Expand All
Troy
01/04/2026, 03:30:14 AM

Last winter, my H8 suddenly broke down, and I discovered the battery was hidden in the trunk's secret compartment. At -15°C, here's what I did: first, I emptied the storage box, lifted the floor panel to reveal the foam tray, and there it was—the black rectangular cover in the middle. Later, I learned this layout helps avoid engine heat, extending battery life. It's advisable to keep an emergency jump starter, especially in extremely cold regions where battery capacity degrades quickly. Regularly check the battery terminals for white crystalline deposits; pouring hot water can remove the oxide buildup.

Was this review help?
13
Share
Expand All
Mandy
04/01/2026, 03:34:06 AM

Sis, my H8 battery replacement story was so awkward! Searched all over the engine bay but couldn't find it, turns out the mechanic said it's in the trunk. The operation is actually simple: lift the trunk mat to see a rectangular cover, pry open the clips on both sides with your nails. This design improves front-rear weight distribution. When replacing it yourself, pay attention to whether the new battery size matches the foam slot - the original Varta battery dimensions are 343×175×190mm. Suggest girls keep jumper cables in the trunk side mesh pocket, it's more convenient to connect from the trunk when you really run out of power.

Was this review help?
4
Share
Expand All
More Q&A

How to Turn on the Cold Air in an Electric Car's Air Conditioning?

The car has buttons marked with blue and red colors. The blue part represents cold air, the red represents warm air, and the middle represents a moderate temperature. Adjust it to the blue part. The button with a white line on the left is the temperature adjustment button. If you feel too warm, adjust it to the middle. If not in use, set it to the fan symbol. The button on the far right controls the mode, which can be adjusted to blow air only to the feet, hands, or windshield. You can also use two modes simultaneously. The AC switch is marked with 'AC.' Some are integrated with the temperature adjustment buttons, while others are independent. After setting, press it to turn on.
106
Share

How Often Should the Coolant in a Mercedes-Benz E-Class Be Replaced?

The coolant in a Mercedes-Benz E-Class generally needs to be replaced every 2 years or 40,000 kilometers. This is just a reference interval. For commercial vehicles with higher mileage, the replacement interval should be shorter. Since driving conditions vary for each vehicle, the replacement should be based on actual usage. Check the coolant level regularly and top it up if it is low. If suspended particles, sediment, or discoloration are observed in the coolant, replace it immediately and clean the system. Coolant Replacement Method: Before a complete coolant replacement, conduct a thorough inspection to check for leaks or cracks in all pipes, with a focus on the five-way hose. The five-way hose, named for its five connecting interfaces, distributes coolant to different parts of the car. If any leakage is detected in this section, replace the hose or reseal the connections as needed. Drain the old coolant and flush the system with clean water. Add water to the coolant reservoir and continuously flush the engine cooling system. Then, start the engine and let it idle for 3 to 5 minutes to circulate the water. Initially, the drained water may appear slightly pinkish. Continue flushing until the water runs clear. Remember to disconnect the heater hose and drain the water from the heater core. After draining for about an hour, add new coolant through the radiator hose to allow quick flow into the radiator. Then, fill the coolant reservoir with another bottle of coolant until it is nearly full. Run the engine for about 10 minutes. As air is purged from the cooling system, the coolant level will drop. Top up the coolant to the "MAXT" mark on the reservoir.
106
Share

How to Operate an Automatic Transmission Car Correctly?

Correct operation method for starting an automatic transmission car: 1. After sitting in the driver's seat, the driver does not need to press the brake pedal, just press the start button once to turn on the ACC indicator, then press it again to initiate the vehicle self-check (for models with one-button start function). 2. Depress the brake pedal and press the start button once more to ignite the engine; release the ignition switch immediately after the engine starts. Holding it down may cause gear grinding between the starter and engine flywheel, shortening the starter's lifespan. 3. Release the foot brake and allow the engine to warm up for 1-3 minutes. The instrument panel has a C-F coolant temperature gauge - when the pointer reaches the middle position, it indicates the coolant has reached 90°C, meaning warm-up is complete. 4. Depress the foot brake again, shift to D gear, and release the parking brake (for electronic parking brakes, simply press the button briefly). Before moving, check the vehicle surroundings carefully. Due to blind spots, use the horn and turn signals to alert nearby vehicles and pedestrians. 5. Gradually release the foot brake while gently applying throttle to complete the starting procedure.
118
Share

How to Tow a Car with Electronic Gear Shift?

First, check the car's battery level. If there is power, press and hold the power button for 10 seconds to unlock the gear shift when the vehicle is fully powered on. The N gear is the neutral position, allowing the car to be towed. Without pressing the brake, long-press the ignition button for a security check, then release the handbrake and shift to N gear. After completion, the engine needs to be turned off. Newer car models may have a mechanical gear shift button, usually located near the gear lever and labeled as SHIFT. Press and hold this button to shift into N gear. For older car models, remove the ashtray to reveal a small cover. Use a small flat-head screwdriver to pry it open, then press and hold downward to shift gears.
101
Share

What to Do When the Electric Oil Pump Fails to Pump Oil?

Check the oil level height. If the oil level is too low, promptly add the appropriate type of oil as required. Incorrect oil grade can cause the oil viscosity to be too high or too low. Select the appropriate oil grade according to the season. Generally, use higher-grade oil in summer and lower-grade oil in winter. If the added oil is unclean, it may clog the oil filter or suction pipe. Regularly clean the oil filter and pipelines, and ensure the added oil is filtered to maintain cleanliness. Check if the sealing ring at the oil suction port is damaged. Also, inspect the suction pipeline and self-tightening oil seal. If there is air leakage due to damage, take sealing measures or replace the sealing components.
114
Share

What to Do When the Battery Gets Wet?

If the battery gets wet, do not charge the electric vehicle. You must dry the battery thoroughly and check whether reconfiguration and electrolyte replenishment are needed. If there is significant water ingress, pour out and wipe dry all the water inside the battery. Then, clean it with distilled water or high-purity water, and add electrolyte to adjust the density. You can choose to use a qualified battery repair machine to directly repair the battery. If the battery is damaged beyond repair due to water ingress and cannot be used, you can only replace it with a new battery at a repair shop.
105
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.