Where is the airbag connector located?

1 Answers
ORuby
07/29/25 11:37pm
The airbag connector is located beneath the airbag, specifically under any interior panel marked with 'airbag'. These connectors are typically yellow in color. Here are relevant details: 1. Driver side: The driver's airbag is situated beneath the steering wheel. To access it, remove the two bolts on the steering wheel rear cover, then disconnect the clock spring connector attached to the inflator. 2. Passenger side: Passenger airbags come in two types - split type and integrated type. The split type features a separate airbag cover with visible gaps between it and the dashboard, marked with 'SRS' or 'airbag' or a combination of both. The integrated type has the airbag cover molded as part of the dashboard, also bearing similar markings.
Was this review help?
20
4
Share
More Forum Discussions

How to Replace Brake Fluid by Yourself?

Drain the brake fluid from the reservoir and fill it with new brake fluid. One person presses the brake pedal (2-3 times) and holds it down without releasing, while another person loosens the bleeder screw on the brake caliper below, allowing fluid to flow out. When the pedal drops to the bottom, close the bleeder screw. Repeat this process several times until new fluid flows out. Continuously add fluid to the reservoir to prevent air from entering. Use a line wrench to loosen the two brake lines until brake fluid flows out. When there is no more brake fluid in the reservoir, tighten the two brake lines.
17
1
Share

How to Replace a Motorcycle Tubeless Tire?

Use an adjustable wrench to loosen and remove the rear axle nut of the motorcycle. It may be tight, so apply more force, then separate the other components. Remove the tire valve core to allow the casing to expand and contract, then use two tire levers together to remove the old tire. Take off the rim, wash it thoroughly with water, and wipe it clean with a cloth. Then install the new tire onto the rim. After installation, inflate the tire with compressed air. Check that the tire is properly installed and undamaged, then reinstall it onto the motorcycle frame.
1
3
Share

What to Do When the Hood Release Lever Pops Back but the Hood Won't Open?

It might be due to insufficient lubrication of the hood latch spring. Apply some lubricating oil. Lift the hood, reach inside, and pull a mechanical release button to open the hood. Use a screwdriver as a hook to open the engine hood. Crawl under the car, use a wire to pull from beneath the engine to the hood keyhole, and then pull to open the front hood. Open the main driver's door, remove the door seal, make a hook with a thick wire about one and a half meters long, place the hook into the lower right corner of the door motor to open the door, and then the hood can be opened.
7
0
Share

How to Deal with Foggy Windshield on Passat?

Blowing hot air can effectively defog the windshield. At the same time, turn on the external circulation of the air conditioning and set the air vents to defog mode to prevent the car interior from getting too cold. After the front windshield fogs up, slightly lower the window to allow outside air to flow into the car, which will quickly disperse the fog. Keep a towel ready to wipe off the fog when it appears. Applying a mixture of dish soap or soapy water, then rinsing with clean water and drying it off can prevent fogging for a short period. Glycerin can also be used as an alternative.
1
0
Share

How to Deal with Frozen Snow on Car Windows?

Do not drive immediately after getting in the car, as frost impairs visibility, and avoid using the windshield wipers to scrape. Instead, warm up the car while stationary to allow the engine coolant temperature to rise. After the engine coolant temperature has risen, turn on the heater and adjust the airflow direction to upward mode. Let it blow for a while to melt the frost. As soon as the frost begins to melt, wipe away the moisture. Repeat this process several times to gradually increase the melted area and prevent refreezing. Using a snow scraper can improve efficiency, but ensure to choose a high-quality one with soft rubber blades to avoid scratching the windshield. If conditions permit, you can rinse with lukewarm water. Be sure to control the temperature—avoid using excessively hot water—and wipe dry after the frost has melted.
2
2
Share

How to Check the Current Location of Your Car?

Download and install the GPS vehicle monitoring system, then click to enter and monitor your car. Enter your license plate number on the screen, and it will locate your current position and the parking location of your car, providing the best route to retrieve your vehicle. Open the car-finding app on your phone to locate your car. Some GPS systems also allow you to check your car through a WeChat public account. It features a deviation alarm function; if your car moves beyond the set range, your phone will immediately display an alarm message.
17
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.