···
Log in / Register

Where is the air conditioning filter of the Roewe 550 located?

6Answers
DeLeila
09/05/2025, 12:05:58 AM

Roewe 550's air conditioning filter is located behind the sealing strip in the engine compartment. The replacement method for the air conditioning filter is as follows: 1. Remove the fasteners of the sealing strip and pull the strip from left to right; 2. Unscrew the screws above; 3. Hold the pressure strip and gently pull to remove the air filter; 4. Prepare the new air filter, paying attention to the correct installation direction, and then replace it. The Roewe 550 has a body length, width, and height of 4648mm, 1827mm, and 1483mm respectively, with a wheelbase of 2705mm. The car is front-engine, front-wheel drive, and the engine it is equipped with has a maximum power of 98kw and a maximum torque of 170nm.

Was this review help?
106
Share
KadenDella
09/17/2025, 12:40:45 AM

I've been driving the Roewe 550 for several years, and its cabin air filter is located behind the glove compartment on the passenger side. Open the glove box, and you'll see several clips or screws inside. After gently removing them, a small cover plate is revealed, and the filter is inside that box. Replacing it yourself is quite simple. I usually change it once a year, and buying the same model filter only costs a few dozen yuan, saving the expense of going to a repair shop. After replacement, the air inside the car becomes noticeably fresher, which is especially important for people with pollen allergies. Pay attention to the accumulation of dust in daily use; if there's an odd smell when the air conditioning is on, it's time to replace it. Developing a habit of regular checks not only protects the health of the car's interior but also saves money.

Was this review help?
7
Share
Expand All
DelHope
10/31/2025, 01:09:53 AM

From practical experience, the cabin air filter of the Roewe 550 is designed inside the glove compartment on the passenger side. You need to remove the glove box first, usually by pressing the clips on both sides to easily detach it. The filter housing is hidden behind, and you can remove the old filter by opening the cover. When replacing, pay attention to align the directional arrow on the filter correctly, otherwise it may affect the filtration efficiency. If a dirty filter is not replaced in time, it can allow dust to be sucked into the cabin, causing coughing or allergies. It is recommended to replace it every 10,000 to 20,000 kilometers. Doing it yourself is very convenient, requiring no professional tools, saving time and effort while improving driving comfort.

Was this review help?
15
Share
Expand All
SilasMarie
12/14/2025, 12:18:32 AM

I just replaced the cabin air filter of my Roewe 550 by myself, which is located inside the glove compartment on the passenger side. Open the compartment, there are clips inside, just pry them open and you'll see the filter housing. The steps are super simple: take out the old filter and insert the new one you bought, the whole process takes less than ten minutes. After replacement, there's no more unpleasant odor from the air vents, and the air quality inside the car has improved significantly. Even beginners can easily handle it without spending money to hire someone else.

Was this review help?
20
Share
Expand All
AlyssaMarie
02/03/2026, 01:18:11 AM

To maintain good air quality inside the car, I always check the cabin air filter. In the Roewe 550, it's located behind the glove compartment on the passenger side. You can access the filter housing by removing the glove box, and replacing the filter helps reduce bacterial growth and prevent respiratory issues. I usually change it once each in spring and autumn to keep the air fresh. The process isn't difficult and can be done by hand—it's both safe and economical. Developing this habit benefits both health and the air conditioning system.

Was this review help?
8
Share
Expand All
TuckerRose
04/28/2026, 05:52:33 PM

DIY Tips for Replacing the Cabin Air Filter Yourself: The filter in the Roewe 550 is located inside the glove compartment on the passenger side. Remove a few plastic clips to reveal its position. Be careful not to install it backwards. After replacement, turn on the AC and let it run for a minute or two to test the airflow. A dirty filter can cause unusual noises or reduce cooling efficiency. I replace mine every six months—it saves money and gives peace of mind. Choose an OEM filter to ensure a proper seal, and check if the glove compartment is loose before starting to avoid damaging any parts.

Was this review help?
20
Share
Expand All
More Q&A

What lights should be used when driving at night?

When driving at night, you generally turn on the width indicator lights and low beams. If the lighting is insufficient or there are few oncoming vehicles, you can also use high beams. However, it's important to note that when encountering oncoming traffic, you should switch from high beams to low beams to prevent affecting the visibility of the oncoming vehicles and causing safety hazards. Here is some additional information: 1. Night driving: Strictly controlling your speed is the fundamental measure to ensure safety. Maintain a moderate speed, increase your following distance, and be prepared to stop at any time. To avoid potential dangers, try to increase your following distance to prevent collisions with vehicles in front or behind. 2. Driving in the city: Pay attention to pedestrians crossing the road from the left. Especially since streetlights in urban areas are mostly on both sides of the road, the area near the centerline is often poorly lit, so extra caution is needed in such situations.
119
Share

Why does the ABS light come on?

ABS light comes on due to weakened signals or loose wiring. The solution is to clean the sensors thoroughly and reinstall the wiring. When the sensing part of the ABS speed sensor is covered by dirt, mud, or other contaminants, it affects the sensor's ability to detect the corresponding speed signal. This prevents the ABS computer from identifying the vehicle speed and determining the wheel slip rate, thus failing to issue appropriate commands to adjust braking. Solution: Clean the dirt from the speed sensor and adjust the gap between the speed sensor and the signal ring to restore normal operation. System malfunctions can also occur due to poor signal quality caused by loose connections between system lines or poor contact in ABS relays. The most common issue is a loose speed sensor wire connection, which will also show as a poor speed sensor signal in the ABS computer's fault memory. Solution: Check all wiring connections, reconnect any loose parts, and verify if the fault is resolved.
113
Share

Will a hot charging battery explode?

Battery heating during charging will not cause an explosion. It is normal for a car battery to heat up during charging. When the battery is charging, the electrolyte inside will be in a boiling state, so when you touch it with your bare hands, you will naturally feel the battery heating up, and theoretically, there is no risk of explosion. Below are some relevant details: 1. Abnormal heating: If the heating is abnormal, it may lead to thermal runaway of the battery, causing it to swell. This abnormal phenomenon occurs because the car battery has become severely sulfated and requires timely repair. 2. Repair method: The method to repair a sulfated battery is to discharge the battery, then pour out the original electrolyte, and charge it with a low current within a temperature range of 20 to 40 degrees Celsius. After the charging is completed, the sulfation phenomenon will be eliminated, and the battery capacity can basically be restored to more than 80%.
104
Share

Can I Transfer Between Driving Schools?

It is possible to transfer to another driving school during the course of learning to drive. As early as 2019, the small vehicle driver's license test was implemented nationwide, allowing individuals to apply for a driver's license in any city across the country with just their ID card. If you need to change your place of residence due to work, study, or other reasons during the learning process, you can transfer to another driving school. The process for transferring driving schools mid-course is as follows: 1. Apply to the driving school: After the driving school agrees, use your ID card to complete the transfer procedures and obtain a transfer certificate; 2. Retrieve your records: Go to the vehicle management office or the driving school to retrieve your electronic records; 3. Enroll: After selecting a new driving school, bring your ID card, electronic records, and transfer certificate to register; 4. Transfer registration: After registration, use your ID card and electronic records to complete the electronic transfer registration at the local vehicle management office; 5. Learning: Once the transfer is successful, you can begin learning and taking tests.
102
Share

Can car seat leather be replaced if it's torn?

If the surface is accidentally scratched or damaged, the genuine leather of the seat can certainly be replaced. However, replacement is not recommended for the following reasons: 1. From an overall cost perspective: Taking the driver's seat as an example, the genuine leather of the seat is divided into two parts. When replacing, only one part can be replaced entirely. The overall cost of replacing the seat's genuine leather is relatively high. 2. From a safety perspective: Many car models are equipped with side airbags in the seats. These side airbags are installed between the seat frame and the genuine leather. If the replaced seat leather is of substandard quality or improperly installed, it could severely hinder the airbag from deploying properly in the event of an accident. Therefore, it is essential to regularly maintain and care for genuine leather seats during daily use. If any damage occurs, it is advisable to promptly seek professional repair services for surface restoration of the leather.
117
Share

How many points are deducted for not wearing a seatbelt in the passenger seat?

No points are deducted for not wearing a seatbelt in the passenger seat, but a fine of 20 yuan will be imposed if caught on camera or during an on-site inspection. For drivers not wearing seatbelts while driving on highways or urban expressways, a fine of 50 yuan and 2 points will be deducted, while passengers not wearing seatbelts will be fined 20 yuan, given a verbal warning, and ordered to correct the behavior. Proper seatbelt usage guidelines: 1. Regular inspection: Periodically check the technical condition of the seatbelt, and replace damaged seatbelts promptly. 2. Correct seatbelt usage: The three-point lap belt should be fastened at the hips, not the waist, with the fastening position as low as possible. The seat should not be overly reclined to ensure the seatbelt functions effectively. 3. No sharing: Seatbelts should not be placed over fragile items, such as glass (breakable) accessories, and should not press against the skin to avoid injury from broken accessories during seatbelt activation. Additionally, seatbelts should not be shared; each person should use only one seatbelt.
102
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.