What to Do When Water Reaches the Exhaust Pipe?

2 Answers
LeKatherine
07/29/25 5:44am
If water enters the exhaust pipe after driving through a flooded area and the engine stalls, do not attempt to restart it forcefully. Immediately call for roadside assistance and wait for help. Check the electronic systems, remove any accumulated water under the car body, and then remove the spark plugs to drain some of the water from the engine. Have the car towed to an auto repair shop for servicing. If water enters the exhaust pipe, a simple cleaning and drying process will allow the engine to function normally again.
Was this review help?
9
5
Share
VonPeter
08/12/25 9:16am
It's very dangerous when a car is submerged up to the exhaust pipe. I encountered this situation once before and almost ruined the entire engine. At that time, there was heavy rain and deep water accumulation. I tried to move the car, but water got sucked in, and the repairs cost over 8,000 yuan. So if your car is in this situation, immediately turn off the engine and do not start it, as starting it could cause water to flow back into the engine and cause internal damage. Then call a tow truck to have it taken away—never try to push the car or attempt to drive it. At the repair shop, ask the mechanic to check whether the engine oil and air filter have been flooded, and clean the exhaust system if necessary. When driving normally, always check the weather forecast to avoid low-lying areas. After all, flood damage repairs are too costly and time-consuming—safe driving is the most important thing.
Was this review help?
18
5
Share
Expand All
More Forum Discussions

Is flooring the accelerator pedal harmful to the car?

Flooring the accelerator pedal while driving is indeed harmful to the car, as it not only poses extremely high safety risks but also damages the engine. Here are relevant details about flooring the accelerator pedal: 1. Situations where you should not floor the accelerator pedal: At any time, especially when the engine RPM is not very high, flooring the accelerator pedal should be avoided as it can cause engine knocking, leading to sluggish acceleration and increased unburned fuel. 2. Situations where flooring the accelerator pedal is acceptable: Only when the engine RPM reaches 4000 or even 5000, or when the car is approaching its top speed, is it appropriate to floor the accelerator pedal.
19
0
Share

What does 23555r18 tire mean?

23555r18 has the following meanings: 235 indicates the tire's cross-sectional width of 235mm; 55 represents the tire's aspect ratio, which is the percentage of the tire's cross-sectional height divided by its width. A higher value means a thicker tire with lower maneuverability but increased comfort; r stands for the tire type, radial tire, and 18 denotes the rim diameter of 18 inches. Below is related information: Tire lifespan: Since tires have a limited service life, paying attention to the production date is also crucial. The production date is usually found on the outer side of the tire, consisting of four digits. The first two digits indicate the week number, and the last two represent the production year. For example, 3410 means the tire was produced in the 34th week of 2010.
9
4
Share

Is the Anti-Skid Light On or Off?

Whether the anti-skid light is on or off depends on the vehicle's fault condition. Here is an introduction to relevant knowledge about car lights: 1. Function: Car lights are various traffic lights installed on vehicles to ensure safe driving. They are divided into two categories: lighting lights and signal lights. 2. Classification: Headlights, fog lights, reverse lights, license plate lights, dome lights, instrument panel lights, and trunk lights. 3. Notes: Checking car lights is one of the simpler steps in all new car inspection precautions. However, because the installation of car lights is more prone to issues during the overall vehicle installation process, it is also important to take this step seriously during inspection.
14
1
Share

Is a physical examination required for a driver's license test?

A physical examination is required for obtaining a driver's license. The following are the relevant details: 1. Driver's license physical examination items: height, color vision, visual acuity, hearing, upper limbs, lower limbs, torso, and neck. 2. Specific requirements: (1) For large buses, tractors, city buses, large trucks, and trolleybuses, the minimum height requirement is 155 cm. (2) No red-green color blindness. (3) For large buses, tractors, city buses, medium-sized buses, large trucks, trolleybuses, and trams, the naked visual acuity of both eyes must reach 5.0 or above on the logarithmic visual acuity chart.
5
2
Share

What does xle mean?

xle indicates the trim level of a vehicle model, and there are also levels such as le and se. The following is an introduction about license plates: 1. Introduction: License plate is the common name for vehicle registration plates, which are metal or plastic plates attached to the front and rear of a vehicle. 2. Material: The commonly used materials are aluminum, sheet metal, plastic, or paper, with the vehicle's registration number, registration region, or other relevant information engraved on them. 3. Function: License plates serve as a numbering and information registration system for vehicles. Their main purpose is to identify the region to which the vehicle belongs, and the owner and registration details of the vehicle can also be traced through the license plate.
4
3
Share

How Often Should Car Brake Fluid Be Changed?

Car brake fluid should generally be changed every 4-5 years. Below is relevant information about car brake fluid: 1. Function: Brake fluid, also known as hydraulic brake fluid, is an essential part of the braking system. It serves as the liquid medium that transmits brake pressure in hydraulic braking systems, used in vehicles equipped with hydraulic braking systems. Within the braking system, it acts as a force-transmitting medium. Since liquids cannot be compressed, the pressure output from the master cylinder is directly transmitted to the wheel cylinders via the brake fluid. 2. Characteristics: Car brake fluid has a very low freezing point, ensuring good fluidity in low-temperature conditions. It also has an extremely high boiling point, preventing vapor lock in high-temperature conditions. When using car brake fluid, you will notice minimal quality changes, and it does not cause corrosion to metals or rubber.
6
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.