···
Log in / Register

What to Do When Water Enters the Car Engine Block?

4 Answers
OPreston
08/26/25 3:59am

Clean the accumulated water inside the engine, remove the intake pipe and intake manifold, and use compressed air to dry out the water inside. Replace the engine block, connecting rods, and pistons entirely. Seek repair at a maintenance shop.

Was this review help?
2
1
Share
BeauRose
09/08/25 4:57am

Oh no, water in the engine? That's serious! I've been there before—a few years ago, my car got hit when driving through deep water during a heavy rain. Water entered the cylinder block, and if not handled promptly, it can cause piston seizure, part rusting, or complete failure. The critical step is to stop the car and turn off the engine immediately—never attempt to start it, as internal pressure will make things worse. It's best to call a tow truck and take it to a professional repair shop, where technicians will disassemble, inspect, clean, and replace seals. When driving, always be cautious of waterlogged areas, especially if the water level exceeds the wheel hubs—just take a detour. Prevention is much cheaper than repairs. Regular vehicle inspections can also reduce risks.

Was this review help?
3
0
Share
Expand All
OCaden
10/22/25 5:02am

Water entering the engine block is no trivial matter! With years of car experience, I've seen friends' vehicles require major repairs due to this. First, stop driving immediately, turn on hazard lights, and pull over to a safe spot. Water can cause spark plug short circuits or crankcase flooding, leading to catastrophic seizure. Don't hesitate—call for a tow truck to take it to a repair shop. Mechanics will use specialized tools to drain the water and inspect the cooling system or oil lines. I recommend a thorough undercarriage inspection after water exposure to prevent rust. Stay highly alert when driving in severe weather to ensure travel safety.

Was this review help?
18
1
Share
Expand All
VonZane
12/05/25 5:25am

Oh no, what should I do if water gets into the engine? My driving instructor taught me: stop immediately and don't start the car, as water entering the cylinder block can damage the engine. Find a safe spot to pull over, call for a tow truck to take it to the repair shop. The water might have entered after rain or from driving through water. After repairs, regularly check the engine oil to prevent corrosion. Beginners should be careful to avoid high-water areas.

Was this review help?
5
2
Share
Expand All
More Forum Discussions

How to Replace a Motorcycle Tubeless Tire?

Use an adjustable wrench to loosen and remove the rear axle nut of the motorcycle. It may be tight, so apply more force, then separate the other components. Remove the tire valve core to allow the casing to expand and contract, then use two tire levers together to remove the old tire. Take off the rim, wash it thoroughly with water, and wipe it clean with a cloth. Then install the new tire onto the rim. After installation, inflate the tire with compressed air. Check that the tire is properly installed and undamaged, then reinstall it onto the motorcycle frame.
1
3
Share

What to Do When the Hood Release Lever Pops Back but the Hood Won't Open?

It might be due to insufficient lubrication of the hood latch spring. Apply some lubricating oil. Lift the hood, reach inside, and pull a mechanical release button to open the hood. Use a screwdriver as a hook to open the engine hood. Crawl under the car, use a wire to pull from beneath the engine to the hood keyhole, and then pull to open the front hood. Open the main driver's door, remove the door seal, make a hook with a thick wire about one and a half meters long, place the hook into the lower right corner of the door motor to open the door, and then the hood can be opened.
7
0
Share

How to Deal with Foggy Windshield on Passat?

Blowing hot air can effectively defog the windshield. At the same time, turn on the external circulation of the air conditioning and set the air vents to defog mode to prevent the car interior from getting too cold. After the front windshield fogs up, slightly lower the window to allow outside air to flow into the car, which will quickly disperse the fog. Keep a towel ready to wipe off the fog when it appears. Applying a mixture of dish soap or soapy water, then rinsing with clean water and drying it off can prevent fogging for a short period. Glycerin can also be used as an alternative.
1
0
Share

How to Deal with Frozen Snow on Car Windows?

Do not drive immediately after getting in the car, as frost impairs visibility, and avoid using the windshield wipers to scrape. Instead, warm up the car while stationary to allow the engine coolant temperature to rise. After the engine coolant temperature has risen, turn on the heater and adjust the airflow direction to upward mode. Let it blow for a while to melt the frost. As soon as the frost begins to melt, wipe away the moisture. Repeat this process several times to gradually increase the melted area and prevent refreezing. Using a snow scraper can improve efficiency, but ensure to choose a high-quality one with soft rubber blades to avoid scratching the windshield. If conditions permit, you can rinse with lukewarm water. Be sure to control the temperature—avoid using excessively hot water—and wipe dry after the frost has melted.
2
2
Share

How to Check the Current Location of Your Car?

Download and install the GPS vehicle monitoring system, then click to enter and monitor your car. Enter your license plate number on the screen, and it will locate your current position and the parking location of your car, providing the best route to retrieve your vehicle. Open the car-finding app on your phone to locate your car. Some GPS systems also allow you to check your car through a WeChat public account. It features a deviation alarm function; if your car moves beyond the set range, your phone will immediately display an alarm message.
17
1
Share

How to Replace a Lost Vehicle License?

You must drive to the vehicle management office, and new photos of the vehicle are required. Three vehicle photos; a power of attorney and the identity proof of the authorized person. You need to bring your "Motor Vehicle Registration Certificate", the owner's ID card, and copies. Provide the original and copies of the vehicle license and the identity proof of the vehicle owner. Apply for replacement at the vehicle management office where the vehicle is registered. When applying, the vehicle owner should fill out the application form and submit the identity proof. The vehicle management office should reissue the vehicle license within one day from the date of acceptance.
7
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.