What to Do When the Car Won't Start Due to ESC System Failure?

1 Answers
Patricia
07/29/25 1:36pm
The solution for a car not starting due to ESC system failure is: Take the vehicle to a 4S shop or professional repair shop as soon as possible for inspection and troubleshooting of the throttle body and sensors. The reasons for ESC system failure are: 1. ABS pump malfunction; 2. Throttle body contamination; 3. Faulty or dirty speed sensor causing incorrect signal output that triggers the warning light. The working principle of the ESC system is: It judges the driving state based on sensor signals and performs precise control through calculations. When rotation, understeer, or oversteer occurs, it individually controls each wheel to improve vehicle stability.
Was this review help?
16
1
Share
More Forum Discussions

Should the Buick Business Sedan Use 92 or 95 Octane Gasoline?

According to the official vehicle manual recommendation, the Buick Business Sedan should use 95 octane gasoline. In addition to checking the appropriate gasoline grade in the vehicle manual, the Buick Business Sedan can also refer to the fuel cap, which will indicate the recommended octane. Typically, the gasoline grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 octane gasoline, while those with a compression ratio between 10.0-11.5 should use 95 octane gasoline. However, with the application of new technologies, the compression ratio alone cannot determine the required gasoline grade. High compression ratio engines can also be tuned to use lower octane gasoline due to other influencing factors, such as ignition timing, turbocharging technology, and Atkinson cycle technology. Generally, the higher the gasoline octane rating, the higher the octane number and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane. If the Buick Business Sedan occasionally uses the wrong gasoline grade, simply switch back to the correct grade after the current tank is used up. However, long-term use of the wrong gasoline grade may have the following effects: For vehicles recommended to use lower octane gasoline, using higher octane gasoline will not cause damage. However, the increase in octane number may alter the fuel's ignition point, leading to delayed combustion in the engine. This reduces the engine's power output and thermal efficiency, resulting in poorer performance. For vehicles recommended to use higher octane gasoline, using lower octane gasoline may cause engine knocking. Due to the significantly lower octane number, the fuel may ignite prematurely during the compression stroke before the spark plug fires. This premature ignition creates resistance during the upward stroke, causing unstable engine operation. Mild knocking may only increase noise without significant engine damage, but severe knocking indicates serious engine issues, affecting driving stability and causing abnormal wear on pistons and cylinders, potentially leading to cylinder scoring in extreme cases.
1
3
Share

What Causes the Automatic Air Volume Adjustment Failure in Land Rover Freelander 2's Air Conditioning?

Generally, it is due to a blown fuse in the resistor, and replacing it should resolve the issue. Below are the functions of a car's air conditioning system: 1. Temperature Regulation: This is the primary function of a car's air conditioning system. In summer, the cooling system generates cold air to lower the temperature inside the cabin. In winter, except for large commercial vehicles that use independent combustion heaters for heating, most vehicles utilize waste heat from the engine for warmth. 2. Humidity Regulation: Humidity significantly impacts passenger comfort. The humidity inside the cabin should generally be maintained between 30% and 70%. Standard car air conditioning systems do not have the capability to adjust cabin humidity; this can only be achieved through ventilation systems or advanced luxury vehicles equipped with integrated heating and cooling air conditioners. 3. Airflow Regulation: The speed and direction of airflow greatly affect comfort. If air is blowing directly, the speed should be limited to a certain range when the temperature is appropriate. The airflow speed can be adjusted based on passengers' living environment, age, health status, and temperature preferences. 4. Air Purification: The quality of air inside the cabin is crucial for ensuring comfort.
2
3
Share

Is Rainwater Corrosive to Car Surface Paint?

Rainwater is corrosive to car surface paint. Here are the specific details: 1. Nature of Rainwater: Rainwater is weakly acidic. Due to environmental pollution, it cannot be ignored just because it appears clean on the surface. If a car is left wet from rain for a long time without being washed, the concentration of acidic substances in localized areas will tend to increase. As we all know, acidic substances can corrode car paint. The outermost layer of rainwater spreads across the paint surface because the car's surface usually accumulates a thick layer of dust, which turns into mud when it encounters rainwater. Mud can absorb water, so rainwater directly forms a water film on the paint surface. Besides making the car increasingly dirty, this also accelerates the erosion of the car body's paint by acid rain. 2. Rainwater Stains: Many rainwater stains are mostly found on the car's front hood because the engine generates a large amount of heat when the car is running, causing rainwater to evaporate more quickly and leaving watermarks. If the watermarks penetrate deeply, waxing alone may not remove them. In such cases, it is usually necessary to go to a car beauty shop for maintenance, where a surface wax polish is required to address the issue.
3
4
Share

What Causes the Cabin to Overheat?

Causes of cabin overheating: 1. If the cabin's thermal insulation design is poor or the vehicle is old, it can lead to high temperatures; 2. If there is hot air in the cabin, it indicates that the car is set to external air circulation with the airflow directed at the feet. It is normal for engine heat to transfer into the cabin. Additional information: The cabin is a small space, and with people constantly entering and exiting, it is easy for dust to accumulate and bacteria to grow. For health reasons, it is advisable to thoroughly clean the cabin at least once a year. Additionally, the cabin should be ventilated regularly to avoid excessive bacterial contamination.
14
3
Share

What are the length, width, and height dimensions of the Envision?

The new Envision has a length of 4686mm and a wheelbase of 2750mm. Additional information is as follows: 1. Features: The new car is equipped with tire pressure monitoring, rearview camera, cruise control, auto start-stop, panoramic sunroof, keyless entry for all doors, 4.2-inch LCD instrument panel, front seat heating, 8-inch central control screen, support for CarPlay+AndriodAuto, LED daytime running lights, one-touch up/down with anti-pinch for front windows, and automatic dual-zone air conditioning. 2. Interior: The style is sporty, with a well-designed central control layout. The extensive use of straight lines gives the interior a unique look. The three-spoke steering wheel has a simple design with a decent grip, and the single-sided multifunction buttons are driver-friendly. Additionally, the car features a three-circle instrument cluster with good display quality.
8
0
Share

What to Do If There Is No Photo on the Driver's License?

If there is no photo on the driver's license, go to the vehicle management office to replace it. Documents and materials required for obtaining a driver's license: 1. Fill out the motor vehicle driver's license application form; 2. Original and photocopy of the applicant's ID card; 3. Temporary residents also need to prepare the original and photocopy of the temporary residence permit; 4. Three one-inch color photos with a white background and no hat; 5. A physical examination certificate is required. Additional information: 1. Driving school registration time: It takes about half an hour to complete the registration for a motor vehicle driver's license at a driving school. After registration, wait for the driving school's notice for a physical examination. After the physical examination, participate in the study for the motor vehicle driver's license subject one. After meeting the required study hours, take the exam. Other subjects should also be completed in this order. There is no need for a repeat physical examination within six months. 2. Time to obtain a motor vehicle driver's license: Under normal circumstances, it takes about 45 days to obtain a motor vehicle driver's license, with a maximum time limit of three years. This period starts after completing the motor vehicle driver's license subject one exam. If the time limit is exceeded, the qualification for the driver's license exam will be canceled, and no further exams can be taken.
1
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.