What to Do When Brake Pads Are Too Hard and Make Noise?

How to Install Seat Covers for Rear Car Seats?

The steps to install seat covers for rear car seats are: 1. Remove the rear seat headrests and place the backrest covers over the backrests; 2. Secure the top of the seat covers with hooks, and fix the bottom by inserting the seat cushion clips into the gap between the backrest and the seat cushion; 3. Place the seat cushion covers over the rear seat cushions and secure them again by inserting the seat cushion clips into the gap between the backrest and the seat cushion; 4. Reinstall the rear seat headrests and place the headrest covers over them, securing them with buckles. Car seat covers come in various materials such as genuine leather, microfiber leather, synthetic leather, nylon, chemical fiber, artificial fur, polyester wool, etc.

16

0

Share

Is the Driver's License Score Reset at 0:00 or 24:00?

Driver's license score reset can be considered both at 0:00 and 24:00. The demerit point cycle for a driver's license is 12 months. For example, if you obtained your license on March 3rd, the cycle will last until March 2nd of the following year, and the next cycle will start counting from March 3rd. This means the driver's license score reset occurs at 24:00 on March 2nd, which is also 0:00 on March 3rd. Additional information: Score reset date update: The demerit point cycle for a driver's license is 12 months. The reset date starts updating from 0:00 on the date when the license was obtained. At the moment of update, the driver's license enters a new demerit point cycle.

17

5

Share

What to Do When a Car Breaks Down on the Road

When a car breaks down on the road, the response should be tailored to two different scenarios. Below is a detailed introduction to these two situations and their corresponding measures: 1. Occurring on urban or rural roads: When a car breaks down on urban or rural roads, the hazard warning lights should be activated to alert vehicles ahead and behind to slow down. If the vehicle can be moved, it should be promptly moved to the roadside or a location that does not obstruct traffic to prevent secondary accidents. If the vehicle cannot be moved, warning signs should be set up immediately. 2. Occurring on highways: When a car breaks down on a highway, it should be stopped immediately, and the safety of the occupants should be ensured. After stopping the vehicle, occupants should exit the vehicle as quickly as possible from the outer doors. Warning signs should be set up as required, and authorities should be alerted promptly.

13

2

Share

When will the Lynk & Co 03 New Energy be launched?

Lynk & Co 03 will be launched in the fourth quarter of 2019. Below are the specific details about the Lynk & Co 03 New Energy vehicle: 1. Body Dimensions: The vehicle measures 4657mm in length, 1840mm in width, and 1460mm in height, with a wheelbase of 2730mm. The curb weight is 1730kg. 2. Powertrain Configuration: Equipped with a 1.5L turbocharged engine. It delivers a maximum horsepower of 180PS, with maximum torque available between 1500-4000rpm and maximum power at 5000rpm. 3. Suspension Configuration: The front suspension uses a MacPherson strut independent suspension, while the rear suspension employs a multi-link independent suspension.

12

4

Share

What to Do When There Is Ice on the Front Windshield?

The solutions for ice on the front windshield are: 1. Turn on the heating mode and direct the air vents to blow warm air at the icy areas on the windshield; 2. Roll down the windows to let the hot air inside the car dissipate, reducing the temperature difference between the inside and outside of the car, then close the windows; 3. Apply dishwashing liquid to the windshield, and after it dries, wipe it with a dry cloth, which can effectively prevent ice formation for a certain period; 4. Sprinkle windshield washer fluid on the icy areas, as the freezing point of washer fluid is -30 degrees Celsius, and it will melt the ice quickly. The phenomenon of windshield icing is common in winter due to the large temperature difference between the inside and outside of the car and the high humidity outside.

7

3

Share

Is the compulsory traffic insurance the same for 5-seater and 6-seater vehicles?

5-seater and 6-seater vehicles have different compulsory traffic insurance rates. Additional information: 1. Vehicle insurance premiums are calculated separately for each coverage type based on the vehicle category, usage nature, and required insurance types selected by the policyholder. 2. The composition of vehicle damage insurance premium is: Vehicle damage insurance premium = Base premium + Insured amount × Rate (%). 3. Third-party liability insurance charges fixed premiums according to different compensation limit tiers selected based on vehicle category and usage nature. 4. The compulsory traffic insurance has 42 basic rate categories, with different premium rates for eight major vehicle types (family passenger cars, non-commercial buses, commercial buses, non-commercial trucks, commercial trucks, special vehicles, motorcycles, and tractors) and their 42 subcategories. However, the same vehicle model maintains a unified price nationwide.

13

4

Share

What to Do When Brake Pads Are Too Hard and Make Noise?

How to Install Seat Covers for Rear Car Seats?

Is the Driver's License Score Reset at 0:00 or 24:00?

What to Do When a Car Breaks Down on the Road

When will the Lynk & Co 03 New Energy be launched?

What to Do When There Is Ice on the Front Windshield?

Is the compulsory traffic insurance the same for 5-seater and 6-seater vehicles?

What does the auto start-stop in cars mean?

Does a car cover have any impact on the car?

What is the optimal mileage interval for car maintenance?

What is the service life of the EA211 engine?