What to Do If You Can't Make a U-Turn in One Go?

1 Answers
BennettMarie
07/25/25 4:56pm
Master the techniques before taking the test. U-turn techniques are as follows: 1. Technique one: Upon hearing the voice prompt "Please make a U-turn ahead," observe the road traffic conditions on both sides. 2. Technique two: Turn on the left turn signal and keep the steering wheel steady for three seconds. 3. Technique three: Once the entire vehicle enters the area with the yellow dashed line, observe the road traffic conditions on both sides again. The U-turn should be made at the yellow dashed line; do not make the turn over a solid line. 4. Technique four: Ensure safety, then turn the steering wheel fully to the left. 5. Technique five: After entering the straight lane, straighten the steering wheel. The steering wheel should be straightened in time, being careful not to cross the solid line. 6. Technique six: Turn off the left turn signal to complete the U-turn operation. After the vehicle is straightened, turn off the left turn signal, and the U-turn operation is complete.
Was this review help?
8
2
Share
More Forum Discussions

Will I be fined for putting stickers on my car?

Putting stickers on your car can result in a fine. Here are the specific regulations regarding car decals and patterns: 1. Prohibited patterns: According to the 'Road Traffic Safety Law of the People's Republic of China,' motor vehicles are not allowed to spray or use patterns that are exclusive to or similar to those of police cars, fire trucks, ambulances, or engineering rescue vehicles. 2. Requirements for decals: The logos or advertisements sprayed on the car must not affect safe driving, and the area covered by the stickers must not exceed 30%. If the coverage exceeds 30%, you must apply for record-filing with the traffic management department. If the car stickers do not comply with the above regulations, the vehicle will not pass the annual inspection and may also face fines.
16
0
Share

How many kilometers can a car still drive after the fuel light comes on?

After the fuel light comes on, different car models can travel distances ranging from 30km to 135km, with a very large gap. More information about the fuel light coming on is as follows: 1. When the fuel light comes on, especially when it enters the flashing stage, it indicates that the fuel tank is about to be empty. At this time, it is more important to reasonably control the speed, turn off high-power electrical appliances such as the car air conditioner, and reduce fuel consumption during driving. 2. When the vehicle is in a state of low fuel, significant tilting will affect the operation of the fuel pump. In addition to providing power for the vehicle, fuel also has a cooling effect. If the fuel pump operates without being cooled, there is a risk of burning out.
7
5
Share

What engine does the Oshan Kosai use?

This vehicle is equipped with two types of engines: a 1.5-liter turbocharged engine and a 2.0-liter turbocharged engine. The specific details are as follows: 1. The 1.5-liter turbocharged engine delivers 178 horsepower and a maximum torque of 265 Nm. This engine can output maximum power at 5500 rpm and maximum torque at 4500 rpm. It features direct fuel injection technology and uses an aluminum alloy cylinder head and block. This engine is paired with either a 6-speed manual transmission or a 6-speed automatic transmission. 2. The 2.0-liter turbocharged engine produces 233 horsepower and a maximum torque of 360 Nm, achieving maximum power at 5500 rpm. This engine also employs direct fuel injection technology and uses an aluminum alloy cylinder head with a cast iron block. It is matched with an 8-speed automatic transmission.
10
3
Share

How many kilometers can a Fit run on a full tank of gas?

The Honda Fit can run approximately 600 to 700 kilometers on a full tank of gas, with a fuel tank capacity of 40 liters. The Fit is a compact 5-door, 5-seat hatchback with body dimensions of 4109mm in length, 1694mm in width, and 1537mm in height, and a wheelbase of 2530mm. It is equipped with a 1.5L engine and a CVT continuously variable transmission, delivering a maximum power of 96 kilowatts at 6600 rpm and a maximum torque of 155 Newton-meters at 4600 rpm. The Fit features front-wheel drive, with a MacPherson strut independent front suspension and a torsion beam non-independent rear suspension.
4
2
Share

How to Lift Up the Wiper Blades on the Sylphy?

The method to lift up the wiper blades on the Sylphy is: 1. Press the ACC switch to power on the vehicle; 2. Quickly push the wiper switch upward twice; 3. Lift the wipers from the middle position. The Sylphy is a compact 4-door 5-seater sedan with body dimensions of 4631mm in length, 1760mm in width, 1503mm in height, and a wheelbase of 2700mm. It is equipped with a 1.6L naturally aspirated engine and a 5-speed manual transmission, delivering a maximum power of 90 kW and a maximum torque of 155 Nm. The drivetrain is front-wheel drive, with a MacPherson strut front suspension and a torsion beam rear suspension.
20
2
Share

What is the difference between narrowing on both sides and a narrow bridge?

The differences between narrowing on both sides and a narrow bridge are as follows: 1. Different shapes of signs: The sign for a narrowing bridge shows the middle being narrow and both ends wide; while the sign for narrowing on both sides of the road shows the top being narrow and the bottom wide. 2. Different meanings conveyed: A narrowing bridge sign is placed where the bridge width is less than the road width, and the bridge width is less than 6 meters, to warn drivers to pay attention to the narrowing bridge width ahead and drive carefully; narrowing on both sides of the road indicates that the road will narrow ahead, prompting drivers to slow down in advance as the road space will decrease, vehicle density will increase, and the risk of accidents will rise, so it is essential to slow down beforehand.
9
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.