What to do if the Haval F7 cannot start due to a dead battery?

1 Answers
HannahRose
07/30/25 1:43am
Move the assisting vehicle slowly towards the vehicle that cannot start, maintaining an appropriate distance between the two vehicles so that the jumper cables can connect to both car batteries. First, connect the positive terminals of both vehicles. After both positive terminals are securely connected, then connect the negative terminals of both vehicles. The order of connection does not matter. Keep the assisting vehicle running, then attempt to start the vehicle with the dead battery. Do not remove both cables from one battery simultaneously to prevent accidental short circuits. First, remove the negative jumper cables from both vehicles, and finally remove the positive jumper cables.
Was this review help?
6
4
Share
More Forum Discussions

What Causes the RPM of a Single-Cylinder Diesel Engine to Fluctuate?

Air entering the fuel line, leading to poor fuel supply, prolonged use of the fuel injection system, and aging of the fuel injection system, among others. Common causes of unstable diesel idle speed are as follows: 1. Significant air leakage: During idle, excessive cylinder air leakage results in substantial energy loss within the cylinder, leading to lower compression temperatures and pressures, poor fuel atomization, and significant combustion fluctuations. 2. Insufficient fuel supply: At idle, the fuel supply is minimal, and slight variations in fuel supply to each cylinder can cause differences in their operating states. This uneven fuel distribution during idle leads to the diesel engine's idle hunting phenomenon. 3. Low nozzle precision: The direct injection in diesel engines has driven fuel injection pressures to higher levels, especially with the adoption of multi-hole injectors. This makes the nozzle less precise when delivering small fuel quantities, prone to fluctuations. Unstable fuel supply in diesel engines is a major cause of idle instability.
1
2
Share

What are the initial maintenance time and mileage for the BYD Song MAX?

The initial maintenance should be within 3,500 kilometers or 3 months. Below is a related introduction to the BYD Song MAX: 1. Exterior: The Song MAX is the first product featuring the 'Dragon-Face' family front design, with a simple and stylish large-mouth shape. The front features multiple precise horizontal chrome-plated grille strips. The front grille integrates with the central BYD Song logo. The chrome trim connects with the headlights. 2. Interior: The Song MAX is equipped with a 12.8-inch high-definition CarPad, featuring an open intelligent connectivity system that integrates online audio-visual entertainment, exclusive applications, intelligent voice interaction, car-machine connectivity, smart precise navigation, in-car Bluetooth, cloud services, 4G network, in-car WiFi, radio, and more. It offers responsive and precise control, fully connecting people, machine, car, and cloud. 3. Powertrain: The Song MAX is powered by a mature and stable 1.5TI direct-injection turbocharged engine, delivering a maximum power of 113kW and peak torque of 240N.m, equivalent to a 2.4-liter naturally aspirated engine even when fully loaded with passengers.
19
5
Share

How to Drive on Highways with Temporary License Plates?

Temporary license plates can be used on highways as long as they are within the validity period and can be driven in all regions, but relevant documents such as invoices, certificates of conformity, and proof of insurance purchase must be carried. The paper motor vehicle license plate that permits temporary road driving, also known as a temporary driving license plate, is a temporary vehicle driving certificate issued by the vehicle management department of the public security authority before the new vehicle is officially registered. The validity period of a temporary license plate generally does not exceed thirty days. Temporary license plates are divided into four types: temporary license plates within administrative jurisdictions, temporary license plates across administrative jurisdictions, temporary license plates for testing, and temporary license plates for special motor vehicles. The use of temporary license plates is time-limited and regional.
3
5
Share

Arrizo 5 Spark Plug Replacement Tutorial?

Steps for replacing spark plugs in Arrizo 5: Open the hood, lift the plastic cover of the engine, remove the high-voltage distributor wires, and mark each cylinder's position to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. While removing, check for any leaves, dust, or debris externally and ensure thorough cleaning. Place the new spark plug into the spark plug hole, hand-tighten it a few turns, then use the socket to tighten further. Reinstall the removed high-voltage distributor wires according to the firing order, then secure the cover. Spark plug replacement interval: Under normal maintenance conditions, replace every 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine type, so it's recommended to follow the user manual. Refer to the following standards for maintenance replacement: Platinum spark plugs should be replaced at 40,000 km, standard nickel alloy spark plugs at 20,000 km, and iridium spark plugs between 60,000-80,000 km.
15
0
Share

Where is the Equinox's spare tire located?

The Equinox's spare tire is located in the trunk. The spare tire size for the Equinox is 17 inches, and it is a non-full-size spare tire. This type of spare tire has a slightly smaller diameter and width, so it can only be used as a temporary replacement and should only be installed on non-driven wheels. Precautions for using the spare tire: 1. Regularly inspect the spare tire; 2. Do not store oil products with the spare tire; 3. The lifespan of a spare tire is approximately 4 years. In terms of body dimensions, the Equinox measures 4652 mm in length, 1843 mm in width, and 1684 mm in height, with a wheelbase of 2725 mm. For the exterior, the Equinox features a family-style three-dimensional dual grille, hawk-eye automatic full-LED headlights, hawk-eye LED daytime running lights, hawk-feather LED taillights, silver-wing aluminum roof rails, and 18-inch dual five-spoke aluminum alloy wheels.
14
5
Share

Where is the OBD port located on the Peugeot 2008?

The OBD port of the Peugeot 2008 is located inside the cover panel beneath the steering wheel. Simply pull down the cover panel from above by hand, and you will see the black-and-green OBD interface. The computer diagnostic connector, also known as the OBD connector, functions when the diagnostic card is inserted into the PCI slot. OBD, as an abbreviation for a proprietary term, stands for On-Board Diagnostics, which refers to the vehicle's onboard automatic diagnostic system. This system continuously monitors the working conditions of the engine's electronic control system and other functional modules of the vehicle during operation. If any abnormal conditions are detected, it identifies specific faults based on predefined algorithms and stores them as diagnostic trouble codes in the system's memory. The Dongfeng Peugeot 2008 adopts Peugeot's new family design language, featuring a dot-matrix grille with subtle chrome accents, creating a highly three-dimensional and sophisticated appearance. The headlight design draws inspiration from a lion's eye, with an irregular shape that stands out impressively. In terms of body dimensions, the Peugeot 2008 measures 4159mm in length, 1739mm in width, and 1578mm in height, with a wheelbase of 2538mm.
11
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.