
When it rains, promptly turn on the windshield wipers and adjust their speed according to the intensity of the rain to maintain clear visibility. While driving in the rain, control your speed—drive slightly slower than during regular training sessions. During the rainy-day Subject 3 road test, prioritize safety over passing the exam. During the test, avoid sudden acceleration or hard braking, as wet roads are slippery, visibility is reduced, and the tires are prone to skidding. Stay calm and operate the vehicle with caution. Practice courteous driving by slowing down and easing off the accelerator when passing through waterlogged areas with pedestrians or non-motorized vehicles nearby, preventing splashes from affecting them.

During my driving test for Subject 3, it was raining and as a novice driver, I was quite nervous. It was pouring heavily that day, but I took deep breaths and reminded myself not to panic—keeping a steady mindset was key. With poor visibility in the rain, I had to slow down, so I adjusted my speed to around 30 km/h in advance at the test site and took extra care when turning to avoid skidding. I made sure to check the windshield wipers beforehand and didn’t forget to top up the washer fluid before the test. If the windows fogged up, I quickly turned on the fan or AC to defog them. I also kept a greater distance from other vehicles since braking distances increase in the rain, making rear-end collisions more likely. My instructor had advised using low beams only and avoiding high beams to prevent glare. By mastering these details and treating the test like a regular practice session, I passed smoothly. The rainy-day challenge actually helped build my confidence, and after the test, I felt much more self-assured.

Taking the driving test (Subject 3) during heavy rain can indeed be challenging, but I've seen many candidates handle it successfully. Preparation is crucial—check tire traction before heading out to ensure no wear; wiper quality should be good, adjusting speed as needed during the test. Lighting setup is key—always turn on fog lights and width indicators in heavy rain so others can see you clearly. Slow down when turning corners, avoid sharp steering to minimize loss of control risks. When parking, engage the handbrake firmly—examiners won't deduct points for that. Stay calm and focus on road conditions. Remember, safety comes first—prioritize stability in all maneuvers, and the pass rate is actually quite high.

Don't panic during the road test in the rain. Turn on the wipers and check if there's enough water, slow down and control the steering wheel. Turn on the fan or AC to defog and maintain clear visibility. Use low beam lights and drive at a steady speed for safety.

Taking the driving test (Subject 3) in rainy conditions increases risks, requiring heightened focus on safety. I always remind everyone to slow down and drive steadily in wet weather, avoiding sudden braking or sharp turns to prevent wheel skidding. Maintain a greater distance from the vehicle ahead, as slippery roads increase the risk of rear-end collisions. Turn on your lights and use low beams to improve visibility. If fogging occurs during the test, address it promptly by activating the defroster. Don’t worry about taking extra time—stop when necessary and use hazard lights for a temporary break. These measures ensure driving safety, as completing the test smoothly is more important than rushing.

I took the driving test (Subject 3) in heavy rain, and my heart was pounding. But I calmly recalled my training: wipers on full speed, defogger with fan. Drove slowly with automatic low-beam headlights. Took turns even slower, leaving ample braking distance. The examiner didn't make it difficult—instead said passing in rain shows skill. Maintained optimistic mindset, familiarized with test route beforehand for preparedness. Post-test reflection: invaluable experience.


