What speed is considered exceeding the 70 km/h limit?

2 Answers
VonJayden
09/06/25 8:24am
If the speed limit is 70 km/h, any speed above 70 is considered speeding. Exceeding the prescribed speed limit constitutes speeding, and traffic laws stipulate that exceeding the speed limit by more than 10% is a violation. Additional information on speeding from traffic regulations is as follows: 1. Motor vehicles driving on roads must not exceed the maximum speed indicated by speed limit signs. On roads without speed limit signs, a safe speed should be maintained. 2. On roads with two or more motor vehicle lanes in the same direction, the left lane is the fast lane and the right lane is the slow lane. Vehicles in the fast lane should drive at the speed prescribed for the fast lane, and vehicles that cannot reach the prescribed speed of the fast lane should drive in the slow lane.
Was this review help?
11
1
Share
VanSara
09/18/25 7:57am
To be honest, after driving for so many years, I always have to be careful not to go too fast on roads with a 70 km/h speed limit. Generally, exceeding 77 or 80 km/h is considered speeding because many places have a 10% tolerance for speed cameras. If you go over 85 km/h, you're likely to get caught and fined, and may even get penalty points. Speeding is no trivial matter—in an emergency, braking distance increases significantly and reaction time shortens. I once had a friend who got into an accident due to speeding. I recommend keeping your speed under 70 km/h—it saves fuel and is safer, giving you more time to handle unexpected situations.
Was this review help?
14
1
Share
Expand All
More Forum Discussions

How to adjust the time on an older model GL8?

Here are the specific steps to adjust the time on an older model GL8: 1. The older GL8 has a time reset button on the right side, located as a small protruding knob on the dashboard. Press it briefly to switch between time and mileage display. When the time is displayed, press and hold for 3 seconds. 2. Wait until the hour display starts flashing, then press briefly to adjust the hour. 3. Press and hold for 3 seconds again until the minute display flashes, then press briefly to adjust the minutes. 4. Press and hold for 3 seconds once more or do nothing to return to normal time display. 5. The clock on the car dashboard is only an auxiliary function and isn't highly precise. You can adjust it whenever there's a time discrepancy.
19
3
Share

What are the physical examination requirements for a C1 driver's license?

The physical examination requirements for a C1 driver's license are as follows: 1. Height: Applicants for large buses, tractors, city buses, large trucks, and trolleybuses must be at least 155 cm tall. Applicants for medium-sized buses must be at least 150 cm tall. 2. Vision: Applicants for large buses, tractors, city buses, medium-sized buses, large trucks, trolleybuses, or trams must have uncorrected or corrected visual acuity of at least 5.0 on the logarithmic visual acuity chart. Applicants for other vehicle types must have uncorrected or corrected visual acuity of at least 4.9 on the logarithmic visual acuity chart. 3. Color vision: No red-green color blindness. 4. Hearing: Able to distinguish the direction of sound sources with each ear at a distance of 50 cm from a tuning fork.
3
4
Share

What does the BATT indicator on the Honda XR-V dashboard mean?

The BATT indicator on the Honda XR-V dashboard stands for battery. When the BATT light flashes, it indicates that the remote key battery is low. Below are the specific steps to replace the battery in the Honda XR-V key: 1. First, locate the switch on the back of the key fob and pull out the top part to remove the internal metal mechanical key, revealing a small groove. 2. Use a flathead screwdriver or another tool to pry open the key fob cover along the groove. Once a gap appears, you can manually open it. 3. After opening the key fob cover, remove the old battery and replace it with a new one, paying attention to the battery's polarity. 4. Reattach the key fob cover and reinsert the mechanical key.
6
4
Share

Why is there no heating in the car?

There is no heating in the car because there is a problem with the car's cooling system or exhaust fan. The following is how the heating and cooling system works: 1. Cold air: Cold air is formed by compressing the refrigerant to liquefy it and then vaporize it, absorbing a large amount of heat from the air; when the cold air is turned on, the compressor pulley drives the compressor to work, increasing the engine load and consuming a certain amount of fuel. 2. Warm air: Warm air comes from the heat generated by the engine during operation: when the engine's cooling system dissipates heat from the engine, the fan sends the dissipated heat into the car to form warm air; when the warm air is not in use, the fan stops, the warm air outlet closes, and the dissipated heat is completely released into the atmosphere.
17
0
Share

What is the difference between National 5 and National 6 when buying a car?

The differences between National 5 and National 6 when buying a car are as follows: 1. Price difference: National 6 cars are generally more expensive than National 5 cars, mainly because automakers need to comply with policy implementation by submitting applications to relevant departments and conducting various pollution tests, which increases costs and consequently raises the vehicle price. Additionally, National 6 vehicles are equipped with more configurations compared to National 5 to reduce environmental pollution. 2. Access restrictions: With the implementation of the National 6 policy, vehicles that do not meet the emission standards will face certain driving restrictions. Typically, National 5 or below vehicles may be directly prohibited from road use due to non-compliance with emission requirements. Therefore, many National 5 vehicle owners switch to National 6 cars to ensure normal road usage.
16
5
Share

What are the functions of a shark fin antenna?

The functions of a shark fin antenna are: 1. Intercepting and transmitting radio waves; 2. Releasing static electricity; 3. Enhancing signal strength; 4. Overcoming air resistance to prevent vehicle interference; 5. Providing anti-theft functionality. Classification of shark fin antennas: 1. Functional antennas; 2. Decorative antennas. The installation method for a shark fin antenna is: 1. Remove the original car antenna; 2. Secure the antenna spring plate using the screws provided with the shark fin antenna and tighten them; 3. Cover the original car antenna with the shark fin antenna, fix it in position, and mark the location with a pen; 4. Apply glue to the marked position on the car roof, press the shark fin antenna firmly to ensure secure fixation.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.