What speed can be achieved in 4th gear of a car?

3 Answers
DeKarter
07/29/25 5:13am
In a car, 4th gear can achieve speeds above 40 km/h. Below is relevant information about car gears: 1. Speed range: First gear corresponds to speeds of 0-5 km/h, second gear to 5-20 km/h, third gear to 20-40 km/h, fourth gear to 40-60 km/h, and fifth gear to 60-100 km/h. 2. Gear shifting timing: For most cars, the optimal gear shifting occurs when the engine reaches 2000 r/min and should not exceed 2500 r/min. For some high-displacement, high-power engines, shifting can be done around 3000 r/min.
Was this review help?
9
1
Share
DeJustin
08/12/25 6:48pm
I've been driving for over 20 years. Generally, 4th gear can reach 100 to 120 km/h, but it really depends on the car's performance and how you drive it. For small-displacement cars, the upper limit might be around 100 km/h, while larger-displacement cars can easily hit 120 km/h or more. I often use 4th gear on highways, keeping the RPM around 3000 for optimal fuel efficiency. If the RPM goes too high, say over 4000, the car will start shaking, fuel consumption will spike, and it's both unsafe and bad for the engine. Road conditions also affect speed—for example, you might need to downshift when going uphill if the car lacks power. Safety first—I always pay attention to speed limit signs and avoid taking risks just to go faster. For new drivers, I recommend testing your car's sweet spot for fuel efficiency and not pushing it to high speeds unnecessarily.
Was this review help?
6
4
Share
Expand All
DiEmerson
10/03/25 5:45am
The speed in 4th gear can vary quite a bit, generally ranging from 80 to 140 km/h depending on the vehicle's condition. With powerful engines like V6, pushing beyond 120 km/h isn't difficult. Transmission ratio designs differ—some cars prioritize fuel efficiency in 4th gear, making 100 km/h sufficient. I find the tachometer a crucial tool; maintaining 2500 to 3000 RPM is ideal for normal driving. Too low RPM results in insufficient power and higher fuel consumption, while too high increases risk and noise. For testing, find an open road to gradually accelerate and observe the response. From a safety perspective, avoid speeding and adjust according to traffic flow. Reduce speed for changing road conditions like curves to protect your beloved car.
Was this review help?
18
0
Share
Expand All
More Forum Discussions

Do Vehicles Need to Warm Up Before Starting?

Vehicles need to warm up before starting. Below are the relevant details about warming up: 1. Warming-up technique: After starting the car, you will notice the engine speed is around 1200 RPM. After approximately one minute, the speed will drop to around 800 RPM, indicating the warm-up is complete. How long should you warm up the car before driving? Once this signal appears, the car is ready to drive. Otherwise, excessive idling can lead to increased carbon buildup in the engine, which is more damaging than not warming up at all. 2. Precautions for warming up: If the warm-up time is too long, it will cause excessive carbon buildup in the engine. Increased carbon deposits can lead to higher fuel consumption and reduced engine power, so it's important to warm up the car appropriately.
19
3
Share

What to Do When the Cruze Lacks Power and Can't Accelerate?

The reasons why the Cruze lacks power and can't accelerate include clutch slippage, throttle system blockage, engine fuel system issues, etc. Here is an introduction to the reasons why the Cruze lacks power and can't accelerate: 1. Clutch Slippage: Clutch slippage is mainly manifested when the car accelerates during driving, the speed cannot increase with the engine speed, and the engine's power cannot be fully transmitted to the driving wheels, resulting in weak driving force. 2. Throttle System Blockage: For the car's engine to operate, it requires not only fuel but also air; otherwise, the engine cannot run smoothly. The most likely issue with intake is probably due to a clogged air filter or throttle system.
13
5
Share

How to switch driving modes in Mercedes-Benz E300?

Method for switching driving modes in Mercedes-Benz E300: On the driver's right side, there is a dial on the tunnel cover, which is a silver circular knob with buttons on the left side. You can switch between S and C driving modes, and pressing it directly will display the mode on the instrument cluster. E stands for Economy mode; C stands for Comfort mode; S stands for Sport mode, but the basic vehicle stability assistance is the same as in C mode. The Mercedes-Benz E is a mid-to-large luxury sedan under the Mercedes-Benz brand. The dimensions of this car are 4947 mm in length, 1860 mm in width, and 1470 mm in height, with a wheelbase of 2939 mm. The imported version of the Mercedes-Benz E has a standard wheelbase, while the domestically produced models feature a long wheelbase.
5
2
Share

Why does the Sylphy use a foot brake?

The principle of the Sylphy's foot brake is the same as that of a handbrake, with high stability and no malfunctions. Here are the specific details about foot brakes and handbrakes: 1. Usage scenarios: The foot brake is used while the vehicle is in motion; the handbrake is used after the vehicle has stopped. 2. Functions: The foot brake stops or slows down a moving vehicle; the handbrake prevents the vehicle from moving after parking. 3. Classification: Foot brakes are divided into disc and drum-disc types; handbrakes are divided into electronic and mechanical types. 4. Additional information: The foot brake is the vehicle's main brake, where mechanical force from the brake pedal is transmitted hydraulically, and the hydraulic pressure of the brake fluid is transferred through pipelines to the brake disc actuator. The handbrake is an auxiliary brake, with a steel cable connected to the rear brake shoes to apply braking force to the vehicle.
4
5
Share

Where to Check Tire Pressure for Geely Borui?

For Geely Borui, during driving, press the right button on the dashboard to display the tire pressure. According to the international GBT2978-2008 standard requirements, the recommended tire pressures for different tires are as follows: Standard tires: 2.4-2.5bar; Reinforced tires: 2.8-2.9bar; Maximum pressure: should not exceed 3.5bar. In summer, the tire pressure should generally be set at the lower limit of the standard tire pressure. For example, the lower limit for standard tires is 2.4bar. If the car is often parked outdoors, the pressure can be about 0.1bar lower than standard to prevent high-temperature blowouts. In winter, the tire pressure should follow the standard tire pressure principle, and can be appropriately increased by about 0.2bar.
7
5
Share

What are the methods for remote car starting?

Methods for remote car starting: 1. Aim the key at the vehicle and press the lock button on the key, then hold the remote start button on the key for at least 4 seconds within 5 seconds; 2. The parking lights will illuminate until the vehicle's turn signals flash and remain on while the engine is running. After entering the vehicle during a single remote start session, press the brake pedal and turn the ignition switch to ON and RUN (open and run) to drive the vehicle. The car's smart keyless entry system, abbreviated as PKE, utilizes the world's advanced RFID radio frequency technology and an advanced vehicle identity coding recognition system. It employs a miniaturized, low-power RF antenna development solution and successfully integrates the remote control system with the keyless system, maintaining traditional vehicle circuit protection to achieve a dual RF system and dual anti-theft protection.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.