···
Log in / Register

What is the Safety and Civilization Knowledge Test in Subject 3?

6Answers
ChaseAnn
07/29/2025, 04:55:20 AM

Safety and Civilization Knowledge Test is a branch of Subject 3, which includes road driving skills and safety and civilization driving knowledge test. The Safety and Civilization Knowledge Test is commonly referred to as "Subject 4", but in fact, there is no "Subject 4". Here are the relevant introductions: 1. The main contents include: safety and civilization driving operation requirements, safe driving knowledge under bad weather and complex road conditions, emergency handling methods in case of tire blowout and other emergencies, and knowledge of handling after traffic accidents. 2. Score requirements: The full score is 100 points, and a score of 90 points is qualified. All subjects are the same, take the test once, if you fail the test, you can retake it once. If you do not take the retest or still fail the retest, the test will be terminated, and the applicant should make an appointment for the test again.

Was this review help?
111
Share
LaWalter
08/12/2025, 03:30:39 AM

I just passed the Subject 3 test. The safety and civilized driving knowledge refers to those key points about safe and courteous driving learned during the exam, such as recognizing traffic signs and signals, maintaining safe following distance, yielding to pedestrians, avoiding drunk or fatigued driving, and handling emergencies like not jerking the steering wheel during a tire blowout. These basics are crucial for actual road driving to prevent accidents. During my test, I was asked many questions, such as how to use lights in rainy/foggy conditions and overtaking rules on highways. It's essential to memorize the textbook content during revision, as examiners pay close attention to this. Developing these habits in daily driving is also necessary—otherwise, accidents can still happen even after passing the test. In short, this section ensures everyone understands the rules and practices civility to make roads safer.

Was this review help?
14
Share
Expand All
VonSebastian
10/05/2025, 10:30:04 PM

Having driven for several years, I believe that safe and civilized driving knowledge is the basic ethics and rules that must be followed in daily driving. Every time I hit the road, I remind myself to stay in my lane, yield to pedestrians at crosswalks, and not run red lights, especially in crowded urban areas where extra caution is needed. The purpose of testing this in the third driving exam is to ensure drivers develop good habits from the start, rather than regretting only after an accident occurs. I've seen many novices get into trouble due to ignorance of these basics, such as speeding and rear-ending or using phones while driving. In real life, driving civilly also sets a good example for family, teaching children about road safety. In short, learning these principles has made me more mindful of staying calm, being aware of my surroundings, and taking responsibility for both my own and others' safety.

Was this review help?
13
Share
Expand All
LeCaroline
11/18/2025, 10:57:33 PM

When teaching driving, I always emphasize the core of safety and civilized driving knowledge: obeying traffic rules is the top priority, such as controlling speed within the limit, being aware of blind spots, and stopping at red lights while going at green lights; civilized driving means being polite, like yielding the emergency lane and not honking unnecessarily. Key exam points include accident handling knowledge, such as not moving the car after a rear-end collision and calling the police directly. These points aren't about rote memorization but require practice in real road conditions. Beginners often forget details like turning on fog lights in foggy weather. During lessons, I add practical tips, such as checking the dashboard for speeding. In short, even after passing the test, you must always comply, or your driver's license is just a piece of paper.

Was this review help?
9
Share
Expand All
Davis
01/09/2026, 12:34:32 AM

I love driving, and for me, safety and civilized driving knowledge are the foundation of enjoying the journey. It's not just exam material but daily driving habits, like maintaining a safe distance to avoid rear-end collisions, yielding to pedestrians at crosswalks, and staying alert on highways. In case of emergencies like a flat tire while driving, remember to steady the steering wheel and avoid sudden braking. Be civilized—for example, refrain from smoking in the car to avoid affecting others, and yield at intersections instead of cutting in. In practice, these principles can reduce traffic jams and conflicts, making driving more enjoyable for everyone. I also love traveling, and understanding these basics has made my trips much smoother. In short, safe driving is not just about rules—it reflects one's character.

Was this review help?
4
Share
Expand All
DelNathan
04/05/2026, 10:48:41 PM

As a parent, I believe that safety and civilized driving knowledge are essential for protecting the safety of family members and children while driving. This includes obeying traffic signals at intersections, giving priority to pedestrians, properly securing child seats, and driving slowly without speeding in rainy weather. Testing these aspects in the third driving test is about cultivating a sense of responsibility, not taking risks just to save time. I often remind my children to sit in the back seat and fasten their seat belts, teaching them to recognize road hazards. In practical terms, civilized behaviors like not parking haphazardly and blocking pedestrian pathways can create a harmonious traffic environment. In short, mastering this knowledge makes driving much more reassuring and family trips more pleasant.

Was this review help?
20
Share
Expand All
More Q&A

At what test value does a car battery need replacement?

A standard 12V battery has a resting voltage range of 10.6-14.3V. If the resting voltage falls within this range but drops below 10V under load, replacement is required. Most batteries convert chemical energy into electrical energy, and the voltage generated by this chemical reaction is fixed and cannot be altered. Below are car battery maintenance tips: 1. Avoid prolonged vehicle inactivity: Batteries installed in vehicles self-discharge over time, so it's advisable to drive the car at least once a week for a minimum of 20 minutes to allow the alternator to recharge the battery. 2. Close windows before turning off the engine: Power windows and sunroofs rely on battery power, so close all windows before shutting down the engine rather than after, or using the long-press lock button method post-departure. 3. Maintain battery cleanliness: Regular inspections effectively extend battery life. Use a professional battery terminal brush or old toothbrush to remove dust and corrosion from positive and negative terminals. Apply petroleum jelly or grease to contact surfaces to form a protective film.
109
Share

What is the difference between broad-sense passenger vehicles and narrow-sense passenger vehicles?

The differences between broad-sense passenger vehicles and narrow-sense passenger vehicles are as follows: 1. Micro buses: Micro buses refer to mini passenger vehicles, commonly known as minivans. Minivans typically have small engine displacements, usually no more than 1.5L, and use a mid-engine layout, meaning the engine is located under the seats, with rear-wheel drive. This is because they need to consider load capacity; when going uphill, the center of gravity shifts backward, reducing front-wheel traction, necessitating rear-wheel drive. 2. Commercial buses: If passenger vehicle sales statistics include minivans, their purchasing guidance significance is relatively weak. In reality, modern minivans are more commercially oriented. However, since they have fewer than 9 seats and are passenger vehicles, they are classified as passenger vehicles. To distinguish them from traditional passenger vehicles, they are categorized under broad-sense passenger vehicles. Passenger vehicles with 9 seats or fewer, excluding minivans, are all classified as narrow-sense passenger vehicles.
105
Share

What gear should be used when going up a steep slope?

The gear used when a car is going uphill is related to both the vehicle speed and the gradient of the slope. For steep slopes, a lower gear such as 2nd or 3rd should be selected. Vehicles with large displacement can also use 3rd gear with increased throttle to climb, while smaller displacement vehicles should use 2nd gear to ensure sufficient traction. The following are precautions for driving uphill: 1. Note 1: Maintain sufficient engine power to ensure the vehicle climbs smoothly. Always monitor the coolant temperature gauge to prevent the engine from overheating. 2. Note 2: When starting, firmly engage the handbrake and slowly release the clutch to the engagement point. Hold the clutch steady at this point, release the handbrake, and the vehicle will not roll backward. 3. Note 3: When starting uphill, due to greater resistance, the clutch should be held steady for 3-4 seconds longer than on flat ground. Do not release the clutch immediately after releasing the handbrake; instead, apply throttle immediately. After the vehicle moves slowly for 3-4 meters, gradually release the clutch to ensure a smooth start without stalling. 4. Note 4: When releasing the handbrake during an uphill start, immediately apply throttle to bring the engine speed to around 1500 RPM. This ensures sufficient power for a smooth start without shaking. 5. Note 5: Choose the appropriate gear based on the slope, ensuring the engine sound does not indicate strain. Avoid shifting gears if possible, and watch for oncoming traffic. Adjust gears based on speed as you gain experience. 6. Note 6: When approaching the top of the slope, be cautious of oncoming vehicles or pedestrians to prevent accidents, as visibility may be limited at this point.
101
Share

Should the last high beam light in Subject 3 be turned off?

The last high beam light in Subject 3 needs to be turned off. Here is a brief introduction about Subject 3: 1. Basic Information: Subject 3 includes the road driving skills test and the safety and civilized driving knowledge test. It is part of the motor vehicle driver's license assessment and is the abbreviation for the road driving skills and safety and civilized driving knowledge test subjects in the motor vehicle driver's test. The content of the road driving skills test varies for different types of vehicles. 2. Test Content: The road driving skills test generally includes preparation before getting on the car, simulated lighting test, starting, driving in a straight line, shifting gears, changing lanes, parking by the side of the road, going straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school zones, passing bus stops, meeting oncoming vehicles, overtaking, making U-turns, and night driving.
119
Share

What does Volkswagen's indirect tire pressure monitoring mean?

Volkswagen's indirect tire pressure monitoring uses the wheel speed sensors of the car's ABS system to compare the rotational speed differences between tires for monitoring tire pressure. Below is relevant information: 1. Working principle: The tire pressure monitoring system utilizes the sensing function of ABS to compare the rotation counts of tires. Insufficient tire pressure shortens the tire's circumference, causing the rotation count to differ from other tires during driving. 2. Tire pressure warning: The tire pressure monitoring alerts based on speed comparison by wheel speed sensors. Tire pressure can be checked with a pressure gauge. During driving, the tire pressure loss display monitors the inflation pressure of tires. If the inflation pressure in a tire is significantly lower than others, the system will issue a warning. When the internal tire pressure decreases, the working radius of the wheel changes accordingly, altering the wheel's rotational speed.
101
Share

What does the red color on a car battery indicate?

The red battery indicator light refers to the battery status indicator, which remains constantly lit when the engine is not running. Under normal circumstances, the battery status indicator should automatically turn off once the engine is started. If the battery status indicator remains lit after the engine is started, it indicates a problem with the battery that requires inspection and repair. The solutions include: checking whether the battery terminals are oxidized. If oxidation is present, it needs to be cleaned and polished before reinstalling and testing, as oxidation may hinder battery charging. Additionally, check for any signs of looseness in the battery's positive and negative cables. It is advisable to first inspect the battery itself and the generator's output. If the results are normal, then check for any short circuits or disconnections in the wiring. Reasons for the red battery indicator on the dashboard include: loose or slipping generator belt; insufficient generator output; damaged battery; faulty generator rectifier bridge leading to uncontrolled generator output voltage; broken generator belt, damaged generator, or broken positive/negative cables. Furthermore, electrical device cross-connections can also cause the indicator light to illuminate, though the brightness may not be very strong.
115
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.