What license will be downgraded to if 12 points are deducted from a B1B2 driver's license?

1 Answers
DanielAnn
07/29/25 2:05pm
It will be downgraded to a Class C license. Here are the relevant details: B1 driver's license: The permitted vehicle types for a B1 license are medium-sized passenger vehicles, defined as those not exceeding 6 meters in length, with a rated passenger capacity of 10 (inclusive) to 19 (inclusive) persons. Other permitted vehicle types include C1 (small cars), C2 (small automatic transmission cars), C3 (low-speed trucks), C4 (three-wheeled cars), and M (wheeled self-propelled machinery). It is important to note that B2 is not included in the permitted vehicle types for a B1 license. If a holder of a B1 license wishes to drive large trucks, they can upgrade their license to a B1B2 license (or A1, A2, A1A2, etc.). B2 driver's license: The permitted vehicle types for a B2 license are heavy-duty, medium-duty trucks or large, heavy, and medium-duty special-purpose vehicles. Heavy-duty and medium-duty trucks are mostly trucks, such as the large trucks commonly seen on the road carrying construction waste, which fall under the category of heavy-duty trucks. Large, heavy, and medium-duty special-purpose vehicles refer to vehicles equipped with special equipment or devices, such as water sprinklers, concrete mixers, fire trucks, etc. Other permitted vehicle types for a B2 license include C1 (small cars), C2 (small automatic transmission cars), C3 (low-speed trucks), C4 (three-wheeled cars), and M (wheeled self-propelled machinery), which is the same as the B1 license.
Was this review help?
15
0
Share
More Forum Discussions

What is the normal water temperature for the New Generation Transit?

New Generation Transit's normal water temperature is 90 degrees. Normal water temperature: Water temperature refers to the coolant temperature. After the engine warms up, it typically displays 70-90 degrees as normal. When the coolant level in the radiator is low, the water temperature will rise, and it's necessary to add water at this point. If the temperature gauge approaches the H mark or the red danger zone, or if the coolant warning light illuminates in severe cases, it indicates that the engine coolant temperature is too high. Working principle: The water temperature gauge sensor is a thermistor-type sensor fixed with threads on the engine's coolant passage. The thermistor determines the current flowing through the coil winding of the water temperature gauge, thereby driving the gauge needle to swing.
19
5
Share

Where is the toolbox located in the BMW X1?

The toolbox is located in the trunk. Essential items for a family car include a first aid kit, fire extinguisher, toolbox, and tire pressure gauge. Fire Extinguisher: Many cars nowadays come with a fire extinguisher in the trunk, but some do not. This item is crucial in case of an accident. Toolbox: The toolbox is used for car repairs. If the vehicle has a major malfunction, the toolbox may not be of much use, but for minor issues like changing a tire, it comes in handy. Tire Pressure Gauge: Many people check their tire pressure only during car maintenance. However, it's important to monitor tire pressure regularly, especially during winter and summer. It's best to check it at least once a week.
5
3
Share

What Causes the Reversing Camera Distortion in BMW X2?

BMW X2 reversing camera distortion can be caused by camera malfunction, power disconnection, display settings issues, or wiring problems. Below are the specific reasons for BMW X2 reversing camera distortion: Camera Malfunction: The camera may have issues, with internal components damaged, requiring the purchase of a new camera. Power Disconnection: The power supply to the camera may be loose or disconnected. Simply reinserting and securing the power plug can resolve this issue. Wiring Problems: This is the most common issue. Since the wiring harness for the reversing camera runs from the dashboard all the way to the trunk, the lengthy route makes it likely for a section of the wiring harness or a connector to have poor contact, necessitating a thorough inspection.
16
1
Share

How Often Should the Battery of the Equinox Be Replaced?

The battery has a service life of approximately 2 to 5 years, with a general recommendation of 3 years. Battery Replacement Cycle: The battery plays a crucial role in the operation of a vehicle. If it fails to supply power properly, the engine may malfunction or stall. Typically, the battery in a car should be replaced every 2 years or so, but with proper maintenance, it can last up to 4 years. Battery Replacement Method: Place the new battery in the same location where the old one was removed. Connect the positive and negative cables to the correct sides. Tighten all screws, clamps, or rods securing the battery. Reconnect the positive terminal and tighten the clamp with a wrench. Reconnect the negative terminal and tighten the clamp with a wrench. Apply lithium-based battery grease—spray lithium-based grease on the terminals to prevent corrosion. Close the hood—securely shut the hood and start the car. Check that all electronic devices are functioning normally.
15
5
Share

Where to Check the Mileage on Audi A6?

Audi A6 mileage can be checked on the dashboard. Definition of Mileage: The car's mileage starts counting from zero when it leaves the factory, and there are at least two mileage readings. One is the total mileage, which represents the total distance traveled from the factory to the present. It will always increase regardless of the environment and will not decrease. The other is the trip mileage, which can be reset during the journey. Many car owners use the trip mileage to calculate how far a full tank of fuel can travel. Precautions: Different fuel types can result in different fuel consumption performances. Generally, vehicles that use 95-octane gasoline may show better fuel efficiency when using 98-octane gasoline. This is because higher-octane fuel can provide better engine performance. If you notice that your fuel consumption has decreased from 8 liters per 100 kilometers to 7 liters, it might be due to the use of higher-octane gasoline.
8
1
Share

What is the normal tire pressure for the Bestune B70?

The normal tire pressure for the Bestune B70 is 2.3-2.5 bar. Tire pressure, strictly speaking, refers to the air pressure inside the tire. Hazards of over-inflation: Reduced friction and adhesion of the tire, affecting braking performance; causes steering wheel vibration and deviation, reducing driving comfort; accelerates wear on the central tread pattern of the tire, shortening its lifespan; increases body vibration, indirectly affecting the lifespan of other components. Decreased puncture resistance. When encountering sharp objects like nails or glass on the road, they can easily penetrate the tire, causing internal cracks and blowouts, leading to tire bursts. Hazards of under-inflation: Increases the friction coefficient with the road surface, leading to higher fuel consumption; causes heavy steering and deviation, posing risks to driving safety; increases movement in various parts of the tire, leading to excessive rolling and abnormal heat generation; reduces the functionality of the cords and rubber, causing delamination or cord breakage and excessive friction with the rim, resulting in damage to the bead area and abnormal wear.
4
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.