What license does an A2 driver's license downgrade to at age 60?

1 Answers
MacEmma
07/28/25 4:10pm
A2 driver's license downgrades to C1 license at age 60. Here are the specific details: 1. Overview: According to the regulations on the application and use of motor vehicle driver's licenses, the downgrade age for an A2 driver's license is 60 years old, applicable to both men and women. They must go to the vehicle management office where the driver's license was issued to exchange it for a motor vehicle driver's license that permits driving small cars or small automatic transmission cars. 2. Laws and regulations: Individuals aged 60 or above are not allowed to drive large buses, tractors, city buses, medium-sized buses, large trucks, trolleybuses, and trams; those holding a driver's license for large buses, tractors, city buses, medium-sized buses, or large trucks must go to the vehicle management office where the driver's license was issued to exchange it for a motor vehicle driver's license that permits driving small cars or small automatic transmission cars.
Was this review help?
13
2
Share
More Forum Discussions

What is the best amount of oil to add to a motorcycle?

For most common domestic motorcycles below 150CC, the oil capacity is generally no more than one liter. It is absolutely essential not to overfill the motorcycle with oil. The correct oil level should be checked using the oil dipstick or oil inspection window. Below is additional information about motorcycle oil: 1. When adding oil to the engine, the oil level should be between the upper and lower limits on the dipstick. If too much oil is added, the oil volume will expand as the engine temperature rises, increasing the pressure in the oil chamber and the running resistance. This can lead to reduced engine power and increased fuel consumption. 2. Overfilling the oil can cause oil to leak through the crankcase vent pipe due to increased crankcase pressure. The oil pressure may also loosen the oil seals, resulting in oil leaks. 3. Excessive oil can affect engine cooling, leading to high engine temperatures, insufficient power, oil leaks, blue smoke from the engine, and issues such as clutch disengagement failure.
4
3
Share

Is the Three-Way Catalytic Cleaner Useful?

Three-way catalytic cleaner is useful. The three-way catalytic cleaner is a transparent liquid used to clean the surface complexes of the three-way catalytic converter in motor vehicles. Below is an introduction to the cleaning steps of the three-way catalytic cleaner: 1. Start the vehicle for preheating and connect the hanging tube to the three-way catalytic cleaner. 2. Insert the device into the vacuum tube connected to the engine. 3. Start the engine, open the device control valve, and allow the three-way catalytic cleaner to drip in the viewing window. 4. Keep the engine idling until the cleaner is completely dripped. 5. After cleaning, turn off the engine and reconnect the pipelines. 6. Let the engine idle to discharge any remaining liquid.
13
2
Share

What procedures are required to purchase an imported car?

Here is an introduction to the procedures for purchasing an imported car: 1. Documents required for purchase: Individuals need to provide a household registration book or ID card, while companies need to provide an enterprise code certificate. 2. Payment and vehicle pickup: (1) The user must go to the traffic police department to obtain a vehicle movement permit or temporary license plate, then proceed to the sales unit to pay the agreed price. This includes the sales unit price fee, warehouse release fee, or transportation fee. Payment can be made in cash, by check, or by bank draft. (2) After receiving the payment, the sales unit issues a sales invoice and a warehouse release or transportation fee receipt. (3) The user picks up the vehicle at the agreed time and simultaneously receives the sales invoice; warehouse release or transportation fee receipt; certificate of import for goods; and commodity inspection certificate.
1
2
Share

How to Use OBD in a Sedan?

OBD, also known as On-Board Diagnostics, is actually very compact and plug-and-play, requiring no complex wiring or installation, making it very user-friendly. Additional information: 1. OBD can monitor the engine's electronic control system and the working conditions of other functional modules of the vehicle during operation. Through OBD, you can check the vehicle's status in real-time, including the vehicle's past driving trajectory, fuel consumption-to-mileage ratio, and also standardize the driver's behavior to enhance safe driving. 2. The OBD interface cannot be directly connected to a computer; it requires a 'gateway' device. Locate the vehicle's OBD interface, plug the OBD-II connector into the vehicle's interface, and connect the other end to the computer's USB port. Install the corresponding software on the computer, ensure the device and drivers are properly installed, then open the software. Select the appropriate device type, click 'Open Device', choose 'Work Mode', select 'Baud Rate', click 'OK', and you can read information such as vehicle speed, RPM, and coolant temperature.
12
5
Share

Where to Install the ETC Tag?

The ETC installation position is generally in the upper middle part of the front windshield, while for large vehicles such as trucks and buses, the installation position is in the lower middle part. The suitable installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with built-in or later-added explosion-proof film, which may affect the signal transmission of the microwave communication link, it should be installed in the microwave sunroof strip. ETC stands for Electronic-Toll-Collection, meaning electronic toll collection system. To apply, you need to provide the original and photocopy of the vehicle owner's valid ID and vehicle registration certificate. If the application is not made by the owner, the agent's valid ID is also required. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also needed, and the vehicle must be registered under an individual aged between 18 and 60. For company vehicles, the required documents are: An introduction letter from the vehicle owner (with official seal); a photocopy of the organization code certificate or business license (with official seal); the original ID of the agent; the original vehicle registration certificate; and the vehicle that needs to apply for ETC. Here are the precautions for installing ETC: Do not block the view; it is best to install it behind the rearview mirror: Many car models have a large rearward tilt angle of the windshield, which reduces the driver's field of vision. If this is not considered during ETC installation, it will increase the driver's blind spot. Installing it behind the rearview mirror on the right side can avoid blocking the view. Do not affect charging: The ETC electronic tag consumes power, but generally does not need to be charged or have its battery replaced, as there is a solar panel on its back that can charge itself. Therefore, during installation, avoid the black areas on the windshield and do not place it where the solar panel might be blocked. Once installed, do not remove it casually: The button in the middle of the adhesive is an anti-removal lever, connected to a switch below. After the electronic tag is installed, the windshield will press the anti-removal lever in. If it is removed casually, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You will then need to go to an ETC service point to unlock it. This is designed to prevent multiple vehicles from sharing one device.
10
2
Share

Is it illegal to modify car headlights?

Modifying car headlights is illegal. Additional information: 1. Article 97 of the 'Road Traffic Safety Law of the People's Republic of China' stipulates that the wattage of headlights must not exceed 60W. 2. For the unauthorized installation of xenon headlights, according to Article 90 of the 'Road Traffic Safety Law', it is considered an unauthorized modification violating vehicle safety principles, punishable by a fine of 200 yuan and 3 penalty points. 3. If the original halogen headlights are replaced with xenon headlights, in accordance with the relevant provisions of the 'Road Traffic Safety Law', a fine ranging from 500 to 2000 yuan will be imposed. Therefore, car owners must comply with these regulations when upgrading bulbs; otherwise, they will face penalties from traffic police.
6
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.