What is the trunk size of the Wuling Hongguang S3?

1 Answers
VictoriaRose
07/29/25 3:21pm
The trunk of the Wuling Hongguang S3 has a depth of 470mm and a width of 1150mm. This model is equipped with two types of engines: 1. A 1.5-liter naturally aspirated engine. This engine delivers 99 horsepower and a maximum torque of 140 Nm, with the peak torque achieved between 3400 to 4400 rpm. It features DVVT technology and multi-point fuel injection, and uses an aluminum cylinder head with a cast iron cylinder block. This engine is paired with a 6-speed manual transmission. 2. A 1.5-liter turbocharged engine. This engine produces 147 horsepower and a maximum torque of 250 Nm, with the peak torque achieved between 2200 to 3400 rpm. It also features multi-point fuel injection and uses an aluminum cylinder head with a cast iron cylinder block. This engine is paired with a 6-speed manual transmission.
Was this review help?
11
3
Share
More Forum Discussions

What Causes the Temperature Gauge to Stop Moving?

The reasons for the temperature gauge not moving are as follows: 1. Wiring issues: The power wire of the temperature gauge is broken, the heating coil of the temperature gauge is burnt out, or the heating coil of the temperature gauge sensor is burnt out or the contact is poor. The wiring of the temperature gauge sensor is loose or broken. The voltage regulator supplying stable power to the temperature gauge circuit is damaged. 2. Thermostat: Check if the heater is blowing hot air. Then feel if the temperatures of the upper and lower radiator hoses are the same. It is recommended to check if there is a thermostat. After confirming there are no issues with the thermostat, consider the sensor, wiring, and temperature gauge. It is likely that the thermostat is damaged, remaining in the open position, causing the coolant to continuously circulate in a large loop.
11
0
Share

How to Check Vehicle Highway Travel Records?

Vehicle entry and exit information on highways can be queried through the highway toll collection system. Here are some key points to note when entering the highway: 1. Check if the vehicle is safe: Before driving on the highway, you should inspect your vehicle for any potential safety hazards. For example, check if the four tires have any cracks, bulges, or if the tire pressure is normal. Also, check if the brake fluid, antifreeze, engine oil, etc., in the engine compartment are insufficient. 2. Check the lights: Verify if your vehicle's lights are functioning properly, as noise levels are very high when driving at high speeds on the highway. If you need to communicate any information to drivers ahead or behind you, it must be done through the lights, as honking the horn is ineffective and almost inaudible to others.
6
1
Share

Is waxing a car useful in winter?

Regularly polishing and waxing the car body can effectively resist ultraviolet rays and provide protection against sun exposure in winter. Here are some relevant information about waxing in winter: 1. In northern regions, the winter is cold and dry, and cars are inevitably exposed to snow, ice, and sandstorms, which can cause the car paint to become matte prematurely. Frequent washing and timely waxing can effectively protect against acid snow and resist corrosion. 2. In winter, due to the large-scale burning of coal, substances like sulfur dioxide in the air increase, and with thick cloud cover, these substances are not easily dispersed into the atmosphere. Additionally, winter itself has less rainfall, and prolonged dryness leads to an increase in dust and haze in the air, making the rain more acidic. As a result, car body maintenance becomes particularly important in winter. 3. During winter, the freezing temperatures reduce the frequency of car washing, making waxing in early winter the best strategy for maintaining the car paint. Moreover, a waxed car body is less likely to retain water, reducing the chance of ice formation. 4. Before waxing, use car wash water to clean the dirt and dust on the car body. Avoid blindly using dish soap or soapy water, as the sodium chloride content can erode the car paint, wax film, and rubber parts, causing the paint to lose its luster and the rubber parts to age. 5. If there is no dedicated car wash water, you can use clean water to wash the car, dry the body, and then use a polishing and waxing machine for waxing. Consistent car paint maintenance is necessary to achieve better care results.
2
2
Share

How to Handle a Car Accident When the Vehicle Was Not Parked in a Designated Spot?

If a car that was not parked in a designated spot is involved in an accident, the situation should be reported to the police. The traffic police will determine liability based on the on-site conditions, and compensation will be provided according to the liability determination certificate issued by the police. The specific amount involved will depend on the actual circumstances. The traffic management department of the public security authority will determine the liability of the parties involved based on their actions and the severity of their faults in causing the road traffic accident. The details are as follows: 1. If the accident is caused solely by the fault of one party, that party bears full responsibility. 2. If the accident is caused by the faults of two or more parties, each party will bear primary, equal, or secondary responsibility based on their actions and the severity of their faults. 3. If no party is at fault for the accident, it is considered a traffic accident, and no party bears responsibility. If one party intentionally causes the accident, the other party is not responsible.
14
4
Share

What are the installation requirements for a new energy home charging station?

There are several conditions for installing a new energy home charging station: 1. Whether installation conditions are met: For example, whether there is a fixed parking space, whether it can be connected to the national grid's power lines, etc. 2. Understand the power supply attributes of the residential area: If the charging station is powered by ordinary residential electricity, users need to apply to the national grid for power supply box wiring first. After approval, the national grid will arrange for staff to install the wiring. If using commercial electricity within the residential area, the process is simpler, and you can directly negotiate with the property management for power supply. 3. Understand the types of charging stations: Generally, the type of charging station to be installed needs to be determined based on the installation conditions of your home charging station. Currently, home charging stations are roughly divided into wall-mounted and post-mounted types. The advantage of wall-mounted charging stations is that they save space and are cheaper, but they can only be installed on walls where wiring is possible. Although post-mounted charging stations occupy relatively more space and are more expensive, they have fewer limitations on installation locations.
10
5
Share

How to Conduct Annual Vehicle Inspection for Cars Within 10 Years?

For passenger cars within 10 years, an annual inspection is required; for those over 15 years, inspection is required every 6 months. Below is the relevant information: 1. Commercial passenger vehicles and trucks: Commercial passenger vehicles within 5 years require an annual inspection; those over 5 years require inspection every 6 months; trucks and large or medium-sized non-commercial passenger vehicles within 10 years require an annual inspection; those over 10 years require inspection every 6 months. 2. Small and mini non-commercial passenger vehicles: Small and mini non-commercial passenger vehicles within 6 years require inspection every 2 years; those over 6 years require an annual inspection; those over 15 years require inspection every 6 months; motorcycles within 4 years require inspection every 2 years; those over 4 years require an annual inspection.
12
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.