What is the trunk capacity of the Hongqi E-HS3?

2 Answers
DelAlana
07/24/25 5:50am
The trunk capacity of the Hongqi E-HS3 is approximately 500 liters. Below is a detailed introduction to the Hongqi E-HS3: 1. The trunk capacity of the Hongqi E-HS3 is approximately 500 liters. If the rear seats are folded down, the trunk capacity will be even larger, making it perfectly suitable for daily use. 2. The Hongqi E-HS3 features mesh pockets and storage compartments on both sides of the trunk, allowing for more items to be loaded and preventing them from falling during aggressive driving. The rear seats of the Hongqi E-HS3 support a 4:6 split-folding function, further enhancing the interior space. 3. In terms of the tailgate, the Hongqi E-HS3 is equipped with an electric tailgate, which can be opened or closed with a single button, greatly facilitating the owner's driving experience.
Was this review help?
7
5
Share
MacAndrew
08/11/25 1:31am
I've been driving the Hongqi E-HS3 for a while now, and its trunk capacity is approximately 470 liters, which is quite practical among urban SUVs. For daily outings, like carrying a large suitcase or several bags of groceries, the space is more than sufficient. The rear seats can be folded down in a 60/40 split, expanding the capacity to over 1,100 liters, making it suitable for moving, transporting large items, or long trips. I often go on weekend road trips, using it to carry tents, food, and equipment, and I find the design very thoughtful—the battery layout under the chassis doesn’t take up too much space. The wide opening makes loading and unloading effortless. This capacity is friendly for both solo commutes and family daily use. Just remember to pay attention to weight distribution when loading items to avoid overloading—it’s both safe and efficient.
Was this review help?
12
1
Share
Expand All
More Forum Discussions

How to Measure a Four-Wire Oxygen Sensor?

The measurement method for a four-wire oxygen sensor is: 1. Start the engine; 2. Increase the throttle to reach 1500 RPM, then test the signal voltage of the oxygen sensor—the voltage should be between 0.1 and 0.9 volts for normal operation; 3. Measure the resistance between the two wires, which should be around 10 ohms. The function of the oxygen sensor is to convert oxygen content into a voltage signal and transmit it to the engine computer, enabling the engine to achieve closed-loop control targeting excess air. The working principle of the oxygen sensor is: using a ceramic sensing element to measure the oxygen potential in the car's exhaust pipe, calculating the corresponding oxygen concentration based on the chemical equilibrium principle, thereby monitoring and controlling the combustion air-fuel ratio to ensure product quality and compliance with exhaust emission standards.
3
3
Share

What is the penalty for driving a C1 vehicle with a C2 license?

According to the "Road Traffic Safety Law": Driving a C1 vehicle with a C2 license is considered driving a vehicle type that does not match the license. It will be classified as driving without a license, resulting in a 12-point deduction from the original driver's license and a fine ranging from 20 to 200 yuan. In severe cases, the offender may also face detention. C license levels: C1: Small cars and C2, C3 (Passenger vehicles with fewer than 9 seats, such as sedans, are considered small cars) C2: Small automatic transmission vehicles C3: Low-speed trucks and C4 C4: Three-wheeled vehicles C5: Small automatic transmission passenger vehicles specially designed for disabled individuals (referring to five categories of people: those with right lower limb disabilities, lower limb disabilities, hearing impairments, missing right thumb, or finger end defects)
10
3
Share

Why does the Camry shake severely when in D gear and braking?

The reasons for severe shaking when the Camry is in D gear and braking are: 1. Tire deformation; 2. Tire dynamic imbalance; 3. Vehicle transmission system failure; 4. Worn or loose tie rod ball joints or detached rubber sleeves at the joints; 5. Twisted or deformed drive shaft; 6. Uneven brake discs; 7. Power steering belt too loose or too tight; 8. Aged engine mounts. The Camry is a mid-size car under GAC Toyota. Taking the 2019 Camry facelift Elite Edition as an example, its body dimensions are: 4885 mm in length, 1840 mm in width, 1455 mm in height, with a wheelbase of 2825 mm and a fuel tank capacity of 60 liters.
19
0
Share

Is a tire pressure of 2.6 normal?

A tire pressure of 2.6 is normal. Tire pressure refers to the air pressure inside the tire. The effects of low tire pressure are: 1. Increased friction coefficient with the road surface; 2. Causes the steering wheel to feel heavy and prone to deviation; 3. Increased movement of various parts of the tire, leading to abnormal heating due to excessive rolling. The effects of high tire pressure are: 1. Reduced friction and adhesion of the tire, affecting braking performance; 2. Steering wheel vibration and deviation, reducing driving comfort; 3. Accelerated wear of the tread pattern in the center of the tire, reducing tire lifespan; 4. Increased body vibration, indirectly affecting the lifespan of other components; 5. Excessive stretching deformation of the tire cords, reducing tire elasticity and increasing the load on the car while driving.
7
5
Share

How to Convert a Car Air Conditioner into a Home Air Conditioner?

The compressor of a car air conditioner is powered by the engine, not an electric motor, so it cannot be converted for home use. Below are the specific details: 1. Air Conditioner Compressor: Remove the compressor and fan from the air conditioner. The compressor can be used for home refrigerators. The air conditioner's circuit breaker can be used on the home power main switch or branch circuits. The fan can be used as a household fan, typically operating on AC 220V. 2. Points to Note: The power supply voltage of a car air conditioner is usually provided by the battery, with a standard voltage of 12 volts. Therefore, a 12V rectifier power supply must be configured. When setting up a 12V rectifier power supply, in addition to the 12V voltage, the current should be controlled to be above 2A.
20
1
Share

Why Are All the Dashboard Warning Lights On?

Here are the reasons why all the dashboard warning lights in a car may illuminate: 1. CAN bus failure in the ECU, or poor contact at the ECU's CAN interface. 2. Excessive dirt and carbon deposits, causing abnormal air circulation and inaccurate control of normal air intake, leading to unstable gas content and poor engine performance. 3. Low fuel pressure combined with poor constant pressure performance results in low system atomization levels, making the car difficult to start. Below are the types of dashboard indicator lights: First category: Routine indicator lights, such as turn signal lights, light indicators, seat belt indicators, cruise control indicators, and parking indicators, which serve to indicate the operational status of various vehicle functions. Second category: Warning indicator lights, such as the fuel level indicator and windshield washer fluid level indicator. Third category: Fault indicator lights, including the engine (exhaust system) fault light, oil system fault light, and battery and charging system fault light. These fault indicators rarely light up under normal circumstances.
2
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.