What is the tire size of the Audi A4L?

What is the wading depth of the Passat?

The wading depth of the Passat is 350mm. The wading depth of the Passat is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, off-road vehicles and SUVs have obvious advantages. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the Passat is below the water level while wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before wading, always turn off the auto start-stop function to prevent the engine from automatically restarting if the vehicle stalls in water, which could cause severe damage due to water ingress; Assess the underwater road conditions based on the passage of preceding vehicles and choose an appropriate entry point. Observe the path taken by other vehicles and follow it at a low speed, avoiding sudden acceleration or deceleration; On roads prone to water accumulation, use warning water level markers, trees, or the wheels and doors of other vehicles as reference points to estimate the water depth before deciding whether to proceed; Know your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed and choose an alternative route instead.

20

2

Share

What Causes Engine Shaking When Driving Through Water Without Stalling?

Driving through water without stalling proves that the car's engine did not take in water. The shaking is likely caused by water entering the exhaust pipe, affecting the exhaust. If you're unsure, you can check whether the air filter has taken in water. If the air filter is dry, it indicates no water intake, and you can continue using the vehicle with confidence. If the filter is wet, simply replace it. The correct method for driving through water: 1. Slow down or stop to observe: When encountering standing water while driving, if the water level exceeds two-thirds of the bumper or tire height, there is a certain risk in proceeding. Additionally, driving too fast through water can cause splashes to enter the cabin through the engine compartment or chassis. Assess the water level—if it's high, try to detour and avoid forcing your way through. 2. Do not stop or shift gears: When driving through water, maintain a steady speed in low gear with moderate to high throttle. Drive at a low speed and avoid stopping, shifting gears, or releasing the throttle. 3. Do not restart the engine: If the car stalls in water, take measures to tow it to a safe location with less water as soon as possible. Never restart the engine to avoid damaging it. 4. Remove brake pad moisture promptly: This prevents the vehicle from losing braking ability after driving through water, which could lead to danger or accidents.

14

3

Share

What is the difference between manual-automatic transmission and dual-clutch transmission?

There are three main differences between manual-automatic transmission and dual-clutch transmission: 1. In terms of concept, dual-clutch is both a manual transmission and an automatic transmission, while manual-automatic combines manual and automatic shifting: Dual-clutch transmission belongs to both manual and automatic transmissions, offering the flexibility of manual transmission and the comfort of automatic transmission while providing uninterrupted power output; Manual-automatic transmission integrates manual and automatic shifting functions into the same vehicle. 2. Different structural approaches: Dual-clutch has two sets of transmissions, while manual-automatic combines manual and automatic transmissions: Dual-clutch can be used separately, whereas manual-automatic operates together. 3. Different functions: Dual-clutch ensures smooth starting and seamless shifting, while manual-automatic reduces the impact of manual shifting on the vehicle's drivetrain: Dual-clutch transmission guarantees smooth vehicle starts and seamless gear changes, while manual-automatic transmission minimizes the impact of manual shifting on the drivetrain, thereby extending vehicle lifespan, improving ride comfort, allowing appropriate gear selection based on road conditions to keep the engine operating optimally, and reducing driver fatigue.

3

2

Share

What are the methods for reducing penalty points through legal study?

According to Article 5 of the Notice issued by the Ministry of Public Security on January 14, 2020, regarding the "Work Regulations on Reducing Points for Road Traffic Safety Violations through Accepting Traffic Safety Education (Trial)" (GongJiaoGuan [2020] No. 14): Motor vehicle drivers who apply to participate in traffic safety education to reduce points for traffic violations should participate in corresponding road traffic safety laws, regulations, and related knowledge study, examinations, or traffic safety public welfare activities based on their highest permitted vehicle type and meet relevant requirements to apply for point reduction. The point reduction through legal study is a measure for drivers holding a driver's license who have been penalized with points due to traffic violations. After participating in online traffic safety study and passing the examination, their penalty points can be reduced. This is a convenient traffic management measure uniformly deployed by the Traffic Management Bureau of the Ministry of Public Security. Specific precautions are as follows: Applicable groups: Motor vehicle drivers who hold a driver's license of the People's Republic of China, regardless of the vehicle type permitted by the license or whether they are commercial vehicle drivers, can participate in point reduction through legal study. They should participate in corresponding road traffic safety laws, regulations, and related knowledge study and examinations based on their highest permitted vehicle type. Specific rules: Motor vehicle drivers participating in online study of road traffic laws, regulations, and related content must study continuously for 5 minutes each time. The total study time must accumulate to 30 minutes within 3 days. They can then register for an examination within 7 days. Passing the examination will reduce 1 point. Drivers can also attend on-site study, with each session lasting no less than 1 hour. After completing the required study hours, they can apply for an examination. Passing the examination will reduce 2 points. Cases not accepted: The following situations will not be accepted: If the driver had more than two full-point records in the previous scoring cycle. If the driver was involved in hit-and-run accidents, drunk driving, or used forged or altered documents or license plates within a 3-point cycle. If the driver's license is in the probation period or has not been reviewed on time. If the driver has unprocessed traffic violation records under their name. If the driver has a motor vehicle under their name with an expired safety technical inspection or not deregistered as required. If the driver has already reduced the maximum of 6 points in the current cycle.

15

4

Share

How to Install the Welcome Light on Baojun 560?

The installation steps for the welcome light on Baojun 560 are as follows: first, locate the signal wire of the door control switch, then connect the positive wire through the constant power line, and the negative wire through the door switch. Below is an introduction to the Baojun 560: 1. Overview: The Baojun 560 is the first SUV model officially launched by SAIC-GM-Wuling, released on July 18, 2015. It initially offered three models: 1.8L manual comfort, 1.8L manual elite, and 1.8L manual luxury. 2. Powertrain: The Baojun 560 is equipped with a 1.8L naturally aspirated engine producing 101kW and 186Nm, paired with either a 5-speed manual transmission or an AMT transmission.

14

0

Share

What Are the Causes of Abnormal Noise During Emergency Braking?

When a vehicle brakes suddenly, the intense friction between the brake caliper and the brake disc can produce abnormal noise, possibly due to foreign objects on the brake disc causing the noise. Below is relevant information about the braking system: 1. Function: Ensures safe driving, increases driving speed, and improves productivity: To ensure safe driving, increase the average driving speed of the vehicle, and enhance transportation productivity. 2. Classification: (1) By function, it is divided into service brake system, parking brake system, and auxiliary brake system: ① The service brake system is operated by the driver using their foot, also known as the foot brake system. Its function is to decelerate a moving vehicle or bring it to a stop in the shortest distance possible. ② The parking brake system is operated by the driver using their hand, also known as the hand brake system. Its function is to keep a vehicle that has already stopped on various road surfaces stationary. ③ The auxiliary brake system is suitable for vehicles frequently driven in mountainous areas and for certain special purposes. It enhances driving safety and reduces the performance degradation of the service brake system and brake wear, stabilizing the vehicle speed during downhill driving. (2) By energy source, it is divided into manual brake system, power brake system, and servo brake system: ① The manual brake system uses the driver's physical strength as the sole energy source for braking. ② The power brake system relies entirely on the engine's power converted into potential energy in the form of air pressure or hydraulic pressure for braking. ③ The servo brake system combines both human power and engine power for braking.

9

4

Share

What is the tire size of the Audi A4L?

What is the wading depth of the Passat?

What Causes Engine Shaking When Driving Through Water Without Stalling?

What is the difference between manual-automatic transmission and dual-clutch transmission?

What are the methods for reducing penalty points through legal study?

How to Install the Welcome Light on Baojun 560?

What Are the Causes of Abnormal Noise During Emergency Braking?

Is the driving position on the right side in Hong Kong?

Can I continue taking the test after failing the second subject three times?

What are the reasons for frequent DPF regeneration?

What happens if a small amount of water enters the engine intake?