What is the reason why the Zotye T600 cannot sense the key and fails to start?

2 Answers
LaZachary
08/29/25 2:05am
Zotye T600 cannot sense the key and fails to start due to a dead key battery and radio interference. The basic components of the remote key consist of the following two points: 1. Transmitter: Composed of a transmission switch, transmission antenna, integrated circuit, etc., it contains an identification code storage circuit and an amplitude modulation circuit, with a button-type lithium battery installed on the opposite side of the circuit. The transmission frequency uses radio waves, and each press of the transmission switch button sends a signal once; 2. Receiver: After the transmitter sends the identification code using shortwave modulation, it is received by the car's shortwave antenna and enters the receiver's electronic control unit through a distributor for demodulation by the shortwave high-frequency amplifier processor, where it is compared with the demodulator's identification code.
Was this review help?
17
0
Share
VanBentley
09/10/25 6:53am
I also encountered a similar issue when driving my Zotye T600—the car key couldn't be detected, and there was no response when trying to start the engine. The main cause was insufficient battery power in the key fob, which was resolved by replacing it with a new battery. Additionally, faults in the key itself, such as internal circuit damage from being dropped or short-circuiting due to water exposure, can also weaken the signal. Problems with the vehicle's sensing system, like a loose or moisture-damaged antenna module—especially after rainy days—can lead to malfunctions. Signal interference from nearby wireless devices or placing the key near a phone can also block the signal. It's recommended to first try replacing the key battery; if that doesn't work, use the spare mechanical key to start the car or attempt a system reset: turn off the engine, remove the key, wait a few minutes, and try again. Always keep the key dry and avoid high-temperature environments. Don't worry too much—this is a common issue, and simple troubleshooting usually resolves it.
Was this review help?
11
0
Share
Expand All
More Forum Discussions

Can You Start the Engine in P Gear for an Automatic Transmission?

You can start the engine in P gear for an automatic transmission. Starting in P gear and passing through R gear without stopping will not cause damage to the transmission. An automatic transmission refers to a car's automatic gear-shifting mechanism, where the control system of the automatic transmission selects the appropriate gear based on the engine's speed and load during driving, eliminating the need for the driver to manually shift gears. The gears for an automatic transmission car are as follows: 1. P gear stands for Parking and Starting gear. When the gear is in this position, the wheels are mechanically locked to prevent rolling; 2. R gear stands for Reverse gear, used when reversing; 3. N gear stands for Neutral gear, used for temporary parking. To prevent the vehicle from rolling on a slope, it is important to step on the brake when using this gear; 4. D gear stands for Drive gear, used when the vehicle is moving forward; 5. L gear stands for Low gear, used when going downhill or descending a long slope. Engaging this gear allows the use of engine power for braking, avoiding the danger of overheating brake pads due to prolonged braking; 6. S gear stands for Sport mode, allowing free gear switching when engaged.
13
0
Share

How to Deal with Wax Marks Left by Polishing?

Spray a small amount of adhesive remover onto a clean cloth. Use the cloth with adhesive remover to wipe the areas with wax residue, applying slight pressure during the process. Rinse thoroughly with clean water. After the first rinse, use deionized water for the second wash. After the first wash, spin dry with a spin dryer, then use deionized water for the second rinse.
8
5
Share

What to do if the headlights of Sagitar get water inside and fog up?

For relatively minor cases of moisture or water ingress inside the headlights, the fogging will usually dissipate as the heat from the headlights causes the moisture to evaporate and exit through the vent tube after the headlights have been on for a while. In cases of severe moisture or water ingress, the headlight assembly should be removed, the lens opened, and allowed to dry. After drying, inspect the condition of the headlight surface.
4
2
Share

How to Set the Seat Memory Function in Passat Lingyu?

Turn on the ignition switch; Press down the red "Memory-Off" button; Adjust the driver's seat and exterior mirrors to the most comfortable position, then press and hold one of the memory buttons on the left side of the driver's seat; Turn off the ignition switch and remove the ignition key, press and hold the unlock button on the key until you hear a "dong" confirmation sound indicating the setup is complete.
17
4
Share

How to Disable the Anti-Theft System When the GL8 Won't Start?

Use the reset button on the odometer to set the first digit to any number between 0 and 9. Press the odometer reset button to set the second digit of the password, then press the odometer reset button again to set the third digit of the password. Pull out the clock adjustment button on the instrument cluster while pressing the daily odometer reset button.
18
5
Share

How to Remove Car Paint from Plastic?

To remove car spray paint, you can use some solutions that have the effect of diluting the paint. If the car spray paint still cannot be removed, gasoline will be needed. First, apply gasoline to the affected area, and then wash it with soapy water.
17
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.