What is the reason why the central lock of Hyundai Tucson cannot lock the door?

1 Answers
DiRemington
07/29/25 5:28pm
Modern Tucson central lock may not be able to lock the door because the remote control battery is dead, or there is magnetic field interference. It is necessary to eliminate the faults one by one to determine the specific reason. The following is a related introduction about Hyundai Tucson cars: 1. Body size: The body size is 4670/1865/1690mm, and the wheelbase is 2755mm, which is the longest in the same class, 40mm longer than the overseas version; Compared with the previous generation model, the wheelbase is increased by 85mm, the length is increased by 125mm, the rear legroom is increased by 80mm, reaching 1050mm, which is at the leading level in the same class. 2. Air conditioning: Hidden windless air conditioning, with multiple air outlets, optional multi-port air supply mode, evenly and softly sending out the wind, eliminating the discomfort caused by strong wind.
Was this review help?
7
0
Share
More Forum Discussions

How to Remove the Rear Tire of a Scooter?

Remove the bracket of the right rear shock absorber. Some right shock absorbers may obstruct the removal of the rear wheel, so it's necessary to detach the right rear shock absorber. Step on the wrench After loosening the nut, gently tap and vibrate the rear axle with a hammer to loosen the splines between the rear wheel and the axle, then the rear wheel can be removed.
11
1
Share

Installation of Guide Rails and Lead Screws?

Remove burrs and debris, place the guide rail against the reference surface, and tighten the bolts. Ensure each bolt leaves a gap in the guide rail mounting hole for later adjustments. Use a torque wrench to gently secure the bolts, pressing the clamping blocks against the rails. After both guide rails are installed as described, use a dial indicator to check the parallelism between them. Once installation is complete, move the worktable to confirm if the resistance is normal.
19
2
Share

How to Ride a Regular Motorcycle?

Hold the clutch with your left hand, pull it all the way in until there is no gap between the clutch and the handlebar, then step on the motorcycle's gear shift lever. Slowly release the clutch while gradually twisting the throttle with your right hand, and the motorcycle will start moving.
6
4
Share

How to Quench a Knife Made from Automotive Leaf Spring Steel?

Remember that the steel should only be heated to a red color, not white, somewhere between orange and yellow. Dip the cutting edge into water for about 2-3 seconds, making sure the back of the blade does not get wet. Heat the steel until it turns red and immediately immerse it in used motor oil. Wait until the oil stops boiling and bubbling, then bury the knife in sand, allowing the sand and blade to cool together.
6
5
Share

How to Maintain a Motorcycle at 10,000 Kilometers?

Body bolts, including the front and rear axle nuts, must be tightened in a timely manner. Tire pressure should be checked every three months. The rear brake of the new Neptune still uses a relatively conventional drum brake. As the mileage increases, the brake clearance should be adjusted appropriately.
3
2
Share

How to Remove a Motorcycle Lock?

The protective cover of the ignition lock core is magnetic, and you need to use the hexagonal magnetic protrusion on the other end of the special key to unlock it. Lift the main stand and sit on the seat. If the handlebar is locked to the left, gently pull the right handle with your right hand and kick the left handle hard with your left foot.
15
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.