What is the online declaration process for the new version of vehicle and vessel tax?

1 Answers
SanZoey
07/30/25 1:58am
First, log in to the electronic tax bureau, enter the "To-Do" section, select "Other Types of Declaration (Selected by Occurrence)," and click to enter the declaration. Upon entering the declaration, initialize the data as required by the declaration page. After summarizing the data, click save. Read the data, fill in Table 1, and click save. Click "Declare" to complete the declaration.
Was this review help?
18
1
Share
More Forum Discussions

Difference Between Single Solid Line and Double Solid Line

Double solid lines and single solid lines differ in the number of lanes, width, and the type of solid/dashed lines. Specific details are as follows: Difference in the number of lanes: A single solid line indicates there is only one lane in the same direction; double solid lines indicate there are two or more lanes in the same direction. Difference in width: Roads with single solid lines are generally not very wide; roads with double yellow solid lines are usually wider. Difference in solid/dashed lines: Some sections of a single yellow line may have dashed lines, indicating that left turns or U-turns are allowed in those areas. However, double yellow lines are different—some sections may have a dashed line on one side and a solid line on the other. Introduction to road markings: Yellow dashed lines can serve as dividing lines or center lines. When used as dividing lines, lane changes are permitted. Lane dividers are white dashed lines, used to separate traffic moving in the same direction and are marked on the dividing line of lanes traveling in the same direction.
19
4
Share

What does it mean when the yellow light in a car comes on?

The illumination of a yellow light generally indicates a malfunction in the vehicle, and it is necessary to inspect and repair the car based on the type of warning light. Engine Warning Light: There are several reasons why the engine warning light may come on, including engine overheating, engine misfire, engine knocking, severe engine carbon buildup, and poor fuel quality. Oil Warning Light: When the oil warning light comes on, it usually indicates that the car is low on oil. Tire Pressure Warning Light: When the tire pressure warning light comes on, it indicates an imbalance in tire pressure.
3
1
Share

What to Do If the Fuel Tank Cap Won't Open?

If the car fuel tank cap won't open, you can use tools or other methods. Specific related introductions are as follows: Fuel tank cap stuck or rusted: You can insert a small wooden piece into the gap of the fuel tank cap to pry it open. Remember to pull the fuel tank cap's lock switch while prying. Pull cable too long: If the pull cable is too long or has stretched after prolonged use, it may not fully engage when the handle is pulled, causing the fuel tank cap to not open. Another reason could be issues with the handle or the lock mechanism of the fuel tank cap. Fuel tank cap pull cable detached: Open the trunk, and on the side of the fuel tank cap, there is usually an interior panel that can be opened (secured by a few plastic clips). Once opened, you will see the long pull cable for the fuel tank cap—just pull it. If it doesn't work, try moving the movable parts of the lock mechanism while pulling the cable. Some cars have a dedicated lock switch on the lock mechanism. Fuel tank cap spring lost elasticity: You can install a small spring (not too soft or long) on the protruding rubber pad of the fuel tank to increase elasticity between the fuel tank cap and the locking device.
8
5
Share

What is the voltage when five batteries are fully charged?

If one battery is 16V, the total voltage would be 80V; if one battery is 12V, the total voltage would be 60V. The initial charging time should be controlled within 5-6 hours, just enough to fully charge the batteries. First-time charging for electric vehicles: Before the first charge, the electric vehicle's battery should be used up but not completely drained. The first charge should be done during the day. During the initial charge, the battery should be fully charged, but full charge does not mean overcharging. Charging during the day makes it easier to control the charging time, preventing the battery from experiencing overcharging or excessive discharge for the first time, which helps ensure the initial chemical reactions inside the battery proceed normally. Precautions: When charging, the plug should first be inserted into the electric vehicle before connecting to the power source. This is a good method to ensure stable battery voltage.
11
4
Share

What are the symptoms of a faulty ignition coil in a Jetta?

Here are the symptoms of a faulty ignition coil in a Jetta: 1. When idling, the car body shakes noticeably. Observe the exhaust pipe outlet, and you can see that the exhaust gas flow is intermittent, accompanied by severe shaking of the exhaust pipe and a clear "popping" sound; 2. While driving, when the RPM is below 2500, the car body shakes noticeably with poor acceleration. The shaking disappears once the RPM exceeds 2500; 3. Open the engine hood and observe the running engine. You will notice significant shaking of the engine, which is clearly abnormal compared to the normal operating state of the engine, with a large shaking amplitude.
2
1
Share

What is a Test Drive Vehicle?

A test drive vehicle is generally provided by manufacturers to media or 4S dealerships for group test drives. These vehicles undergo treatment before sale, making it difficult to distinguish them from new cars by appearance. Typically, because various performance aspects of the vehicle are tested during the drive, drivers may engage in aggressive acceleration, sudden braking, and other driving behaviors unsuitable for the vehicle's break-in period. Therefore, test drive vehicles are sold at a discount. Purchasing a test drive vehicle should be done cautiously based on individual circumstances. Techniques for Identifying a Test Drive Vehicle: Check the Tires: Since test drive vehicles have been driven, inspecting the tires for wear is essential. If the tires show signs of wear or lack tread hairs, it is highly likely that the vehicle is a test drive car. New tires have evenly distributed tread hairs and no other signs of wear. If tire wear is detected during inspection, it is advisable not to purchase such a vehicle. Check the Brake Discs: The brake discs of a car are also prone to wear during driving. Inspect the brake discs; if they show signs of wear and are not smooth, it indicates the vehicle has been driven, and caution should be exercised when purchasing. Check the Exhaust Pipe: Assess the vehicle's driving condition by examining the exhaust emissions. In a cold state, check the exhaust pipe's emissions. If there is black soot, it suggests the car has been driven for some time, and it is not recommended for purchase. This method can also be used during parking to avoid test drive vehicles, which may increase maintenance costs in the future. Pay Attention to Handles and Keys: Due to frequent door openings and closings, some traces are often left behind. Additionally, vehicles with mechanical keys may show scratches around the lock from frequent use. Check the Manufacturing Date: The vehicle's manufacturing date should match the certificate of conformity, which is usually difficult to alter. If the manufacturing date exceeds 15 days and you are making a prepayment, be cautious. Opt for recently manufactured vehicles, preferably those produced within one or two months. If the dealer has sufficient inventory, you can also choose a model not recommended by the dealer and pick one from the garage yourself, comparing easily scratched areas to select a new car. Examine the Exterior: Focus on the following aspects: Observe the body color from different angles at an appropriate distance under sunlight to ensure consistency. Open the engine hood and trunk, paying special attention to the gaps inside the fenders and the corners of the trunk for signs of repainting. Finally, ask the dealer to lift the car on a hoist to inspect the chassis: Focus on whether the color of the chassis (frame) matches that of various pipelines. For example, if the bottom of a pipeline has an unusual color or obvious mud not present elsewhere, it may indicate that the pipeline has been repositioned (suggesting possible repairs). Similarly, if certain corners that are hard to reach with a water gun show mud or dust not found in exposed areas, it may be a sign of cleaning traces.
10
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.