What is the method for replacing the battery in the Magotan remote key?
3 Answers
Method for replacing the battery in the Magotan remote key: 1. There is a circular button on the side of the key. Press this button to pull out the car's mechanical key; 2. Locate the gap in the middle of the top end of the key, insert a flat-head screwdriver and pry the key up and down until a gap is created; 3. After removing the old battery, place the new battery with the positive side facing up into the battery slot of the key; 4. Cover the key's circuit board onto the key until the upper and lower parts of the key are completely aligned, then insert the mechanical key into the key gap. The Magotan's body dimensions are 4866mm in length, 1832mm in width, and 1464mm in height, with a wheelbase of 2812mm, a fuel tank capacity of 70 liters, and a trunk capacity of 565 liters.
Last time I helped a friend replace the battery in their Magotan key fob, the whole process was actually quite simple. First, locate the small switch on the side of the key fob and press it with a fingernail or coin to release the mechanical key. Then gently pry open the key fob shell along the seam, being careful not to use too much force to avoid damaging the clips. Once opened, you'll see the battery compartment - note that the battery type is CR2032, which is widely available. When removing the old battery, remember its orientation (positive/negative sides), and insert the new battery in the same direction. Finally, snap the cover back on and test all the buttons to ensure they're working properly. The entire process takes just a few minutes - doing it yourself saves time, effort, and money.
Replacing the battery in your Magotan key fob is actually something you can easily do yourself. After removing the mechanical key, locate the groove along the seam of the key fob housing and gently pry it open with a thin tool to separate the shell. Inside, you'll find a round coin cell battery, model CR2032, which is readily available at supermarkets or convenience stores. When installing, make sure to check the battery orientation - the side marked with a '+' should face upwards. After securely closing the housing, test both the locking and unlocking functions to ensure the remote's responsiveness is normal. Remember to have a new battery ready beforehand - the entire process takes less than five minutes, much more convenient than queuing at the 4S shop.
