What is the fuel consumption of the Kia K4?

Where is the air conditioning filter element of the Haifuxing located?

The air conditioning filter element of the Haifuxing is located under the glove box on the passenger side. Here are some relevant details: 1. If the filter element is dirty, you can clean it by blowing compressed air from the reverse side. Operation method: Hold the air gun 5 cm away from the filter element and blow at a pressure of 500 kPa for about 2 minutes. The air filter element is very prone to dust accumulation. Use compressed air to remove the dust, but never wash it with water, as this can easily cause damage. 2. The Haifuxing is a compact car launched by FAW Haima, with body dimensions of 4464mm in length, 1695mm in width, and 1425mm in height, and a wheelbase of 2610mm. The Haifuxing is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 111ps and a maximum torque of 147nm, paired with a 5-speed manual transmission.

12

4

Share

What are the reasons for a car not starting with no power at all inside?

There are several reasons why a car may not start with no power at all inside: 1. Dead battery: This could be due to a drained battery from leaving headlights on for a long time or the battery reaching the end of its lifespan. It is generally recommended to replace the battery every 2 years. Additionally, installing xenon headlights, high-power audio systems, or DVD players can also cause vehicle circuit failures. 2. Incorrect gear position: For automatic transmission cars, the gear must be in P or N position when starting. If it is in R or D position, the car will not start. Some manual transmission cars may also not start if the clutch is not depressed. 3. Lack of antifreeze: Using water or low-quality antifreeze in the car can cause the engine to freeze and crack in extremely cold winter conditions, leading to the water pump failing to operate, the car not starting, and damage to other engine components.

4

Share

How to Decelerate an Automatic Transmission Car?

To decelerate an automatic transmission car, release the accelerator pedal early and apply the brake. Below are detailed introductions to the gear positions of an automatic transmission vehicle: 1. The R gear is the reverse gear. When this gear is engaged, it connects the hydraulic system's reverse gear oil circuit, causing the drive wheels to rotate in reverse for backward movement. Never forcibly shift to the "R" gear when the vehicle hasn't come to a complete stop, as this may damage the transmission. 2. The N gear is the neutral gear. When neutral is engaged, the planetary gear system idles without power output. 3. The D gear is the drive gear. When the gearshift lever is in this position, the hydraulic control device automatically connects the corresponding forward gear oil circuit based on throttle opening signals and vehicle speed signals. It can automatically shift up or down according to driving speed changes, achieving automatic transmission functionality. 4. The P gear is the parking gear. It uses a mechanical device to lock the rotating parts of the vehicle's tires, preventing the car from moving.

11

2

Share

What are the functions of the multi-function steering wheel buttons in Volkswagen?

The functions of the multi-function steering wheel buttons in Volkswagen are: 1. Resume button: Press RES to restore the previously set speed after temporarily canceling cruise control; 2. Set button: Press SET to set the current speed as the cruise speed after temporarily canceling cruise control; 3. Deceleration button: If adaptive cruise control is activated, use it to reduce speed; 4. Acceleration button: If adaptive cruise control is activated, use it to increase speed; 5. Cruise control on/off button: Press to turn on the cruise control function; 6. Cancel button: Press to cancel the cruise control function; 7. Volume adjustment buttons: Press to increase or decrease volume, with the left button decreasing volume and the right button increasing volume; 8. Bluetooth phone button: Press to answer incoming calls; 9. Voice control button: Press to activate voice commands; 10. Option toggle button: Used to switch between up and down options on the multi-function display; 11. Menu toggle button: Used to switch between left and right options on the multi-function display, press OK to confirm; 12. Track change button: Press to skip to the next or previous track.

7

3

Share

How to Use the Focus Wiper?

The usage of the Focus wiper is as follows: 1. Push the entire wiper control lever down one position for a single wipe. 2. Push it up one position for intermittent wiping mode. 3. Push it up two positions for low-speed wiping mode. 4. Push it up three positions for high-speed wiping mode. 5. Push it back one position for front wiper washing. 6. Push it forward one position for rear wiper washing. Here is some extended information about the Focus: 1. The Focus is a compact sedan with 4 doors and 5 seats. 2. The body dimensions are 4647mm in length, 1810mm in width, and 1468mm in height, with a wheelbase of 2705mm. 3. The Focus is equipped with a 1.5L naturally aspirated engine and a 6-speed manual transmission, delivering a maximum power of 90 kW and a maximum torque of 153 Nm.

19

3

Share

What causes the black screen on the Buick Verano's center console display?

The reasons for the black screen on the Buick Verano's center console display are as follows: The Verano's center console black screen is likely a power supply issue. When the screen has no power, it's generally due to two reasons: one is a loose power cable, which can occur over time; the other possibility is a blown fuse causing abnormal power supply, which can be resolved by replacing the fuse. It is recommended to visit a 4S shop for a comprehensive inspection. Additional information: 1. The car's center console is where comfort and entertainment devices such as air conditioning and audio systems are controlled. The car's center console includes the central control door lock system, allowing the driver to control all door switches and the window lift system. 2. The central control door lock system mainly has three functions: central control, speed control, and individual control. The driver can control all door locks, and when the vehicle reaches a certain speed, the doors automatically lock. Each door also has an independent switch for individual control.

17

0

Share

What is the fuel consumption of the Kia K4?

Where is the air conditioning filter element of the Haifuxing located?

What are the reasons for a car not starting with no power at all inside?

How to Decelerate an Automatic Transmission Car?

What are the functions of the multi-function steering wheel buttons in Volkswagen?

How to Use the Focus Wiper?

What causes the black screen on the Buick Verano's center console display?

Where can I find the vehicle production date?

What causes the clicking sound in the rear wheels when braking in a Volkswagen?

Can Modified Wheel Size Pass the Annual Inspection?

Is the Venucia D60 compliant with China VI emission standards?