···
Log in / Register

What is the fuel consumption of the BMW X1 2.0T?

3 Answers
Coleman
09/03/25 7:44am
BMW X1 official combined fuel consumption is 6.2L/100km. Lightly press the accelerator to reduce fuel consumption: When the car starts at low speed, it is the peak fuel consumption area, so gently press the accelerator when starting to prevent excessive engine speed and effectively reduce fuel consumption. Avoid high engine speed to reduce fuel consumption: Try to avoid unnecessary high engine speed as fluctuating engine speed will also significantly consume fuel. Regular maintenance to reduce fuel consumption: Change engine oil and remove carbon deposits. Avoid emergency braking to reduce fuel consumption: Anticipating road conditions in advance not only improves driving safety but also saves fuel, such as slowing down gradually before traffic lights and utilizing inertia to glide.
Was this review help?
2
5
Share
StLuke
09/16/25 2:20am
I've been driving the BMW X1 2.0T for over two years now. The average fuel consumption is around 10L/100km in the city, dropping to just over 7L on highway trips. This is related to my daily commute - when I go out on weekends with family and luggage, the increased load pushes fuel consumption up a bit. City traffic jams are the most fuel-intensive, with frequent red lights and stop-start driving easily pushing consumption over 11L/100km. Highway cruising is much better, with the most fuel-efficient speed being 80-100km/h. Personally, I think the turbocharged engine provides ample power but isn't particularly fuel-efficient. I recommend maintaining light throttle inputs and avoiding sudden acceleration to save some fuel. Regular maintenance like oil changes and tire pressure checks also helps control fuel consumption. After driving it for a while, I feel it's been quite worthwhile.
Was this review help?
4
2
Share
Expand All
KadenFitz
10/30/25 2:53am
The BMW X1's 2.0-liter turbocharged engine has an officially rated combined fuel consumption of 8.5 to 9.5 liters per 100 kilometers. In actual urban driving conditions, it can reach around 11 liters, while highway cruising drops it to approximately 7.5 liters. This is mainly due to the engine design and the vehicle's weight of nearly 1.6 tons, with additional fuel consumption when using air conditioning or carrying a full load. Maintaining smooth acceleration and steady speeds while driving is crucial for fuel efficiency, as turbo lag can cause a sudden increase in fuel consumption at high RPMs. Regular maintenance, such as cleaning the throttle body or replacing the air filter, can also optimize fuel economy. Overall, the power output is good, and the fuel consumption is average for its class—not outstanding but sufficient. Driving with fewer overtakes can further improve fuel efficiency.
Was this review help?
3
5
Share
Expand All
More Forum Discussions

What is the actual fuel consumption of the Lavida 1.6 manual transmission?

The actual fuel consumption of the Lavida 1.6 manual transmission is 6.2L. Actual fuel consumption varies by vehicle and is related to individual driving habits. The calculation method for fuel consumption and ways to reduce it are as follows: Fuel consumption calculation method: Correct fuel consumption formula: Fuel consumed ÷ Distance traveled × 100 = Fuel consumption per 100 kilometers. The data on fuel consumed is relatively difficult to obtain. Generally, a full tank is used as the initial data. After driving a certain distance, the tank is filled again, and the fuel amount provided by the gas station is used as the standard. Methods to reduce fuel consumption: When starting the vehicle, use a low gear, gently press the accelerator, and gradually increase speed; while driving, press the accelerator lightly to avoid sudden increases in engine RPM; maintain tire pressure at the level recommended by the manufacturer; regularly organize the trunk to reduce weight.
20
4
Share

What are Automotive Body Panels?

Automotive body panels (referred to as body panels) are the components that form the surface and interior of the car body or cab, covering the engine and chassis. These panels serve both as aesthetic exterior decorative parts and as load-bearing thin-shell structural components. Any minor defects on the surface of body panels can cause diffuse reflection of light after painting, compromising the visual appeal. Therefore, surface imperfections such as ripples, wrinkles, edge marks, or other defects that impair aesthetics are strictly prohibited. In Europe, America, Japan, and other developed countries, automotive body panels with Class-A surface precision include: hood, roof panel, left/right side panels, front/rear doors, front/rear/left/right fenders, trunk lid, front engine support panel, front engine apron, front upper panel, rear panel, rear upper panel, front apron, front frame, front fender, wheel fender, rear fender, rear panel, luggage compartment lid, rear upper panel, roof panel, front side panel, front panel, front upper panel, front fender, and engine cover.
6
2
Share

Why does the reversing radar keep beeping when shifting to R gear?

Reversing radar keeps beeping when shifting to R gear because it is too close to the obstacle behind, at which time the buzzer will start to sound, reminding the driver to pay attention to the distance from the rear obstacle. Other reasons that cause the vehicle's radar buzzer to keep beeping: Signal blockage: Something is stuck on the reversing radar probe, causing signal blockage. Solution: Check if there is any obstruction on the radar holes at the rear of the vehicle. Water leakage: The rear wiper water pipe leaks or water seeps into the reversing radar system. Solution: Seal the leakage point (or replace the pipe) and drain the accumulated water from the radar system. Signal error: The radar ultrasonic signal is faulty, causing false alarms. Solution: Restart the engine, drive the vehicle to an open area, and try reversing again to observe the effect. Radar malfunction: Short circuit in the reversing radar wiring or failure of the radar module. Solution: Go to a 4S shop or repair shop for inspection, check the wiring or replace the radar module.
7
5
Share

What are the reasons for the insufficient heating in the Buick Excelle?

Here are the reasons for the insufficient heating in the Buick Excelle: Engine coolant temperature not reaching operating temperature: Check whether the engine coolant temperature is normal. If it remains at a low temperature and does not reach the operating temperature, the heating will definitely be insufficient. In this case, focus on checking whether the thermostat is stuck in the large circulation state or whether the coolant temperature sensor signal is accurate. Repair or replace the faulty component as needed. Heater core blockage: Pay special attention to whether there is a significant temperature difference between the inlet and outlet hoses in front of the heater core. If such a difference exists, it indicates a blockage in the heater core, which requires disassembly, cleaning, or replacement. Coolant not meeting requirements: Check whether the flow rate and temperature of the coolant entering the heater core meet the requirements. The temperature can be measured using an infrared thermometer to detect temperature differences in the pipes, while the flow rate can be assessed through diagnostic data and fault storage from the diagnostic tool. Common issues include water pump slippage or damage, and malfunctioning heating flow valves or coolant circulation valves.
2
5
Share

What is the fuel tank capacity of the Hyundai ix25?

The fuel tank capacity of the Beijing Hyundai ix25-2020 1.5L manual GS Fashion model is 50L. It is equipped with a 1.5L naturally aspirated engine and a 6-speed manual transmission (MT). The drivetrain is front-engine, front-wheel drive. The front suspension is a MacPherson strut independent suspension, and the rear suspension is a torsion beam non-independent suspension. In the same class, the Nissan Kicks-2022 1.5L XL CVT Fashion model has a fuel tank capacity of 41L, while the Kia KX3 Seltos-2021 1.5L CVT Fashion model has a fuel tank capacity of 50L. During actual refueling, the amount of fuel may exceed the calibrated capacity. This is because the fuel tank capacity marked by the manufacturer is measured from the bottom of the tank to the safe limit. There is additional space from the safe limit to the tank opening, which is designed to allow for fuel expansion due to temperature increases without causing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked capacity. To check the remaining fuel level, drivers can observe the fuel gauge on the right side of the instrument panel, which is marked with E and F. When the needle is close to E, it indicates low fuel, and when it is near F, it means the fuel level is sufficient.
3
0
Share

What does 97w on a tire mean?

In the tire marking 97w, the number 97 represents the load index of the car tire, indicating that the tire can bear a weight of 730kg. If this specified value is exceeded, the car tire may experience a blowout. The letter w stands for the maximum speed rating of the tire, with w indicating a maximum speed of 270km/h. Here is some relevant information about tires: Tire replacement cycle: Under normal driving conditions, such as 25,000-30,000 kilometers per year, choosing durable tires can allow replacement at around 70,000 kilometers. If opting for comfort-type tires, it is recommended to replace them at 50,000-60,000 kilometers. If the car is driven less than 10,000 kilometers annually, it is advisable to replace the tires every three to four years. Precautions for car tire usage: Every car tire has several raised wear indicators in the tread grooves. When the tire wears down to the level of these indicators, it is time to replace the tire. During inspection of the tire wear limit, it is often observed that the front tires wear out more severely than the rear tires. When the front tires need replacement, the rear tires may still seem usable for several more years. Tire maintenance methods: Ensure the tire pressure is within the correct range; regularly inspect the tire appearance; keep the tire surface clean; periodically check tire alignment and balance; control driving speed; and ensure the tires are used within their service life.
4
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.